Effect of machining area on material removal rate in strip EDM

被引：0
|
作者：
Ki Young Song
Chong Nam Chu
机构：
[1] Sharp Engineering,Department of Mechanical and Aerospace Engineering
[2] Seoul National University,undefined
来源：
International Journal of Precision Engineering and Manufacturing | 2015年 / 16卷
关键词：
Electrical discharge machining; Electrode; Wear;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
Strip EDM is similar to wire EDM, except that the electrode is a roll of brass strip. In this study, investigated is the effect of machining area on material removal rate (MRR) in strip EDM, The MRR was measured according to different machining areas and different electrical discharge conditions. For a given discharge condition, optimal machining area for maximum MRR was identified. The optimal machining area was larger under higher discharge energy condition. It is shown that strip EDM is much more efficient than wire EDM because material removal rate is much higher and the electrode consumption is much less.
引用
收藏
页码：2435 / 2440
页数：5
相关论文
共 50 条
12345