Microstructural evolution and growth kinetics of thermally grown oxides in plasma sprayed thermal barrier coatings

被引:1
|
作者
Xiaoju Liu [1 ]
Teng Wang [1 ]
Caicai Li [1 ]
Zhenhuan Zheng [1 ]
Qiang Li [1 ]
机构
[1] School of Materials Science and Engineering, Fuzhou University
基金
中国国家自然科学基金;
关键词
Thermal barrier coatings(TBCs); Air plasma spraying(APS); CoNiCrAlY; YSZ ceramic coat; Isothermal oxidation; Oxidation rate;
D O I
暂无
中图分类号
TQ174.758.16 [];
学科分类号
080503 ;
摘要
The formation of thermally grown oxide(TGO) during high temperature is a key factor to the degradation of thermal barrier coatings(TBCs)applied on hot section components. In the present study both the Co Ni Cr Al Y bond coat and Zr O-8 wt.% YO(8YSZ) ceramic coat of TBCs were prepared by air plasma spraying(APS). The composition and microstructure of TGO in TBCs were investigated using scanning electron microscopy(SEM), energy dispersive spectroscopy(EDS) and X-ray diffraction(XRD) analysis. The growth rate of TGO for TBC and pure BC were gained after isothermal oxidation at 1100 °C for various times. The results showed that as-sprayed bond coat consisted of β and γ/γ’phases,β phase reducesd as the oxidation time increased. The TGO comprised α-AlOformed in the first 2 h. Co O, Ni O, CrOand spinel oxides appeared after 20 h of oxidation. Contents of Co O and Ni O reduced while that of CrOand spinel oxides increased in the later oxidation stage.The TGO eventually consisted of a sub-Al2O3 layer with columnar microstructure and the upper porous CS clusters. The TGO growth kinetics for two kinds of samples followed parabolic laws, with oxidation rate constant of 0.344 μm/hfor TBCs and 0.354 μm/h0.5for pure BCs.
引用
收藏
页码:103 / 111
页数:9
相关论文
共 50 条
  • [31] Temperature dependent dynamic growth of thermally grown oxide in thermal barrier coatings
    Lim, L. Y.
    Meguid, S. A.
    MATERIALS & DESIGN, 2019, 164
  • [32] Morphological and microstructural characterization of laser-glazed plasma-sprayed thermal barrier coatings
    Batista, C
    Portinha, A
    Ribeiro, RM
    Teixeira, V
    Costa, MF
    Oliveira, CR
    SURFACE & COATINGS TECHNOLOGY, 2006, 200 (09): : 2929 - 2937
  • [33] A comparative study of the optical and microstructural properties of suspension and atmospheric plasma sprayed thermal barrier coatings
    Blanchard, F.
    Baloukas, B.
    Azzi, M.
    Ben Ettouil, F.
    Klemberg-Sapieha, J. E.
    Moreau, C.
    Martinu, L.
    SURFACE & COATINGS TECHNOLOGY, 2022, 449
  • [34] Thermally grown oxide growth behavior and spallation lives of solution precursor plasma spray thermal barrier coatings
    Wu, F.
    Jordan, E. H.
    Ma, X.
    Gell, M.
    SURFACE & COATINGS TECHNOLOGY, 2008, 202 (09): : 1628 - 1635
  • [35] Evolution of Young's modulus of air plasma sprayed yttria-stabilized zirconia in thermally cycled thermal barrier coatings
    Tang, F
    Schoenung, JM
    SCRIPTA MATERIALIA, 2006, 54 (09) : 1587 - 1592
  • [36] Role of thermally grown oxide and oxidation resistance of samarium strontium aluminate based air plasma sprayed ceramic thermal barrier coatings
    Baskaran, T.
    Arya, Shashi Bhushan
    SURFACE & COATINGS TECHNOLOGY, 2017, 326 : 299 - 309
  • [37] Ceramic impregnation of plasma sprayed thermal barrier coatings
    Kathikeyan, J
    Berndt, CC
    Ristorucci, A
    Herman, H
    THERMAL SPRAY: PRACTICAL SOLUTIONS FOR ENGINEERING PROBLEMS, 1996, : 477 - 482
  • [38] Microcrack formation in plasma sprayed thermal barrier coatings
    Basu, SN
    Ye, G
    Gevelber, M
    Wroblewski, D
    INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS, 2005, 23 (4-6): : 335 - 343
  • [39] Fracture behaviour of plasma sprayed thermal barrier coatings
    Malzbender, J
    Wakui, T
    Wessel, E
    Steinbrech, RW
    ACTIVE MATERIALS, NANOSCALE MATERIALS, COMPOSITES, GLASS AND FUNDAMENTALS, 2005, 14 : 421 - 435
  • [40] ON THE DEVELOPMENT OF PLASMA-SPRAYED THERMAL BARRIER COATINGS
    SIVAKUMAR, R
    SRIVASTAVA, MP
    OXIDATION OF METALS, 1983, 20 (3-4): : 67 - 73