Effect of pulse Nd-YAG laser beam interaction on annealing of nanopowder ITO using spin-on-glass

被引：10

作者：

Amoli, H. Salar ^{[1
]}

Fathi, B. ^{[1
]}

机构：

[1] Iranian Res Org Sci & Technol, Fac Chem Ind, Tehran, Iran

来源：

JOURNAL OF SOL-GEL SCIENCE AND TECHNOLOGY | 2011年 / 59卷 / 01期

关键词：

Nanopowder ITO; Pulse Nd-YAG laser; Spin coating; Glass; Annealing; INDIUM-TIN-OXIDE; THIN-FILM; OPTICAL-PROPERTIES; DEPOSITION; BOTTOM;

D O I：

10.1007/s10971-011-2457-0

中图分类号：

TQ174 [陶瓷工业]; TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

The effect of pulse Nd-YAG laser on structural and electrical properties of ITO thin film on glass by spin coating process was evaluated. It was found that the beam interaction of pulse laser energy has a significant effect on crystallization, conductivity and optical properties of ITO. Laser irradiation with a wavelength of 1,064 nm and energy of 8-40 J are employed. The conventional X-Ray diffraction studies show the peak intensities of (211), (222), and (440) planes increased by using Nd-YAG laser treatment and prove the crystallization of ITO nanoparticle. Due to absorption of millisecond pulse laser, the resistivity of ITO coating on glass substrate which was annealed at 350 A degrees C, reduced by a factor of 100, and a resistance of less than 0.6 ka"broken vertical bar has been achieved.

引用

页码：32 / 35

页数：4

共 46 条

[21] Nd-YAG laser machining of SiC fibre borosilicate glass composites. Part II. The effect of process variables
Tuersley, IP
Hoult, TP
Pashby, IR
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 1998, 29 (08) : 955 - 964
[22] The processing of a magnesium-alumino-silicate matrix, SiC fibre glass-ceramic matrix composite using a pulsed Nd-YAG laser .1. Optimization of pulse parameters
Tuersley, IP
Hoult, AP
Pashby, IR
JOURNAL OF MATERIALS SCIENCE, 1996, 31 (15) : 4111 - 4119
[23] Film analysis employing subtarget effect using 355 nm Nd-YAG laser-induced plasma at low pressure
Hedwig, Rinda
Budi, Wahyu Setia
Abdulmadjid, Syahrun Nur
Pardede, Marincan
Suliyanti, Maria Margaretha
Lie, Tjung He
Kurniawan, Davy Putra
Kurniawan, Koo Hendrik
Kagawa, Kiichiro
Tjia, May On
SPECTROCHIMICA ACTA PART B-ATOMIC SPECTROSCOPY, 2006, 61 (12) : 1285 - 1293
[24] The processing of SiC/SiC ceramic matrix composites using a pulsed Nd-YAG laser: Part II The effect of process variables
I. P. Tuersley
T. P. Hoult
I. R. Pashby
Journal of Materials Science, 1998, 33 : 963 - 967
[25] The processing of SiC SiC ceramic matrix composites using a pulsed Nd-YAG laser Part II The effect of process variables
Tuersley, IP
Hoult, TP
Pashby, IR
JOURNAL OF MATERIALS SCIENCE, 1998, 33 (04) : 963 - 967
[26] TRANSURETHRAL EVAPORATION OF PROSTATE (TUEP) WITH ND-YAG LASER USING A CONTACT FREE BEAM TECHNIQUE - RESULTS IN 61 PATIENTS WITH BENIGN PROSTATIC HYPERPLASIA
NARAYAN, P
FOURNIER, G
INDUDHARA, R
LEIDICH, R
SHINOHARA, K
INGERMAN, A
UROLOGY, 1994, 43 (06) : 813 - 820
[27] Investigation on the effect of ambient and beam profile in annealing and texturing of amorphous silicon thin films by pulsed Nd3+:YAG laser
Vidhya, Y. Esther Blesso
Vasa, Nilesh J.
Sriram, R.
LASER-BASED MICRO- AND NANOPROCESSING IX, 2015, 9351
[28] Annealing and texturing of a-Si film using Nd3+:YAG laser with Gaussian and flat-top beam profiles
Palani, I. A.
Rajiv, G.
Vasa, N. J.
Singaperumal, M.
TENCON 2010: 2010 IEEE REGION 10 CONFERENCE, 2010, : 1909 - 1914
[29] 1-PPS 2-MU-SEC PULSE HIGH-ENERGY FREQUENCY-DOUBLED ND-YAG GLASS-LASER FOR STUDYING COMBUSTION PROCESSES
BRANNON, PJ
FRANKLIN, FR
JONES, ED
APPLIED OPTICS, 1982, 21 (10): : 1758 - 1763
[30] Characterization of Ni-P Amorphous Phase Formation in an Ni-Al Alloyed Layer Produced Using a Pulsed Nd-YAG Laser Beam
Yang, Y.
Hu, J-D.
LASERS IN ENGINEERING, 2014, 29 (3-4) : 189 - 195

← 1 2 3 4 5 →