Characterization of SnO2:F thin films deposited by an economic spray pyrolysis technique

被引:34
|
作者
Memarian, Nafiseh [1 ]
Rozati, Seyed Mohammad [1 ]
Elamurugu, Elangovan [2 ,3 ]
Fortunato, Elvira [2 ,3 ]
机构
[1] Univ Guilan, Dept Phys, Rasht 41335, Iran
[2] Univ Nova Lisboa, CENIMAT, FCT, I3N,Dept Ciencias Mat, P-2829516 Caparica, Portugal
[3] CEMOP UNINOVA, P-2829516 Caparica, Portugal
关键词
SnO2; doping; spray pyrolysis; structure; electrical properties; optical properties; OXIDE-FILMS; TRANSPARENT CONDUCTORS; ELECTRICAL-PROPERTIES; LOW-COST; FLUORINE; THICKNESS; PRECURSOR; GROWTH; SNCL2;
D O I
10.1002/pssc.200983738
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Fluorine doped tin oxide (FTO) semiconductor thin films were deposited on glass substrates using spray pyrolysis technique and the effect of fluorine (F-) doping (varying 0-30 at %) is explored. X-ray diffraction studies confirmed the tetragonal structure with polycrystalline nature. The crystallinity of undoped films is enhanced with the increase in F-doping. The films doped with 25 at % F show a strong orientation along (101) plane. The grain size of the undoped films (214 nm) is increased with the increase in F-doping level to reach a maximum of 415 nm (25 at % F). A minimum sheet resistance of similar to 5.4 Omega/square obtained for the 30 at % F doped films is among the lowest reported values. The average visible transmittance (400-700 nm) of the undoped films (61.4 %) is increased with the increasing F-doping to reach a maximum of 74.5 % (25 at %. F). The films doped with 25 at. % F showed high value of figure of merit (4.55 x 10(-3) Omega(-1)). The obtained results authenticate the influence of F-doping on the properties of the deposited films. (C) 2010 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim
引用
收藏
页数:5
相关论文
共 50 条
  • [1] CHARACTERIZATION OF NANOCRYSTALLINE SnO2:F THIN FILMS PREPARED BY THE SPRAY PYROLYSIS TECHNIQUE
    Ikhmayies, Shadia J.
    T.T. CHEN HONORARY SYMPOSIUM ON HYDROMETALLURGY, ELECTROMETALLURGY AND MATERIALS CHARACTERIZATION, 2012, : 511 - 522
  • [2] Investigation of some properties of SnO2:Sb:F thin films by an economic spray pyrolysis technique
    Tatar, D. (demettatar@atauni.edu.tr), 1600, National Institute of Optoelectronics (07): : 7 - 8
  • [3] Structural and photoluminescence characterization of SnO2: F thin films deposited by advanced spray pyrolysis technique at low substrate temperature
    Shewale, P. S.
    Sim, Kyu Ung
    Kim, Ye-bin
    Kim, J. H.
    Moholkar, A. V.
    Uplane, M. D.
    JOURNAL OF LUMINESCENCE, 2013, 139 : 113 - 118
  • [4] Investigation of some properties of SnO2:Sb:F thin films by an economic spray pyrolysis technique
    Kocyigit, A.
    Tatar, D.
    Battal, A.
    Aydin, S.
    Turgut, G.
    Duzgun, B.
    OPTOELECTRONICS AND ADVANCED MATERIALS-RAPID COMMUNICATIONS, 2013, 7 (7-8): : 530 - 535
  • [5] Humidity Response of SnO2 Thin Films Deposited by Spray Pyrolysis
    Tripathi, Aakhilesh
    Pandey, Akhilesh
    Shukla, R. K.
    PROCEEDING OF INTERNATIONAL CONFERENCE ON RECENT TRENDS IN APPLIED PHYSICS & MATERIAL SCIENCE (RAM 2013), 2013, 1536 : 479 - +
  • [6] Fabrication of textured SnO2:F thin films by spray pyrolysis
    Ren, Yang
    Zhao, Gaoyang
    Chen, Yuanqing
    APPLIED SURFACE SCIENCE, 2011, 258 (02) : 914 - 918
  • [7] Effect of Carrier Gas on Spray Pyrolysis Deposited SnO2 Thin Films
    Katariya, Nitu
    Singh, Bhavana
    Saxena, Amit
    Ganesan, Vedachalaiyer
    MACROMOLECULAR SYMPOSIA, 2023, 407 (01)
  • [8] Characterization of SnO2 Thin Films Fabricated by Chemical Spray Pyrolysis
    Bendahmane, Bouteina
    Touidjen, Nour El Houda
    Mansour, Farida
    2019 INTERNATIONAL CONFERENCE ON ADVANCED ELECTRICAL ENGINEERING (ICAEE), 2019,
  • [9] CHARACTERIZATION OF CONDUCTING SNO2 LAYERS DEPOSITED BY MODIFIED SPRAY PYROLYSIS TECHNIQUE
    SINGH, SK
    BASU, S
    MATERIALS CHEMISTRY AND PHYSICS, 1988, 20 (4-5) : 381 - 396
  • [10] Electrical and optical properties of Co2+:SnO2 thin films deposited by spray pyrolysis technique
    T. Indira Gandhi
    R. Ramesh Babu
    K. Ramamurthi
    M. Arivanandhan
    Journal of Materials Science: Materials in Electronics, 2016, 27 : 1662 - 1669