End-Group Functionalization of Poly(3-hexylthiophene) as an Efficient Route to Photosensitize Nanocrystalline TiO2 Films for Photovoltaic Applications

被引:38
|
作者
Krueger, Robin A. [1 ]
Gordon, Terry J. [1 ]
Baumgartner, Thomas [1 ]
Sutherland, Todd C. [1 ]
机构
[1] Univ Calgary, Dept Chem, Calgary, AB T2N 1N4, Canada
基金
加拿大自然科学与工程研究理事会;
关键词
energy conversion; polythiophene; thin films; electrochemistry; mesoporous TiO2; sensitizers; SENSITIZED SOLAR-CELLS; CONJUGATED POLYMERS; ANCHORING GROUP; POLYTHIOPHENE; CATECHOL; LIGHT; RECOMBINATION; ETHYNYLENE); FABRICATION; CONVERSION;
D O I
10.1021/am200262w
中图分类号
TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
Bulk heterojunction (BHJ) and dye-sensitized solar cells (DSSCs) have seen increased popularity over recent years and each technology has experienced tremendous improvements in power conversion efficiencies (PCEs), reaching 8 and 12%, respectively. The two technologies have been on independent improvement pathways, and this work establishes a link between them by using the archetypical hole conductor (poly-3-hexylthiophene, P3HT) in BHJs as a sensitizer on TiO2 for DSSC applications. Three polymers were synthesized and examined as potential TiO2 sensitizers in DSSCs under AM1.5 solar radiation. Using Grignard metathesis, regioregular P3HT was synthesized then functionalized with either one or two cyanoacrylic acid linker moieties to bind to the TiO2 surface. End-group modification resulted in minimal changes to the optical and electronic properties as compared to pristine P3HT. Cyclic voltammetry (CV) experiments at anodic potentials of adsorbed sensitizer quantified the amount of alkylthiophene adsorbed on the TiO2, whereas under reductive sweeps, cyanoacrylic acid end-group binding was determined. CVs of each polymer indicated that loading was drastically different as compared to pristine P3HT with the lowest loading on TiO2 and monofunctionalized P3HT exhibited the highest loading. The DSSCs showed power conversion efficiencies (PCEs) of 0.1%, 0.2 and 2.2% for the polymer-sensitized TiO2 of the unfunctionalized, monofunctionalized and difunctionalized polymers, respectively. DSSCs were then subjected to electrochemical impedance spectroscopy (EIS) in the dark and under monochromatic light radiation. The large variance in performance for the functionalized-P3HT sensitizers is attributed to differences in the adsorption modes of sensitizer on the TiO2 surface, which in the difunctionalized case limits electrolyte recombination and favors forward charge transfer reactions.
引用
收藏
页码:2031 / 2041
页数:11
相关论文
共 50 条
  • [1] End-group stannylation of regioregular poly(3-hexylthiophene)s
    Zhang, Luozheng
    Hashimoto, Kazuhito
    Tajima, Keisuke
    POLYMER JOURNAL, 2012, 44 (11) : 1145 - 1148
  • [2] End-group stannylation of regioregular poly(3-hexylthiophene)s
    Luozheng Zhang
    Kazuhito Hashimoto
    Keisuke Tajima
    Polymer Journal, 2012, 44 : 1145 - 1148
  • [3] Synthesis and Characterization of Monocarboxylated Poly(3-hexylthiophene)s via Quantitative End-Group Functionalization
    Lohwasser, Ruth H.
    Thelakkat, Mukundan
    MACROMOLECULES, 2010, 43 (18) : 7611 - 7616
  • [4] Synthesis and characterization of carboxystyryl end-functionalized poly(3-hexylthiophene)/TiO2 hybrids in view of photovoltaic applications
    Boon, Florian
    Thomas, Amandine
    Clavel, Guylhaine
    Moerman, David
    De Winter, Julien
    Laurencin, Danielle
    Coulembier, Olivier
    Dubois, Philippe
    Gerbaux, Pascal
    Lazzaroni, Roberto
    Richeter, Sebastien
    Mehdi, Ahmad
    Clement, Sebastien
    SYNTHETIC METALS, 2012, 162 (17-18) : 1615 - 1622
  • [5] Poly(3-hexylthiophene):TiO2 nanocomposites for solar cell applications
    Kwong, CY
    Choy, WCH
    Djurisic, AB
    Chui, PC
    Cheng, KW
    Chan, WK
    NANOTECHNOLOGY, 2004, 15 (09) : 1156 - 1161
  • [6] Degradation and stabilization of poly(3-hexylthiophene) thin films for photovoltaic applications
    Griffini, Gianmarco
    Turri, Stefano
    Levi, Marinella
    POLYMER BULLETIN, 2011, 66 (02) : 211 - 222
  • [7] Degradation and stabilization of poly(3-hexylthiophene) thin films for photovoltaic applications
    Gianmarco Griffini
    Stefano Turri
    Marinella Levi
    Polymer Bulletin, 2011, 66 : 211 - 222
  • [8] A scanning probe microscopy study of nanostructured TiO2/poly(3-hexylthiophene) hybrid heterojunctions for photovoltaic applications
    Letertre, Laurie
    Roche, Roland
    Douheret, Olivier
    Kassa, Hailu G.
    Mariolle, Denis
    Chevalier, Nicolas
    Borowik, Lukasz
    Dumas, Philippe
    Grevin, Benjamin
    Lazzaroni, Roberto
    Leclere, Philippe
    BEILSTEIN JOURNAL OF NANOTECHNOLOGY, 2018, 9 : 2087 - 2096
  • [9] The influence of the oxidation degree of poly(3-hexylthiophene) on the photocatalytic activity of poly(3-hexylthiophene)/TiO2 composites
    Xu, Shoubin
    Gu, Lingxiao
    Wu, Kaihua
    Yang, Haigang
    Song, Yuanqing
    Jiang, Long
    Dan, Yi
    SOLAR ENERGY MATERIALS AND SOLAR CELLS, 2012, 96 (01) : 286 - 291
  • [10] Using scanning probe microscopy to study the effect of molecular weight of poly(3-hexylthiophene) on the performance of poly(3-hexylthiophene):TiO2 nanorod photovoltaic devices
    Wu, Ming-Chung
    Lo, Hsi-Hsing
    Liao, Hsueh-Chung
    Chen, Sharon
    Lin, Yun-Yue
    Yen, Wei-Che
    Zeng, Tsung-Wei
    Chen, Yang-Fang
    Chen, Chun-Wei
    Su, Wei-Fang
    SOLAR ENERGY MATERIALS AND SOLAR CELLS, 2009, 93 (6-7) : 869 - 873