Prosthetic venous valve patient selection by validated physics-based computational models

被引:2
|
作者
Chen, Henry Y. [1 ,2 ,4 ]
Berwick, Zachary C. [2 ,4 ]
Kemp, Arika [1 ]
Krieger, Joshua [5 ]
Chambers, Sean [3 ]
Lurie, Fedor [6 ]
Kassab, Ghassan S. [1 ,3 ,4 ]
机构
[1] IUPUI, Dept Biomed Engn, 635 Barnhill Dr,MS 2065, Indianapolis, IN 46202 USA
[2] Calif Med Innovat Inst Inc, San Diego, CA USA
[3] Indiana Univ Sch Med, Dept Surg, Indianapolis, IN 46202 USA
[4] Indiana Univ Sch Med, Dept Cellular & Integrat Physiol, Indianapolis, IN 46202 USA
[5] Cook Med, Res Engn, Bloomington, IN USA
[6] Jobst Vasc Inst, Toledo, OH USA
关键词
FLOW; ARTERIES;
D O I
10.1016/j.jvsv.2014.07.003
中图分类号
R61 [外科手术学];
学科分类号
摘要
Background: There is significant interest in a venous prosthesis to replace insufficient valves. The aim of the current study was to select the patients with hemodynamic conditions most likely to benefit from a valve implant. The hypothesis is that the venous valve prosthesis is most suitable for patients with significant reflux, such as in chronic venous insufficiency (CVI), right heart hypertrophy (RHH), and right heart failure (RHF). Conversely, a prosthetic valve is likely to be of least benefit for deep venous thrombosis (DVT) patients with low flow. Methods: To address this hypothesis, fully coupled fluid and solid mechanics computational models were developed and validated in five acute canine implants. The animal-validated simulations were then carried out for the CVI, RHH, RHF, and DVT patients based on literature hemodynamic data. A mechanical stress ratio of leaflet wall stress to fluid wall shear stress was defined to combine the effects of both fluid mechanics and solid mechanics on leaflet function, for which a lower stress ratio is hemodynamically desirable. Results: The simulation results of mean valve flow velocity and percentage valve opening were found to be within 10% of the measurements in canines. The simulations show that the patients in the CVI classes 4 to 6, RHH patients, and RHF patients may have a significant reduction in stress ratio with virtual implant of a prosthetic valve. The DVT patient simulations demonstrate a minimal reduction in the stress ratio. After thrombus removal where flow is restored, however, the prosthetic valve may be helpful for post-thrombotic patients. Conclusions: For patient selections of the venous valve prosthesis, the most suitable patients are the CVI classes 4 to 6, RHH, and RHF patients. The least suitable patients are the DVT patients because a valve is not effective under low flow conditions. The present study demonstrates a physics based approach to patient selection that can be tested in future clinical trials.
引用
收藏
页码:75 / 80
页数:6
相关论文
共 50 条
  • [41] Fusing physics-based and deep learning models for prognostics
    Chao, Manuel Arias
    Kulkarni, Chetan
    Goebel, Kai
    Fink, Olga
    RELIABILITY ENGINEERING & SYSTEM SAFETY, 2022, 217
  • [42] Progress in representation and validation of physics-based via models
    Schuster, Christian
    Selli, Giuseppe
    Kwark, Young H.
    Ritter, Mark B.
    Drewniak, James L.
    2007 IEEE WORKSHOP ON SIGNAL PROPAGATION ON INTERCONNECTS, 2007, : 145 - +
  • [43] Physics-based secular variation candidate models for the IGRF
    Fournier, Alexandre
    Aubert, Julien
    Lesur, Vincent
    Thebault, Erwan
    EARTH PLANETS AND SPACE, 2021, 73 (01):
  • [44] IMPROVING THE INTERPRETABILITY OF PHYSICS-BASED BIAS IN MATERIAL MODELS
    Chodora, Evan
    Flynn, Garrison
    Tippetts, Trevor
    Unal, Cetin
    PROCEEDINGS OF THE ASME 2020 VERIFICATION AND VALIDATION SYMPOSIUM, VVS2020, 2020,
  • [45] Physics-Based Models for Catheter, Guidewire and Stent Simulation
    Lenoir, Julien
    Cotin, Stephane
    Duriez, Christian
    Neumann, Paul
    MEDICINE MEETS VIRTUAL REALITY 14: ACCELERATING CHANGE IN HEALTHCARE: NEXT MEDICAL TOOLKIT, 2006, 119 : 305 - +
  • [46] A Comparative Study of Different Physics-Based NBTI Models
    Mahapatra, S.
    Goel, N.
    Desai, S.
    Gupta, S.
    Jose, B.
    Mukhopadhyay, S.
    Joshi, K.
    Jain, A.
    Islam, A. E.
    Alam, M. A.
    IEEE TRANSACTIONS ON ELECTRON DEVICES, 2013, 60 (03) : 901 - 916
  • [47] Neural network applications to reservoirs: Physics-based models and data models
    Aifa, Tahar
    JOURNAL OF PETROLEUM SCIENCE AND ENGINEERING, 2014, 123 : 1 - 6
  • [48] RET selection using rigorous, physics-based computational lithography - art. no. 69251D
    Kapasi, Sanjay
    Graves, Trey
    Smith, Mark D.
    Robertson, Stewart
    Sallee, Chris
    DESIGN FOR MANUFACTURABILITY THROUGH DESIGN-PROCESS INTEGRATION II, 2008, 6925 : D9251 - D9251
  • [49] Physics-based statistical learning approach to mesoscopic model selection
    Taverniers, Soren
    Haut, Terry S.
    Barros, Kipton
    Alexander, Francis J.
    Lookman, Turab
    PHYSICAL REVIEW E, 2015, 92 (05):
  • [50] AlGaN/GaN HFET Models and the Prospects for Physics-Based Compact Models
    Trew, R. J.
    2010 IEEE COMPOUND SEMICONDUCTOR INTEGRATED CIRCUIT SYMPOSIUM (CSICS), 2010,