Direct force measurements between carboxylate-modified latex microspheres and glass using atomic force microscopy

被引:38
|
作者
Assemi, Shoeleh [1 ]
Nalaskowski, Jakub
Johnson, William Paul
机构
[1] Univ Utah, Dept Geol & Geophys, Salt Lake City, UT 84112 USA
[2] Univ Utah, Dept Met Engn, Salt Lake City, UT 84112 USA
基金
美国国家科学基金会;
关键词
interaction energy; adhesion; DLVO; glass; carboxylate-modified latex; atomic force microscopy;
D O I
10.1016/j.colsurfa.2006.03.024
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
Depths of colloid-surface interaction energy minima have been sometimes utilized for estimation of the force holding a colloid to the surface upon contact. Since this approach assumes that non-contact forces prevail following attachment, a comparison of this approach to direct measurement via atomic force microscopy is warranted. Interaction and adhesion forces between 1.0-mu m diameter carboxylate-modified polystyrene latex microspheres and a glass surface were measured directly with an atomic force microscope using the colloidal probe technique. Measurements were conducted as a function of ionic strength in NaCl with and without added MOPS (3-(N-morpholino)-propanesulfonic acid) buffer, at pH 6.8-6.9. Theoretical DLVO force curves were fit to the AFM approach curves by varying the surface potential of the microspheres. The depths of the primary minima of the theoretical DLVO curves fitted to AFM approach curves, were used to estimate adhesion forces according to previously published approaches, and were compared to the pull-off forces measured by AFM. Pull-off forces measured by AFM in both electrolytes were consistently a factor of about 20-30 lower than the pull-off forces estimated from theoretical adhesion forces obtained from DLVO curves. AFM-measured pull-off forces decreased with increasing the ionic strength in both electrolytes, whereas the adhesion forces calculated from DLVO showed either no change or a slight increase with increasing the ionic strength. Possible reasons for these discrepancies include roughness on one or both surfaces, which would presumably reduce the adhesion force via reduced contact area and presence of hydration forces that could reduce adhesion via strong short-range repulsion in the neighborhood of the contact points. These observations demonstrate that DLVO-based approach for determining adhesion force overestimates actual adhesion force, likely because a DLVO-based approach neglects interactions that manifest at very close separation distances and upon contact. (c) 2006 Elsevier B.V. All rights reserved.
引用
收藏
页码:70 / 77
页数:8
相关论文
共 50 条
  • [21] Surface force measurements at kaolinite edge surfaces using atomic force microscopy
    Liu, Jing
    Sandaklie-Nikolova, Linda
    Wang, Xuming
    Miller, Jan D.
    JOURNAL OF COLLOID AND INTERFACE SCIENCE, 2014, 420 : 35 - 40
  • [22] Surface force between particles studied using atomic force microscopy
    Xing, Yaowen
    Liu, Min
    Gui, Xiahui
    Cao, Yijun
    Gao, Zhiyong
    Sun, Wei
    Zhongguo Kuangye Daxue Xuebao/Journal of China University of Mining and Technology, 2019, 48 (06): : 1352 - 1357
  • [23] Adhesion forces between functionalized latex microspheres and protein-coated surfaces evaluated using colloid probe atomic force microscopy
    Xu, LC
    Logan, BE
    COLLOIDS AND SURFACES B-BIOINTERFACES, 2006, 48 (01) : 84 - 94
  • [24] Piezoelectric measurements with atomic force microscopy
    Christman, JA
    Woolcott, RR
    Kingon, AI
    Nemanich, RJ
    APPLIED PHYSICS LETTERS, 1998, 73 (26) : 3851 - 3853
  • [25] Uncertainty of atomic force microscopy measurements
    Gotszalk, Teodor P.
    Janus, Pawel
    Marendziak, Andrzej
    Szeloch, Roman F.
    OPTICA APPLICATA, 2007, 37 (04) : 397 - 403
  • [26] Piezoelectric measurements with atomic force microscopy
    Christman, JA
    Maiwa, H
    Kim, SH
    Kingon, AI
    Nemanich, RJ
    FERROELECTRIC THIN FILMS VII, 1999, 541 : 617 - 622
  • [27] Piezoelectric measurements with atomic force microscopy
    Christman, J.A.
    Maiwa, H.
    Kim, S.-H.
    Kingon, A.I.
    Nemanich, R.J.
    Materials Research Society Symposium - Proceedings, 1999, 541 : 617 - 622
  • [28] Pull-off force measurements between rough surfaces by atomic force microscopy
    Beach, ER
    Tormoen, GW
    Drelich, J
    Han, R
    JOURNAL OF COLLOID AND INTERFACE SCIENCE, 2002, 247 (01) : 84 - 99
  • [29] Tribological analysis of glass fibers using atomic force microscopy (AFM)/lateral force microscopy (LFM)
    Behary, N
    Ghenaim, A
    El Achari, A
    Caze, C
    JOURNAL OF APPLIED POLYMER SCIENCE, 2000, 75 (08) : 1013 - 1025
  • [30] ATOMIC FORCE MICROSCOPY STUDY OF LATEX FILM FORMATION
    WANG, Y
    JUHUE, D
    WINNIK, MA
    LEUNG, OM
    GOH, MC
    LANGMUIR, 1992, 8 (03) : 760 - 762