Effects of SiO2 and Al2O3 on the lattice parameter and CO gas reduction of CaO-containing dense wustite

被引:13
|
作者
Inami, T [1 ]
Suzuki, K [1 ]
机构
[1] Ibaraki Univ, Fac Engn, Hitachi, Ibaraki 3168511, Japan
关键词
wustite; CO gas reduction; chemical reaction rate constant; inter-diffusion constant; mixed-control model; lattice parameter; iron making;
D O I
10.2355/isijinternational.43.314
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
The effects of SiO2 and Al2O3 on the lattice parameter and the initial reduction rate of CaO-containing wustite were studied at 1 273 K. Wustite plates containing 0.5-2 mass% CaO, 0.2-2 mass% SiO2 and 1 mass% Al2O3 were prepared at the mass fractions of CaO/SiO2=0.5-5. The lattice parameter of CaO-SiO2- containing wustite decreased with decreasing CaO/SiO2 ratio at a constant CaO content. This corresponded to a decrease of the dissolved content of CaO in the wustite due to a formation of CaO-FeO-SiO2 Compounds. Similarly, the dissolved content of CaO decreased in CaO-SiO2-Al2O3-containing wustite. The process of CO gas reduction within the wustite phase field was traced with the lattice parameter measurement of the partially reduced samples and was analyzed with a-mixed-control model of chemical reaction at the surface and the solid state diffusion in the wustite. The chemical reaction rate constant, k', decreased with increasing the amount of SiO2 addition at a constant CaO content. The dependence of k' on SiO2 (and Al2O3) addition was in good accordance with the change in the dissolved content of CaO in the wustite owing to the formation of the compounds containing CaO. The inter-diffusion coefficient, (D) over tilde, tended to decrease slightly with increasing the amount of compound.
引用
收藏
页码:314 / 320
页数:7
相关论文
共 50 条
  • [21] EFFECT OF THE ADDITION OF SIO2 AND SIO2-CAO ON THE REDUCTION OF DENSE WUSTITE AT HIGH-TEMPERATURES
    SHIGEMATSU, N
    IWAI, H
    TETSU TO HAGANE-JOURNAL OF THE IRON AND STEEL INSTITUTE OF JAPAN, 1993, 79 (08): : 920 - 926
  • [22] Formation and Evolution Mechanism of the Inclusions of Al2O3•SiO2•CaO and Al2O3•SiO2•CaO•MgO in Seamless Steel Tube Steel
    Yang, Wenkui
    Yang, Jian
    Zhang, Runhao
    Sun, Han
    Song, Jingling
    Zhao, Yinghui
    Zhou, Xuan
    STEEL RESEARCH INTERNATIONAL, 2023, 94 (08)
  • [23] Viscosity of CaO?MgO?Al2O3?SiO2 melts containing SiC particles
    Han, Pei-Wei
    Zheng, Wei-Wei
    Zhang, Guo-Hua
    Chu, Shao-Jun
    IRONMAKING & STEELMAKING, 2019, 46 (08) : 705 - 711
  • [24] Specific heats of CaO, Al2O3, CaOAl2O3, 3CaO Al2O3, 2CaO SiO2, 3CaO SiO2, 2CaO Al2O3SiO2 of 20 degrees to 1500 degrees C
    Von Gronow, HE
    Schwiete, HE
    ZEITSCHRIFT FUR ANORGANISCHE UND ALLGEMEINE CHEMIE, 1933, 216 (02): : 185 - 195
  • [25] Influence of Al2O3/SiO2 ratio on the microstructure and properties of low temperature co-fired CaO–Al2O3–SiO2 based ceramics
    Zhenjun Qing
    Bo Li
    Hao Li
    Yingxiang Li
    Shuren Zhang
    Journal of Materials Science: Materials in Electronics, 2014, 25 : 4206 - 4211
  • [26] NO reduction with CO on Cu–Cr and Co–Cr oxide catalysts supported on Al2O3 and Al2O3 + SiO2
    I. Spassova
    N. Velichkova
    M. Khristova
    V. Georgescu
    Reaction Kinetics, Mechanisms and Catalysis, 2010, 101 : 321 - 330
  • [27] Phase equilibrium data and liquidus for the system “MnO”-CaO-(Al2O3 + SiO2) at Al2O3/SiO2 = 0.41
    Ghasem Roghani
    Evgueni Jak
    Peter Hayes
    Metallurgical and Materials Transactions B, 2002, 33 : 839 - 849
  • [28] Thermal conductivity of CaO-SiO2-Al2O3 glassy slags:: Its dependence on molar ratios of Al2O3/CaO and SiO2/Al2O3
    Susa, M.
    Watanabe, M.
    Ozawa, S.
    Endo, R.
    IRONMAKING & STEELMAKING, 2007, 34 (02) : 124 - 130
  • [29] Effect of Al2O3/SiO2 and CaO/Al2O3 ratios on wettability and structure of CaO-SiO2-Al2O3-based mold flux system
    Wang, Wan-lin
    Gao, Er-zhuo
    Zhou, Le-jun
    Zhang, Lei
    Li, Huan
    JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL, 2019, 26 (04) : 355 - 364
  • [30] Wetting characteristics of CaO−SiO2−Al2O3 ternary slag on refractory oxides, Al2O3, SiO2 and TiO2
    Sung-Mo Seo
    Dong-Sik Kim
    Young Hyun Paik
    Metals and Materials International, 2001, 7 : 479 - 483