Direct force measurements between carboxylate-modified latex microspheres and glass using atomic force microscopy

被引:38
|
作者
Assemi, Shoeleh [1 ]
Nalaskowski, Jakub
Johnson, William Paul
机构
[1] Univ Utah, Dept Geol & Geophys, Salt Lake City, UT 84112 USA
[2] Univ Utah, Dept Met Engn, Salt Lake City, UT 84112 USA
基金
美国国家科学基金会;
关键词
interaction energy; adhesion; DLVO; glass; carboxylate-modified latex; atomic force microscopy;
D O I
10.1016/j.colsurfa.2006.03.024
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
Depths of colloid-surface interaction energy minima have been sometimes utilized for estimation of the force holding a colloid to the surface upon contact. Since this approach assumes that non-contact forces prevail following attachment, a comparison of this approach to direct measurement via atomic force microscopy is warranted. Interaction and adhesion forces between 1.0-mu m diameter carboxylate-modified polystyrene latex microspheres and a glass surface were measured directly with an atomic force microscope using the colloidal probe technique. Measurements were conducted as a function of ionic strength in NaCl with and without added MOPS (3-(N-morpholino)-propanesulfonic acid) buffer, at pH 6.8-6.9. Theoretical DLVO force curves were fit to the AFM approach curves by varying the surface potential of the microspheres. The depths of the primary minima of the theoretical DLVO curves fitted to AFM approach curves, were used to estimate adhesion forces according to previously published approaches, and were compared to the pull-off forces measured by AFM. Pull-off forces measured by AFM in both electrolytes were consistently a factor of about 20-30 lower than the pull-off forces estimated from theoretical adhesion forces obtained from DLVO curves. AFM-measured pull-off forces decreased with increasing the ionic strength in both electrolytes, whereas the adhesion forces calculated from DLVO showed either no change or a slight increase with increasing the ionic strength. Possible reasons for these discrepancies include roughness on one or both surfaces, which would presumably reduce the adhesion force via reduced contact area and presence of hydration forces that could reduce adhesion via strong short-range repulsion in the neighborhood of the contact points. These observations demonstrate that DLVO-based approach for determining adhesion force overestimates actual adhesion force, likely because a DLVO-based approach neglects interactions that manifest at very close separation distances and upon contact. (c) 2006 Elsevier B.V. All rights reserved.
引用
收藏
页码:70 / 77
页数:8
相关论文
共 50 条
  • [31] Characterization of latex blend films by atomic force microscopy
    Patel, AA
    Feng, JR
    Winnik, MA
    Vancso, GJ
    McBain, CBD
    POLYMER, 1996, 37 (25) : 5577 - 5582
  • [32] Surface of latex films imaged by atomic force microscopy
    Perez, E
    Marion, P
    Vazquez, F
    Scheer, M
    Pith, T
    Lambla, M
    Lang, J
    REVISTA MEXICANA DE FISICA, 1997, 43 (03) : 436 - 450
  • [33] Probing the force interactions between silver nanoparticles and protein-modified surfaces using atomic force microscopy
    Liu, Xitong
    Livi, Kenneth
    Chen, Kai Loon
    ABSTRACTS OF PAPERS OF THE AMERICAN CHEMICAL SOCIETY, 2016, 252
  • [34] Shale adhesion force measurements via atomic force microscopy
    Mitiurev, Nikolai
    Verrall, Michael
    Shilobreeva, Svetlana
    Keshavarz, Alireza
    Iglauer, Stefan
    OIL AND GAS SCIENCE AND TECHNOLOGY-REVUE D IFP ENERGIES NOUVELLES, 2021, 76 (20):
  • [35] Direct force balance method for atomic force microscopy lateral force calibration
    Asay, DB
    Kim, SH
    REVIEW OF SCIENTIFIC INSTRUMENTS, 2006, 77 (04):
  • [36] Electrochemical direct writing and erasing of silver nanostructures on phosphate glass using atomic force microscopy
    Barna, Shama F.
    Jacobs, Kyle E.
    Mensing, Glennys A.
    Ferreira, Placid M.
    NANOTECHNOLOGY, 2017, 28 (06)
  • [37] Accurate Electrostatic Force Measurements by Atomic Force Microscopy Using Proper Distance Control
    Fukuzawa, Ryota
    Kobayashi, Daichi
    Takahashi, Takuji
    IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT, 2023, 72
  • [38] Quantitative force measurements using frequency modulation atomic force microscopy - theoretical foundations
    Sader, JE
    Uchihashi, T
    Higgins, MJ
    Farrell, A
    Nakayama, Y
    Jarvis, SP
    NANOTECHNOLOGY, 2005, 16 (03) : S94 - S101
  • [39] Calibration of lateral force measurements in atomic force microscopy with a piezoresistive force sensor
    Xie, Hui
    Vitard, Julien
    Haliyo, Sinan
    Regnier, Stephane
    Boukallel, Mehdi
    REVIEW OF SCIENTIFIC INSTRUMENTS, 2008, 79 (03):
  • [40] Quantitative measurements of shear displacement using atomic force microscopy
    Wang, Wenbo
    Sun, Ying
    Zhao, Yonggang
    Wu, Weida
    APPLIED PHYSICS LETTERS, 2016, 108 (12)