Notch Sensitivity of the Fatigue Limit in High-Strength Steel

被引:7
|
作者
Hamano, Yasuaki [1 ]
Koyama, Motomichi [2 ]
Hamada, Shigeru [2 ]
Noguchi, Hiroshi [2 ]
机构
[1] Kyushu Univ, Grad Sch Engn, Nishi Ku, 744 Moto Oka, Fukuoka 8190395, Japan
[2] Kyushu Univ, Dept Mech Engn, Fac Engn, Nishi Ku, 744 Moto Oka, Fukuoka 8190395, Japan
关键词
fatigue limit; notch sensitivity; drill hole; FIB notch; high-strength steel; QUANTITATIVE-EVALUATION; STRESS; CRACK; INCLUSIONS;
D O I
10.2355/isijinternational.ISIJINT-2015-744
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
The fatigue limit of a tempered martensitic steel was evaluated in specimens with stress concentration sources, which were introduced with a small drill and focused ion beam (FIB). In a previous study using ferrite-pearlite steel, the fatigue limit of a specimen with a FIB notch was almost the same as the fatigue limit of a specimen with a drill hole, and the non-propagating cracks were found around both shapes of stress concentration sources. However, the fatigue limit of the specimen with a FIB notch was about 100 MPa lower than the fatigue limit of the specimen with a drill hole in tempered martensitic steel. Additionally, the non-propagating crack was observed only in the specimen with a FIB notch. The stress concentration source shapes in both materials are the same, then the difference in fatigue limit stems from the material property. This indicates that there is applicable range where stress concentration source is regarded as a pre-crack, and the range depends on material. At first, the reason for the difference in fatigue limit was discussed in terms of the non-propagating crack. In this part, we discussed non propagating crack phenomenon around drill hole. Secondly, the effect of hardness which caused the difference in fatigue limit was discussed by using an analytical result of Dugdale model. Finally, we inferred the notch sensitivity from the propagation by deformation at crack tip. After that, we concluded that the propagation by fracture at crack tip is also important factor in analyzing notch sensitivity.
引用
收藏
页码:1480 / 1486
页数:7
相关论文
共 50 条
  • [41] INITIATION AND EARLY GROWTH OF FATIGUE CRACKS IN HIGH-STRENGTH STEEL
    LANKFORD, J
    ENGINEERING FRACTURE MECHANICS, 1977, 9 (03) : 617 - 624
  • [42] CRACK NUCLEATION AND PROPAGATION OF CORROSION FATIGUE IN HIGH-STRENGTH STEEL
    HIROSE, Y
    MURA, T
    ENGINEERING FRACTURE MECHANICS, 1985, 22 (05) : 859 - 870
  • [43] Evaluation of corrosion fatigue life for high-strength steel wires
    Lan, Chengming
    Feng, Ao
    Zhang, Yaoyao
    Ma, Junming
    Wang, Jianjun
    Li, Hui
    JOURNAL OF CONSTRUCTIONAL STEEL RESEARCH, 2024, 217
  • [44] INITIATION AND PROPAGATION OF FATIGUE CRACK IN HIGH-STRENGTH EUTECTOID STEEL
    YOKOBORI, T
    SAWAKI, Y
    SHONO, S
    KUMAGAI, A
    TRANSACTIONS OF THE JAPAN INSTITUTE OF METALS, 1976, 17 (01): : 1 - 10
  • [45] Localized bending fatigue behavior of high-strength steel monostrands
    Winkler, J.
    Fischer, G.
    Georgakis, C. T.
    BRIDGE MAINTENANCE, SAFETY, MANAGEMENT, RESILIENCE AND SUSTAINABILITY, 2012, : 3992 - 3999
  • [46] Microstructural influence on fatigue properties of a high-strength spring steel
    Lee, CS
    Lee, KA
    Li, DM
    Yoo, SJ
    Nam, WJ
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1998, 241 (1-2): : 30 - 37
  • [47] FATIGUE FRACTURE IN A HIGH-STRENGTH LOW-ALLOY STEEL
    THOMPSON, KR
    ARAKI, T
    UCHIYAMA, I
    JOURNAL OF THE IRON AND STEEL INSTITUTE, 1969, 207 : 1624 - +
  • [48] Fatigue crack propagation under corrosion of high-strength steel
    Malikova, Lucie
    Doubek, Pavel
    Juhaszova, Tereza
    Krejsa, Martin
    Seitl, Stanislav
    10TH INTERNATIONAL CONFERENCE ON MATERIALS STRUCTURE AND MICROMECHANICS OF FRACTURE, MSMF, 2023, 43 : 264 - 269
  • [49] HIGH-STRENGTH STEEL PROCESSING VARIABLES THAT AFFECT FATIGUE.
    Pengra, Jay J.
    Wald, George G.
    1978, 9 (02): : 1 - 7
  • [50] Gigacycle fatigue of high-strength steel caused by MnS inclusions
    Furuya, Yoshiyuki
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2021, 824 (824):