ULTRASONIC NONDESTRUCTIVE EVALUATION OF STRESS CORROSION CRACK IN WELDED STEEL PLATE

被引：0

作者：

Ma, Zhaoyun ^{[1
]}

Yu, Lingyu ^{[1
]}

Lam, Poh-Sang ^{[2
]}

Sindelar, Robert L. ^{[2
]}

Duncan, Andrew J. ^{[2
]}

Thanh-Tam Truong ^{[2
]}

Chao, Yuh J. ^{[1
]}

机构：

[1] Univ South Carolina, Columbia, SC 29208 USA

[2] Savannah River Natl Lab, Aiken, SC USA

来源：

PROCEEDINGS OF THE ASME 2020 PRESSURE VESSELS & PIPING CONFERENCE (PVP2020), VOL 6 | 2020年

关键词：

ultrasonic waves; welded steel plate; stress corrosion cracking; wavefield imaging; high level nuclear waste tanks; SCANNING LASER VIBROMETRY; DELAMINATION DETECTION; LAMB WAVES; DAMAGE; QUANTIFICATION;

D O I：

暂无

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

Stress corrosion cracking (SCC) has been observed in the high-level nuclear waste tanks that were constructed by welding carbon steel plates. This paper aims to establish an ultrasonic inspection system and its fundamental ability for SCC inspection and quantification on thick welded steel plates. A welded steel plate was fabricated without heat treatment by joining two carbon steel plates through gas metal arc welding (GMAW) procedure. SCC growth, which was initiated with starter cracks across the weld, were observed in a few weeks after submerging the plate in 5 molar (5M) sodium nitrate (NaNO3) solution at about 90 degrees C. The SCC is inspected with an ultrasonic guided wave system, which employs a piezoelectric transducer for guided wave actuation and a scanning laser Doppler vibrometer (SLDV) for wavefield sensing. The measured wavefield can immediately show wave interactions with the crack. Wavefield images are further generated for the crack length quantification. To demonstrate the crack sizing capability of using the piezoelectric transducer and SLDV, the previous results from the magnetic particle test (MT) are compared. Reasonable agreement in crack length measurement is obtained with the ultrasonic test imaging technique.

引用

页数：5

共 50 条

[31] PREDICTION OF STRESS CORROSION CRACK PROPAGATION BEHAVIOR IN RESIDUAL STRESS FIELD OF TYPE 304 STAINLESS STEEL WELDED JOINT.
Mukai, Yoshihiko
Murata, Masato
1600, (14):
[32] Current around a Crack in an Aluminum Plate under Nondestructive Evaluation Inspection
Lopes Ribeiro, A.
Geirinhas Ramos, H.
Jeronimo Pasadas, D.
Jorge Rocha, T.
2012 IEEE INTERNATIONAL INSTRUMENTATION AND MEASUREMENT TECHNOLOGY CONFERENCE (I2MTC), 2012, : 1635 - 1639
[33] Ultrasonic phased array transducers for nondestructive evaluation of steel structures
Song, SJ
Shin, HJ
Jang, YH
REVIEW OF PROGRESS IN QUANTITATIVE NONDESTRUCTIVE EVALUATION, VOLS 19A AND 19B, 2000, 509 : 1079 - 1086
[34] INFLUENCE OF STRESS CORROSION CRACK MORPHOLOGY ON ULTRASONIC EXAMINATION PERFORMANCES
Dupond, O.
Duwig, V.
Fouquet, T.
REVIEW OF PROGRESS IN QUANTITATIVE NONDESTRUCTIVE EVALUATION, VOLS 28A AND 28B, 2009, 1096 : 89 - +
[35] Ultrasonic stress evaluation on welded plates with Lcr wave
Lu, H.
Liu, X. S.
Yang, J. G.
Zhang, S. P.
Fang, H. Y.
SCIENCE AND TECHNOLOGY OF WELDING AND JOINING, 2008, 13 (01) : 70 - 74
[36] Evaluation of cold crack susceptibility on HSLA steel welded joints
Silverio-Freire, RC
Moura-Maciel, T
da Silva, PG
REVISTA DE METALURGIA, 2003, 39 (02) : 83 - 89
[37] STRESS CORROSION CRACKING OF WELDED AUSTENITIC STAINLESS STEEL.
Gooch, T.G.
Welding in the World, Le Soudage Dans Le Monde, 1984, 22 (3-4): : 64 - 77
[38] Stress corrosion cracking behaviors of weathering steel welded joints
Gong, Lihua, 2018, NACE International (57)
[39] Stress Corrosion Cracking Behaviour of Welded Duplex Stainless Steel
Khoshnaw, Fuad Mohamed
Rahmatalla, Hussein Bakir
THERMEC 2009 SUPPLEMENT: 6TH INTERNATIONAL CONFERENCE ON PROCESSING & MANUFACTURING OF ADVANCED MATERIALS, 2010, 89-91 : 709 - +
[40] Stress Corrosion Cracking Behaviors of Weathering Steel Welded Joints
Gong, Lihua
MATERIALS PERFORMANCE, 2018, 57 (12) : 46 - 49

← 1 2 3 4 5 →