Superplasticity of fine-grained Mg-10Li alloy prepared by severe plastic deformation and understanding its deformation mechanisms

被引:5
|
作者
Jeong, H. T. [1 ]
Lee, S. W. [1 ]
Kim, W. J. [1 ]
机构
[1] Hongik Univ, Dept Mat Sci & Engn, Sangsu Dong 72-1, Seoul 121791, South Korea
关键词
Magnesium-lithium alloy; Superplasticity; Severe plastic deformation; Grain size; Grain growth; LOW-TEMPERATURE SUPERPLASTICITY; MG-LI ALLOYS; ELEVATED-TEMPERATURE; PHASE-TRANSFORMATION; AL; BEHAVIOR; MAPS; MICROSTRUCTURE; DIFFUSION; CREEP;
D O I
10.1016/j.jma.2024.01.001
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
The superplastic behavior and associated deformation mechanisms of a fine-grained Mg -10.1 Li-0.8Al-0.6Zn alloy (LAZ1011) with a grain size of 3.2 mu m, primarily composed of the BCC )5 phase and a small amount of the HCP alpha phase, were examined in a temperature range of 473 K to 623 K. The microstructural refinement of this alloy was achieved by employing high -ratio differential speed rolling. The best superplasticity was achieved at 523 K and at strain rates of 10-4 -5 x 10-4 s-1, where tensile elongations of 550-600% were obtained. During the heating and holding stage of the tensile samples prior to tensile loading, a significant increase in grain size was observed at temperatures above 573 K. Therefore, it was important to consider this effect when analyzing and understanding the superplastic deformation behavior and mechanisms. In the investigated strain rate range, the superplastic flow at low strain rates was governed by lattice diffusion-controlled grain boundary sliding, while at high strain rates, lattice diffusion-controlled dislocation climb creep was the rate-controlling deformation mechanism. It was concluded that solute drag creep is unlikely to occur. During the late stages of deformation at 523 K, it was observed that grain boundary sliding led to the agglomeration of the alpha phase, resulting in significant strain hardening. Deformation mechanism maps were constructed for )5 -Mg -Li alloys in the form of 2D and 3D formats as a function of strain rate, stress, temperature, and grain size, using the constitutive equations for various deformation mechanisms derived based on the data of the current tests. (c) 2024 Chongqing University. Publishing services provided by Elsevier B.V. on behalf of KeAi Communications Co. Ltd. This is an open access article under the CC BY-NC-ND license ( http://creativecommons.org/licenses/by-nc-nd/4.0/ ) Peer review under responsibility of Chongqing University
引用
收藏
页码:316 / 331
页数:16
相关论文
共 50 条
  • [1] Superplasticity of fine-grained Mg-10Li alloy prepared by severe plastic deformation and understanding its deformation mechanisms
    H.T.Jeong
    S.W.Lee
    W.J.Kim
    Journal of Magnesium and Alloys, 2024, 12 (01) : 316 - 331
  • [2] Superplastic deformation mechanisms of a fine-grained Al-Cu-Li alloy
    Liu, Xiaodong
    Ye, Lingying
    Tang, Jianguo
    Ke, Bin
    Dong, Yu
    Chen, Xiaojiao
    Gu, Yi
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2022, 848
  • [3] Ultra fine-grained metals prepared by severe plastic deformation:: A positron annihilation study
    Cizek, J
    Procházka, I
    Kuzel, R
    Matej, Z
    Cherkaska, V
    Cieslar, M
    Smola, B
    Stulíková, I
    Brauer, G
    Anwand, W
    Islamgaliev, RK
    Kulyasova, O
    ACTA PHYSICA POLONICA A, 2005, 107 (05) : 745 - 752
  • [4] Ultra fine grained Ti prepared by severe plastic deformation
    Lukac, F.
    Cizek, J.
    Knapp, J.
    Prochazka, I.
    Zhanal, P.
    Islamgaliev, R. K.
    INTERNATIONAL WORKSHOP ON POSITRON STUDIES OF DEFECTS 2014, 2016, 674
  • [5] Superplasticity of fine-grained 7475 Al alloy and a proposed new deformation mechanism
    Shin, DH
    Lee, CS
    Kim, WJ
    ACTA MATERIALIA, 1997, 45 (12) : 5195 - 5202
  • [6] Development of superplasticity in an Al–Mg alloy through severe plastic deformation
    V. Jaya Prasad
    N. Mohanarao
    S. Kamaluddin
    S. S. Bhattacharya
    The International Journal of Advanced Manufacturing Technology, 2018, 94 : 2973 - 2979
  • [7] Synthesis of fine grained magnesium alloy by severe plastic deformation
    Su, C.W., 2005, Institute of Metals and Materials Australasia (29):
  • [8] Development of superplasticity in an Al–Mg alloy through severe plastic deformation
    Prasad, V. Jaya (Prasad.vjp@gmail.com), 1600, Springer London (94): : 5 - 8
  • [9] Plastic deformation behaviour of fine-grained materials
    Kim, HS
    Estrin, Y
    Bush, MB
    ACTA MATERIALIA, 2000, 48 (02) : 493 - 504
  • [10] PLASTIC DEFORMATION IN FINE-GRAINED ALUMINUM OXIDE
    HEUER, AH
    CANNON, RM
    MOSCHETT.A
    AMERICAN CERAMIC SOCIETY BULLETIN, 1967, 46 (09): : 882 - &