Study on characteristics in high-speed milling SiCp/Al composites with small particles and high volume fraction by adopting PCD cutters with different grain sizes

Silicon carbide particle–reinforced aluminum matrix (SiCp/Al) composites were milled at a high speed by adopting polycrystalline diamond (PCD) tools, which the diamond grain sizes were 5, 10, 25, and 32 μm. The machined materials were SiCp/Al composites which the volume fraction was 45% and grain size of SiC particles was 5 μm. The tool wear resistance and wear morphology of polycrystalline diamond cutters were investigated. And it centered on the effects of diamond grain sizes on the cutting forces as well as the machined surface roughness. The obtained results indicated the difference of corresponding tool wear resistance between larger SiC particles and smaller SiC particles during high-speed milling SiCp/Al composites with higher volume fraction. When the grain size and volume fraction of SiC granules are 5 μm and 45%, the tool wear resistances of four diamond grain sizes were all far higher than those of tools in machining composites with higher volume fraction (56%) and larger 60-μm SiC particles. And the PCD tools of larger diamond grain size acted on better wear resistance. Both the corresponding cutting forces and surface roughness were also smaller. As cutting distance increased, the variation law of cutting forces had a good correspondence with the tool wear of PCD cutters of different diamond grain sizes. The machined surface roughness had a decreasing trend in general, but the fluctuation range was tiny. The main wear morphology was flank wear and slight wear groove marks. And there was no chipping of cutting edge and coarse wear groove marks. A large amount of the machined materials was adhered on flake face in the cutting process, but built-up edge was not formed.