Solidification of Ni-Re Peritectic Alloys

被引:0
|
作者
W. J. Boettinger
D. E. Newbury
N. W. M. Ritchie
M. E. Williams
U. R. Kattner
E. A. Lass
K.-W. Moon
M. B. Katz
J. H. Perepezko
机构
[1] Theiss Research,Materials Science and Engineering Division
[2] National Institute of Standards and Technology,Materials Measurement Science Division
[3] National Institute of Standards and Technology,Department of Materials Science and Engineering
[4] University of Wisconsin,undefined
关键词
D O I
暂无
中图分类号
学科分类号
摘要
Differential thermal analysis (DTA) and microstructural and microprobe measurements of DTA and as-cast Ni-Re alloys with compositions between 0.20 and 0.44 mass fraction Re provide information to resolve differences in previously published Ni-Re phase diagrams. This investigation determines that the peritectic invariant between liquid, Re-rich hexagonal close packed and Ni-rich face center cubic phases, L + HCP → FCC, occurs at 1561.1 °C ± 3.4 °C (1σ) with compositions of liquid, FCC and HCP phases of 0.283 ± 0.036, 0.436 ± 0.026, and 0.828 ± 0.037 mass fraction Re, respectively. Analysis of the microsegregation in FCC alloys yields a partition coefficient for solidification, k = 1.54 ± 0.09 (mass frac./mass frac.). A small deviation from Scheil behavior due to dendrite tip kinetics is documented in as-cast samples. No evidence of an intermetallic phase is observed.
引用
收藏
页码:772 / 788
页数:16
相关论文
共 50 条
  • [31] Interdiffusion in the Ni-Re System: Evaluation of Uncertainties
    W. J. Boettinger
    M. E. Williams
    K.-W. Moon
    G. B. McFadden
    P. N. Patrone
    J. H. Perepezko
    Journal of Phase Equilibria and Diffusion, 2017, 38 : 750 - 763
  • [32] UNIDIRECTIONAL SOLIDIFICATION OF PERITECTIC CU-SN ALLOYS
    SALLI, IV
    IPATOVA, VN
    RUSSIAN METALLURGY, 1973, (04): : 154 - 156
  • [33] Peritectic reaction and solidification in iron-nickel alloys
    N. J. McDonald
    S. Sridhar
    Metallurgical and Materials Transactions A, 2003, 34 : 1931 - 1940
  • [34] A kinetic Monte Carlo study of vacancy diffusion in non-dilute Ni-Re alloys
    Goswami, Kamal Nayan
    Mottura, Alessandro
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2019, 743 : 265 - 273
  • [35] First-principles modeling of energetic and mechanical properties of Ni-Cr, Ni-Re and Cr-Re random alloys
    Breidi, A.
    Fries, S. G.
    Palumbo, M.
    Ruban, A. V.
    COMPUTATIONAL MATERIALS SCIENCE, 2016, 117 : 45 - 53
  • [36] Phase selection during directional solidification of peritectic alloys
    T. A. Lograsso
    B. C. Fuh
    R. Trivedi
    Metallurgical and Materials Transactions A, 2005, 36 : 1287 - 1300
  • [37] CALCULATION OF SOLIDIFICATION PARAMETERS FOR ALLOYS UNDERGOING A PERITECTIC TRANSFORMATION
    BELYAEV, PV
    PIKUNOV, MV
    RUSSIAN METALLURGY, 1991, (03): : 193 - 196
  • [38] Phase selection during directional solidification of peritectic alloys
    Lograsso, TA
    Fuh, BC
    Trivedi, R
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2005, 36A (05): : 1287 - 1300
  • [39] Peritectic reaction and solidification in iron-nickel alloys
    McDonald, NJ
    Sridhar, S
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2003, 34A (09): : 1931 - 1940
  • [40] Peritectic solidification of undercooled Fe-Co alloys
    Liu, N.
    Liu, F.
    Yang, C. L.
    Chen, Y. Z.
    Yang, G. C.
    Zhou, Y. H.
    JOURNAL OF ALLOYS AND COMPOUNDS, 2008, 465 (1-2) : 391 - 395