THE INFLUENCE OF INJECTION TIME AND HOLDING TIME ON THE RESIDUAL STRESS STATE IN INJECTION MOULDED PARTS

被引：1

作者：

Jaruga, Tomasz ^{[1
]}

Mazik, Katarzyna ^{[1
]}

机构：

[1] Politech Czestochowska, Inst Technol Mech, Zaklad Przetworstwa Polimerow, PL-42201 Czestochowa, Poland

来源：

POLIMERY | 2013年 / 58卷 / 7-8期

关键词：

injection moulding; residual stress; photoelastic investigation; injection time; holding time; SHRINKAGE;

D O I：

10.14314/polimery.2013.587

中图分类号：

O63 [高分子化学（高聚物）];

学科分类号：

070305 ; 080501 ; 081704 ;

摘要：

The requirements for the manufacturing process of transparent parts by injection moulding were described. Special attention was paid to such processing parameters like injection time and holding time, which are essential for the production of good quality parts. The effect of these parameters on the residual stress in (methyl methacrylate)-acrylonitrile-butadiene-styrene plastic (MABS) injection moulded parts was investigated using photoelastic analysis.

引用

页码：587 / 596

页数：10

共 50 条

[11] Quality assessment of injection-moulded parts
Hawrylecka, U.
Sikora, R.
International Polymer Science and Technology, 1994, 21 (12)
[12] Influence of the pressure holding time on strain generation in fuel injection lines
Basara, Adis
Alt, Nicolas
Schluecker, Eberhard
INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING, 2011, 88 (04) : 132 - 137
[13] Thin Foil Enhances Injection Moulded Parts
Kirchberg, Gerd
ATZ worldwide, 2011, 113 (04) : 32 - 35
[14] Improving impact toughness of injection moulded parts
Newkirk, J.W.
Metal Powder Report, 2001, 56 (03)
[15] Change on temperature at the surface of injection moulded parts
Nicolazo, C.
Sarda, A.
Vachot, P.
Mousseau, P.
Deterre, R.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, 2010, 210 (02) : 233 - 237
[16] Measurement of internal stresses in injection moulded parts
Hoffmann, K.
Kausche, H.
Kunststoffe, German plastics, 1988, 78 (06): : 22 - 23
[17] Short cycles for injection moulded microfluidics parts
Bourdon, R
KUNSTSTOFFE-PLAST EUROPE, 2003, 93 (09): : 33 - +
[18] Influence of residual stresses on mechanical and thermal properties of injection moulded polycarbonate
Akay, M.
Ozden, S.
Plastics, Rubber and Composites Processing and Applications, 1996, 25 (03): : 138 - 144
[19] Residual Stresses in Short-Fibre Reinforced Injection-Moulded Thermoplastic Parts
Mlekusch B.A.
Mechanics of Time-Dependent Materials, 1998, 2 (2) : 129 - 169
[20] Study of residual gas formed during plasma debinding of powder injection moulded parts
Sobrinho, ASD
Speller, CV
Amorim, J
JOURNAL OF PHYSICS D-APPLIED PHYSICS, 2006, 39 (01) : 94 - 98

← 1 2 3 4 5 →