Comparison of standard two-dimensional and three-dimensional corrected glenoid version measurements

被引:121
|
作者
Budge, Matthew D. [1 ]
Lewis, Gregory S. [1 ]
Schaefer, Eric [2 ]
Coquia, Stephanie [3 ]
Flemming, Donald J. [3 ]
Armstrong, April D. [1 ]
机构
[1] Penn State Milton S Hershey Med Ctr, Dept Orthopaed Surg, Hershey, PA USA
[2] Penn State Milton S Hershey Med Ctr, Dept Publ Hlth Sci, Hershey, PA USA
[3] Penn State Milton S Hershey Med Ctr, Dept Radiol, Hershey, PA USA
关键词
Glenoid version; 3D reconstruction; total shoulder arthroplasty; glenoid component; placement; TOTAL SHOULDER ARTHROPLASTY; COMPUTED-TOMOGRAPHY SCANS; GLENOHUMERAL JOINT; RETROVERSION;
D O I
10.1016/j.jse.2010.11.003
中图分类号
R826.8 [整形外科学]; R782.2 [口腔颌面部整形外科学]; R726.2 [小儿整形外科学]; R62 [整形外科学(修复外科学)];
学科分类号
摘要
Hypothesis: There is concern regarding the accuracy of 2-dimensional (2D) computed tomography (CT) for measuring glenoid version. Three-dimensional (3D) CT scan reconstructions can properly orient the glenoid to the plane of the scapula and have been reported to accurately measure glenoid version in cadaver models. We hypothesized that glenoid version measured by correcting 2D CT scans to the plane of the scapula by 3D reconstruction would be significantly different compared with standard 2D CT scan measurement of the glenoid in a clinical patient population. Materials and methods: Thirty-four patients underwent dedicated axial 2D CT scan of the shoulder with 3D reconstruction. The 2D glenoid version was measured on unmodified midglenoid axial cuts, and the 3D glenoid version measurement was corrected to be perpendicular to the plane of the scapula and then measured in the axial plane. Three observers repeated each measurement on 2 different days. Results: The difference between the overall average 2D and 3D measurements was not statistically significant (P = .45). In individual scapulae, 35% of 2D measurements were 5 degrees to 10 degrees different and 12% were greater than 10 degrees different from their corresponding 3D-corrected CT measurement (P < .001 to P = .045). Reproducibility of both 2D and 3D-corrected measurements was good. Discussion: Although 2D and 3D corrected methods showed a high degree of both intraobserver and interobserver reliability in this series, axial 2D images without correction were 5 to 15 degrees different than their 3D-corrected counterparts in 47% of all measurements. Correcting 2D glenoid version by 3D reconstruction to the transverse plane perpendicular to the scapular body allows for an accurate assessment of glenoid version in spite of positioning differences and results in increased accuracy while maintaining high reliability. Conclusions: Owing to the variability in scapular position, the axial 2D CT scan measurement was significantly different from 3D-corrected measurement of glenoid version. Averaging the version measurements across patients did not reflect this finding. Level of evidence: Level III Retrospective Study of Non-Consecutive Patients. (C) 2011 Journal of Shoulder and Elbow Surgery Board of Trustees.
引用
收藏
页码:577 / 583
页数:7
相关论文
共 50 条
  • [1] Three-Dimensional Scapular Border Method for Glenoid Version Measurements
    Wilder, Lauren
    Simon, Peter
    Reyes, Justin
    Diaz, Miguel
    Munassi, Steven
    Frankle, Mark A.
    [J]. JBJS OPEN ACCESS, 2023, 8 (01)
  • [2] A Comparison Between the Accuracy of Two-Dimensional and Three-Dimensional Strain Measurements
    Desai, Niranjan
    Poling, Joel
    Fischer, Gregor
    Georgakis, Christos
    [J]. JOURNAL OF NONDESTRUCTIVE EVALUATION, DIAGNOSTICS AND PROGNOSTICS OF ENGINEERING SYSTEMS, 2018, 1 (02):
  • [3] A comparison of two-dimensional and three-dimensional measurements of wear in a laboratory investigation
    Rodriguez, Jose M.
    Bartlett, David W.
    [J]. DENTAL MATERIALS, 2010, 26 (10) : E221 - E225
  • [4] Computed Tomography Measurements as a Standard of Exophthalmos? Two-Dimensional Versus Three-Dimensional Techniques
    Guo, Jie
    Qian, Jiang
    Yuan, Yifei
    [J]. CURRENT EYE RESEARCH, 2018, 43 (05) : 647 - 653
  • [5] A comparison between the two-dimensional and three-dimensional lattices
    Dolocan, A
    Dolocan, VO
    Dolocan, V
    [J]. MODERN PHYSICS LETTERS B, 2004, 18 (25): : 1301 - 1309
  • [6] A comparison of two-dimensional radiography and three-dimensional computed tomography in angular cephalometric measurements
    Nalcaci, R.
    Ozturk, F.
    Sokucu, O.
    [J]. DENTOMAXILLOFACIAL RADIOLOGY, 2010, 39 (02) : 100 - 106
  • [7] Two-Dimensional Glenoid Version Measurements Vary with Coronal and Sagittal Scapular Rotation
    Bryce, Chris D.
    Davison, Andrew C.
    Lewis, Gregory S.
    Wang, Li
    Flemming, Donald J.
    Armstrong, April D.
    [J]. JOURNAL OF BONE AND JOINT SURGERY-AMERICAN VOLUME, 2010, 92A (03): : 692 - 699
  • [8] Comparison of three-dimensional and two-dimensional laparoscopic video systems
    McDougall, EM
    Soble, JJ
    Wolf, JS
    Nakada, SY
    Elashry, OM
    Clayman, RV
    [J]. JOURNAL OF ENDOUROLOGY, 1996, 10 (04) : 371 - 374
  • [9] A comparison of three-dimensional and two-dimensional analyses of facial motion
    Gross, MM
    Trotman, CA
    Moffatt, KS
    [J]. ANGLE ORTHODONTIST, 1996, 66 (03) : 189 - 194
  • [10] Comparison Between Two-Dimensional and Three-Dimensional Dynamic Stall
    Kaufmann, K.
    Gardner, A. D.
    Costes, M.
    [J]. NEW RESULTS IN NUMERICAL AND EXPERIMENTAL FLUID MECHANICS X, 2016, 132 : 315 - 325