Influence of particle size distribution on minimum fluidization velocity and bed expansion at elevated pressure

被引:47
|
作者
Feng, Rongtao [1 ,2 ]
Li, Junguo [1 ]
Cheng, Zhonghu [1 ]
Yang, Xin [3 ]
Fang, Yitian [1 ]
机构
[1] Chinese Acad Sci, State Key Lab Coal Convers, Inst Coal Chem, Taiyuan 030001, Shanxi, Peoples R China
[2] Univ Chinese Acad Sci, Beijing 100039, Peoples R China
[3] Univ Sheffield, Dept Mech Engn, Sheffield S10 2TN, S Yorkshire, England
关键词
Gas-solid fluidization; Particle size distribution; Minimum fluidization velocity; Bed expansion; Pressure; BINARY-MIXTURE; GAS; TEMPERATURES; REACTORS; SYSTEMS; PHASE; FLOW;
D O I
10.1016/j.powtec.2017.07.024
中图分类号
TQ [化学工业];
学科分类号
0817 ;
摘要
This paper presents an experimental study on the effects of elevated pressure and particle size distribution (PSD) on the minimum fluidization velocity (U-mf) and the bed expansion. It was developed with Geldart B and D-type polystyrene particles. Four wide PSDs and five narrow PSDs were investigated. The four wide PSDs studied included a Gaussian distribution, a flat distribution, a ternary mixture, and a binary mixture, all with the same mean diameters. Operation pressure ranged from 0.1 MPa (absolute pressure) to 2.7 MPa. The results revealed that the U(mf)s of the wide PSDs were lower than that of the reference narrow PSD with the same diameter at pressures exceeding 0.3 MPa. The segregation tendency of wide PSDs decreases with the increase in the operating pressure. The four wide PSDs had obviously different U(mf)s at pressures below 0.9 MPa; however, this difference in the Units was gradually reducing with a further increase in the pressure (>0.9 MPa). The bed expansion increased with increasing the pressure at same excess fluidized gas velocity. Correlations basing on experimental data were proposed in order to predict the U-mf and bed expansion for the narrow PSD at elevated pressures, and three correlations were investigated for predicting the U-mf of wide PSD. (C) 2017 Elsevier B.V. All rights reserved.
引用
收藏
页码:27 / 36
页数:10
相关论文
共 50 条
  • [41] MINIMUM FLUIDIZATION VELOCITY AT ELEVATED-TEMPERATURES AND PRESSURES
    BIN, AK
    CANADIAN JOURNAL OF CHEMICAL ENGINEERING, 1986, 64 (05): : 854 - 857
  • [42] EXPERIMENTAL RESEARCH OF THE INFLUENCE OF PARTICLE SIZE AND FLUIDIZATION VELOCITY ON ZEOLITE DRYING IN A TWO-COMPONENT FLUIDIZED BED
    Janevski, Jelena N.
    Stojiljkovic, Mladen M.
    Stojanovic, Branislav V.
    Vukic, Mica V.
    THERMAL SCIENCE, 2016, 20 : S103 - S111
  • [43] Experimental research of the influence of particle size and fluidization velocity on zeolite drying in a two-component fluidized bed
    Janevski J.N.
    Stojiljković M.M.
    Stojanović B.V.
    Vukić M.V.
    Thermal Science, 2016, 20 : s103 - s111
  • [44] Significance of temperature and pressure on minimum fluidization velocity in a fluidized bed reactor: An experimental analysis
    Singh, Rupesh Kumar
    Dhaigude, Nilesh D. D.
    Sahu, Arti
    Chauhan, Vishal
    Sahu, Gajanan
    Saha, Sujan
    Chavan, Prakash D. D.
    ENERGY SOURCES PART A-RECOVERY UTILIZATION AND ENVIRONMENTAL EFFECTS, 2023, 45 (01) : 1793 - 1806
  • [45] Bubbles and bed expansion in low pressure fluidization
    Weerasiri, Lanka Dinushke
    Fabijanic, Daniel
    Das, Subrat
    POWDER TECHNOLOGY, 2024, 432
  • [46] Minimum Fluidization Velocity and Expansion Behavior of Spherical Particle Beds Fluidized with Inelastic and Viscoelastic Fluids
    Kaur, Amanjot
    Sobti, Amit
    Wanchoo, Ravinder Kumar
    INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH, 2023, 62 (44) : 18704 - 18719
  • [47] The minimum fluidization velocity and dynamic characteristics of agglomerated carbon nanotube in a tapered fluidized bed at elevated temperature
    Bai, Wenjuan
    Chu, Dianming
    He, Yan
    CHEMICAL ENGINEERING RESEARCH & DESIGN, 2021, 168 : 239 - 253
  • [48] Effects of pressure on the minimum fluidization velocity and bubble properties in a gas-solid fluidized bed
    Kang, SH
    Kang, Y
    Han, KH
    Jin, GT
    JOURNAL OF INDUSTRIAL AND ENGINEERING CHEMISTRY, 2004, 10 (03) : 330 - 336
  • [49] The Effect of Column Diameter and Bed Height on Minimum Fluidization Velocity
    Rao, Akhil
    Curtis, Jennifer S.
    Hancock, Bruno C.
    Wassgren, Carl
    AICHE JOURNAL, 2010, 56 (09) : 2304 - 2311
  • [50] Effect of bed diameter, distrubutor and inserts on minimum fluidization velocity
    Hilal, N
    Ghannam, MT
    Anabtawi, MZ
    CHEMICAL ENGINEERING & TECHNOLOGY, 2001, 24 (02) : 161 - 165