InGaSb-on-insulator p-channel metal-oxide-semiconductor field-effect transistors on Si fabricated by direct wafer bonding

InGaSb-on-insulator (InGaSb-OI) and InAs/InGaAs/InAs-on-insulator (InAs/InGaAs-OI) structures have been realized on Si by a direct wafer bonding (DWB) technology using atomic-layer-deposition Al2O3. While strain introduced in InGaSb channel layers grown on InAs can enhance the hole mobility of the Sb-based channel layers, a difficult issue of fabricating InGaSb-OI wafers is to obtain a smooth InGaSb surface, which is mandatory for wafer bonding. In this study, the surface of a 20-nm-thick In0.185Ga0.815Sb channel grown on an InAs (100) substrate and an InAs (2.5 nm)/In0.185Ga0.815Sb (20 nm)/InAs (2.5 nm) channel with a 20-nm-thick GaSb buffer layer grown on an InAs (100) substrate by metal-organic chemical vapor deposition have a root mean square of the surface roughness as low as 0.16 and 0.22 nm, respectively, over a scan area of 10 x 10 mu m(2), which are smooth enough to employ the wafer bonding. As a result, the fabrication of the InGaSb-OI wafers by the DWB and the operation of InGaSb-OI p-channel metal-oxide-semiconductor field-effect transistors (p-MOSFETs) by using the DWB wafers are demonstrated. Also, the performance of InGaSb-OI p-MOSFETs is found to be improved by inserting ultrathin InAs layers between InGaSb and insulating buried oxide layers. An InGaSb-OI and an InAs/InGaAs-OI p-MOSFET under the accumulation-mode operation exhibit a peak mobility of similar to 161 and similar to 273 cm(2)/V s, respectively. The channel hole mobility of the InGaSb-OI p-MOSFET is higher than that of the GaSb-on-insulator (GaSb-OI) p-MOSFET and can exceed that of Si p-MOSFETs. Published under license by AIP Publishing.