Mode selection for electrostatic beam resonators based on motional resistance and quality factor

被引:0
|
作者
Ryou, Jeong Hoon [1 ,2 ]
Gorman, Jason J. [1 ]
机构
[1] NIST, 100 Bur Dr,Stop 8212, Gaithersburg, MD 20899 USA
[2] Univ Michigan, Dept Mech Engn, GG Brown Lab, 2350 Hayward, Ann Arbor, MI 48109 USA
关键词
DISSIPATION;
D O I
10.1063/1.4971249
中图分类号
O59 [应用物理学];
学科分类号
摘要
An analytical comparison between the fundamental mode and higher modes of vibration for an electrostatic beam resonator is presented. Multiple mode numbers can be matched to a desired resonance frequency through appropriate scaling. Therefore, it is important to determine which mode yields the best performance. A dynamic model of the resonator is derived and then used to determine the motional resistance for each mode. The resulting equation provides the basis for comparing performance between modes using motional resistance and quality factor. As a demonstration of the approach, a quality factor model that has been previously validated experimentally is introduced. Numerical results for silicon resonators indicate that the fundamental mode can provide a lower motional resistance and higher quality factor when the resonators under comparison have the same aspect ratio or the same stiffness.
引用
收藏
页数:8
相关论文
共 50 条
  • [41] Impact Factor Analysis in the Selection of Shopping Mode Based on ISM and AHP
    Wu, Chun
    [J]. 2016 2ND INTERNATIONAL CONFERENCE ON MODERN EDUCATION AND SOCIAL SCIENCE (MESS 2016), 2016, : 1010 - 1018
  • [42] Theoretical calculation of beam quality factor of large-mode-area fiber amplifiers
    Liao, S.
    Gong, M.
    Zhang, H.
    [J]. LASER PHYSICS, 2009, 19 (03) : 437 - 444
  • [43] Quality factor and vibration amplitude based viscosity measurements using suspended microchannel resonators
    Lee, Il
    Lee, Jungchul
    [J]. 2012 IEEE SENSORS PROCEEDINGS, 2012, : 299 - 302
  • [44] Accuracy Analysis of Quality Factor Measurement Based on Time Domain Method for MEMS Resonators
    Wang Lingyun
    Du Xiaohui
    Su Yuanzhe
    He Jie
    Li Yipan
    Wu Dezhi
    Sun Daoheng
    [J]. MICRO-NANO TECHNOLOGY XV, 2014, 609-610 : 1131 - 1137
  • [45] THE IMPACT OF BOTTOM ELECTRODE COVERAGE RATE ON ELECTROMECHANICAL COUPLING AND QUALITY FACTOR OF ALN MEMS CONTOUR MODE RESONATORS
    Jung, Soon In
    Piazza, Gianluca
    Kim, Hoe Joon
    [J]. 2019 20TH INTERNATIONAL CONFERENCE ON SOLID-STATE SENSORS, ACTUATORS AND MICROSYSTEMS & EUROSENSORS XXXIII (TRANSDUCERS & EUROSENSORS XXXIII), 2019, : 917 - 920
  • [46] Planar ring-shaped phononic crystal anchoring boundaries for enhancing the quality factor of Lamb mode resonators
    Binci, L.
    Tu, C.
    Zhu, H.
    Lee, J. E-Y
    [J]. APPLIED PHYSICS LETTERS, 2016, 109 (20)
  • [47] Design and modeling of a MEMS accelerometer based on couple d mode-localize d nonlinear resonators under electrostatic actuation
    Lyu, Ming
    Zhao, Jian
    Kacem, Najib
    Tang, Bin
    Liu, Pengbo
    Song, Jiahao
    Zhong, Heng
    Huang, Yu
    [J]. COMMUNICATIONS IN NONLINEAR SCIENCE AND NUMERICAL SIMULATION, 2021, 103
  • [48] Beam-quality factor of single-mode gain-guided fiber lasers
    Gundu, Krishna Mohan
    Yarandi, Parisa Gandomkar
    Mafi, Arash
    [J]. OPTICS LETTERS, 2010, 35 (24) : 4124 - 4126
  • [49] Influence of fundamental mode fill factor on disk laser output power and laser beam quality
    Cheng, Zhiyong
    Yang, Zhuo
    Shao, Xichun
    Li, Wei
    Zhu, Mengzhen
    [J]. LIDAR IMAGING DETECTION AND TARGET RECOGNITION 2017, 2017, 10605
  • [50] Selection rule for cavity configurations to generate cylindrical vector beams with low beam quality factor
    Chuang, Chih-Hsiang
    Ho, Chen-Yu
    Hsiao, Yu-Chi
    Chiu, Chi-Pin
    Wei, Ming-Dar
    [J]. OPTICS EXPRESS, 2021, 29 (04) : 5043 - 5054