Mode selection for electrostatic beam resonators based on motional resistance and quality factor

被引:0
|
作者
Ryou, Jeong Hoon [1 ,2 ]
Gorman, Jason J. [1 ]
机构
[1] NIST, 100 Bur Dr,Stop 8212, Gaithersburg, MD 20899 USA
[2] Univ Michigan, Dept Mech Engn, GG Brown Lab, 2350 Hayward, Ann Arbor, MI 48109 USA
关键词
DISSIPATION;
D O I
10.1063/1.4971249
中图分类号
O59 [应用物理学];
学科分类号
摘要
An analytical comparison between the fundamental mode and higher modes of vibration for an electrostatic beam resonator is presented. Multiple mode numbers can be matched to a desired resonance frequency through appropriate scaling. Therefore, it is important to determine which mode yields the best performance. A dynamic model of the resonator is derived and then used to determine the motional resistance for each mode. The resulting equation provides the basis for comparing performance between modes using motional resistance and quality factor. As a demonstration of the approach, a quality factor model that has been previously validated experimentally is introduced. Numerical results for silicon resonators indicate that the fundamental mode can provide a lower motional resistance and higher quality factor when the resonators under comparison have the same aspect ratio or the same stiffness.
引用
收藏
页数:8
相关论文
共 50 条
  • [1] Mode selection for electrostatic beam resonators based on motional resistance and quality factor
    [J]. Gorman, Jason J. (gorman@nist.gov), 1600, American Institute of Physics Inc. (120):
  • [2] Impact of Mode Localization on the Motional Resistance of Coupled MEMS Resonators
    Erbes, Andreja
    Thiruvenkatanathan, Pradyumna
    Seshia, Ashwin A.
    [J]. 2012 IEEE INTERNATIONAL FREQUENCY CONTROL SYMPOSIUM (FCS), 2012,
  • [3] On the quality of quality-factor in gap-closing electrostatic resonators
    Shmulevich, Shai
    Lerman, Michael
    Elata, David
    [J]. JOURNAL OF MICROMECHANICS AND MICROENGINEERING, 2013, 23 (11)
  • [4] High Quality Factor and Low Motional Impedance Aluminum Nitride Tuning Fork Resonators Vibrating in In-Plane Flexural Mode
    Yuan, Yi
    Yang, Qingrui
    Li, Haolin
    Shi, Shuai
    Niu, Pengfei
    Sun, Chonglin
    Li, Quanning
    Zhang, Menglun
    Pang, Wei
    [J]. IEEE ELECTRON DEVICE LETTERS, 2022, 43 (10) : 1744 - 1747
  • [5] Mode quality factor based on far-field emission for square resonators
    Guo, WH
    Huang, YZ
    Lu, QY
    Yu, L
    [J]. IEEE PHOTONICS TECHNOLOGY LETTERS, 2004, 16 (02) : 479 - 481
  • [6] An electrostatic quality factor control for surface-micromachined lateral resonators
    Lee, KB
    Cho, YH
    [J]. MHS '96 - PROCEEDINGS OF THE SEVENTH INTERNATIONAL SYMPOSIUM ON MICRO MACHINE AND HUMAN SCIENCE: TOWARD MICRO-MECHATRONICS IN 21ST CENTURY, 1996, : 143 - 147
  • [7] MEASURES OF QUALITY-FACTOR IN GAP-CLOSING ELECTROSTATIC RESONATORS
    Shmulevich, S.
    Lerman, M.
    Elata, D.
    [J]. 26TH IEEE INTERNATIONAL CONFERENCE ON MICRO ELECTRO MECHANICAL SYSTEMS (MEMS 2013), 2013, : 417 - 420
  • [8] Limits of quality factor in bulk-mode micromechanical resonators
    Chandorkar, S. A.
    Agarwal, M.
    Melamud, R.
    Candler, R. N.
    Goodson, K. E.
    Kenny, T. W.
    [J]. MEMS 2008: 21ST IEEE INTERNATIONAL CONFERENCE ON MICRO ELECTRO MECHANICAL SYSTEMS, TECHNICAL DIGEST, 2008, : 74 - 77
  • [9] Quality factor in trench-refilled polysilicon beam resonators
    Abdolvand, Reza
    Johari, Houri
    Ho, Gavin K.
    Erbil, Ahmet
    Ayazi, Farrokh
    [J]. JOURNAL OF MICROELECTROMECHANICAL SYSTEMS, 2006, 15 (03) : 471 - 478
  • [10] Modeling and measuring the quality factor of whispering gallery mode resonators
    Savchenkov, Anatoliy A.
    Borri, Simone
    de Cumis, Mario Siciliani
    Matsko, Andrey B.
    De Natale, Paolo
    Maleki, Lute
    [J]. APPLIED PHYSICS B-LASERS AND OPTICS, 2018, 124 (09):