Evaluation of the electromechanical properties in GdBCO coated conductor tapes under low cyclic loading and bending

被引:16
|
作者
Shin, Hyung-Seop [1 ]
Gorospe, Alking [1 ]
Bautista, Zhierwinjay [1 ]
Dedicatoria, Marlon J. [1 ]
机构
[1] Andong Natl Univ, Dept Mech Design Engn, Andong 760749, South Korea
来源
SUPERCONDUCTOR SCIENCE & TECHNOLOGY | 2016年 / 29卷 / 01期
基金
新加坡国家研究基金会;
关键词
coated conductor; cyclic loading; cyclic bending; electromechanical property; transverse tension; STRAIN; BEHAVIOR; STRESS;
D O I
10.1088/0953-2048/29/1/014001
中图分类号
O59 [应用物理学];
学科分类号
摘要
The effects of low cyclic loading on the critical current, I-c, under uniaxial and transverse loadings, and bending deformations in GdBCO coated conductor (CC) tapes were evaluated. Under monotonic continuous bending deformation, CC tapes exhibit a high tolerance of I-c up to the lowest bending diameter of 12 mm using the Goldacker bending test rig. However, when the CC tape was subjected to alternate tension-compression bending, a lower irreversible bending strain limit was measured. This was also observed when cyclic bending was applied to the CC tapes which showed a significant decrease in I-c just after 10 cycles of alternate tension-compression bending at 20 mm bending diameter. Such different I-c degradation behavior under different bending deformation procedures gave insight into the proper handling of CC tapes from manufacturing, coiling and up to operating conditions. In the case of uniaxial tension, when electromechanical properties of CC tape were evaluated by repeated loading based on a critical stress level obtained under monotonic loading, I-c also did not show significant change in its degradation behavior up to the irreversible stress limit. The GdBCO CC tape adopted can allow cyclic loading up to 100 cycles without significant irreversible degradation below the monotonic irreversible limit. In the case of the transverse cyclic test, with regard to the large scattering of data especially in the tensile direction, a different cyclic loading procedure was established. For 10 repeated loadings, the mechanical and electromechanical properties of the GdBCO CC tapes showed similar values within the reversible range under the monotonic loading. I-c degraded abruptly indicating that no delamination occurred at the REBCO film during the subcritical cyclic loading. Different fracture morphologies were observed under cyclic loading depicting branch-like patterns of the remaining REBCO layer on the substrate of the CC tape.
引用
收藏
页数:12
相关论文
共 50 条
  • [41] Interface properties and failures of REBCO coated conductor tapes: Research progress and challenges
    Gao, Peifeng
    Zhang, Yameng
    Wang, Xingzhe
    Zhou, Youhe
    SUPERCONDUCTIVITY, 2023, 8
  • [42] The relationship between electromechanical cyclic loading and the performance degradation of a smart bending piezoelectric actuator
    Woo, Sung-Choong
    Goo, Nam Seo
    SMART MATERIALS AND STRUCTURES, 2009, 18 (10)
  • [43] Evaluation of electromechanical properties in REBCO CC tapes under transverse compression using anvil test method
    Diaz, Mark Angelo
    Shin, Hyung-Seop
    PROGRESS IN SUPERCONDUCTIVITY AND CRYOGENICS, 2022, 24 (03): : 57 - 61
  • [44] Performance Evaluation of Practical REBCO Coated Conductor Tapes for Superconducting Wind Power Coils
    Shin, Hyung-Seop
    Diaz, Mark A.
    Velasco, Madelene
    Awaji, Satoshi
    IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY, 2020, 30 (04)
  • [45] Comparison of the Bending Strain Effect on Transport Property in Lap- and Butt-Jointed Coated Conductor Tapes
    Shin, Hyung-Seop
    Dedicatoria, Marlon J.
    IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY, 2010, 20 (03) : 1541 - 1544
  • [46] Critical current degradation behaviors of ReBCO coated conductor tapes under pressurized liquid nitrogen
    Shin, H. S.
    Dedicatoria, M. J.
    PHYSICA C-SUPERCONDUCTIVITY AND ITS APPLICATIONS, 2010, 470 (20): : 1329 - 1333
  • [47] Performance of Modular SFCL Using REBCO Coated Conductor Tapes Under Repetitive Overcurrent Tests
    Baldan, Carlos A.
    Yuan Weijia
    Shigue, Carlos Y.
    Ruppert Filho, Ernesto
    IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY, 2016, 26 (03)
  • [48] Study on mechanical properties of truss cable structure under low cyclic loading
    Sun, Guojun
    Xiao, Shuo
    Wu, Jinzhi
    JOURNAL OF BUILDING ENGINEERING, 2022, 58
  • [49] Damage mechanism of REBCO coated conductor in CORC cables under electromagnetic loading
    Ma, Jintao
    Ta, Wurui
    Yan, Jiangtao
    Jin, Zhiwen
    Gao, Yuanwen
    Zhou, Youhe
    ENGINEERING FRACTURE MECHANICS, 2025, 319
  • [50] Improvement of Surface Morphology and Superconducting Properties of YBCO Coated Conductor on Ni-W Tapes
    Li, Yijie
    Liu, Linfei
    Xiao, Guina
    Xu, Da
    Wang, Ying
    Wu, Xiang
    Zhu, Peng
    Luo, Qiang
    IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY, 2013, 23 (03)