Effect of RE on molybdenum partitioning and resultant mechanical and microstructural behavior of a duplex stainless steel during hot working condition

被引:0
|
作者
陈雷 [1 ,2 ]
马筱聪 [2 ]
王明家 [3 ]
薛红燕 [1 ,2 ]
机构
[1] National Engineering Research Center for Equipment and Technology of Cold Strip Rolling,Yanshan University
[2] School of Mechanical Engineering, Yanshan University
[3] State Key Laboratory of Metastable Materials Science and Technology, Yanshan University
基金
中国国家自然科学基金;
关键词
duplex stainless steel; rare earths; partitioning; hot working;
D O I
暂无
中图分类号
TG142.71 [不锈钢、耐酸钢];
学科分类号
080502 ;
摘要
The effect of rare earth(RE) on Mo partitioning and resultant mechanical and microstructural behavior of a duplex stainless steel during hot working condition was investigated. It was found that RE effect was sensitive to temperature. At the high temperature, the development of dynamic recovery(DRV) in α phase was slowed down while the dynamic recrystallization(DRX) process in γ phase was accelerated by RE, whereby both work hardening rate(at low strain) and dynamic softening rate(at high strain) increased and moreover, the discrepancy on the hardness of the both phase reduced. Whereas at the low temperature, the effect of RE was opposite as compared with those in the high temperature. Mo partitioning analysis by EPMA indicated that RE enhanced the partitioning of Mo in α phase while reduced Mo concentration in γ phase at higher temperature whereby the mismatch between two phases could be improved indicated by the elimination of voids and cracks at α/γ interface, but it was contrary to that at the low temperature. Mo partitioning was believed to be an important cause for the RE effect on the differences of mechanical and microstructural behavior. Also this result provided a reasonable evidence for micro-alloying of RE in DSSs.
引用
下载
收藏
页码:107 / 112
页数:6
相关论文
共 50 条
  • [41] Experimental investigation and micromechanical modeling of load partitioning behavior of duplex stainless steel 2205 during cyclic hardening
    Xie, Xue-fang
    Dong, Zhilong
    Li, Shaohua
    Wan, Yu
    MATERIALS TODAY COMMUNICATIONS, 2023, 35
  • [42] Microstructural evolution during mechanical alloying and hot pressing of a powder blend of aluminium and 316 stainless steel
    Samanta, A.
    Chattopadhyay, P. P.
    Lojkowski, W.
    Gierlotka, S.
    Fecht, H. -J.
    Manna, I.
    HIGH PRESSURE TECHNOLOGY OF NANOMATERIALS, 2006, 114 : 211 - 218
  • [43] Effect of filler metal composition on microstructural and mechanical characterization of dissimilar welded joint of nitronic steel and super duplex stainless steel
    Maurya, Anup Kumar
    Pandey, Chandan
    Chhibber, Rahul
    ARCHIVES OF CIVIL AND MECHANICAL ENGINEERING, 2022, 22 (02)
  • [44] Microstructural Evolution and Flow Analysis during Hot Working of a Fe-Ni-Cr Superaustenitic Stainless Steel
    Amir Momeni
    Kamran Dehghani
    Metallurgical and Materials Transactions A, 2011, 42 : 1925 - 1932
  • [45] Effect of process parameters in microstructural and mechanical properties of Nd: YAG laser welded super duplex stainless steel
    Saravanan, S.
    Sivagurumanikandan, N.
    Raghukandan, K.
    MATERIALS TODAY-PROCEEDINGS, 2021, 39 : 1248 - 1253
  • [46] Microstructural Evolution and Flow Analysis during Hot Working of a Fe-Ni-Cr Superaustenitic Stainless Steel
    Momeni, Amir
    Dehghani, Kamran
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2011, 42A (07): : 1925 - 1932
  • [47] Hot working behavior of 2205 austenite-ferrite duplex stainless steel characterized by constitutive equations and processing maps
    Momeni, A.
    Dehghani, K.
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2011, 528 (03): : 1448 - 1454
  • [48] Micromechanics Based Modeling of Effect of Sigma Phase on Mechanical and Failure Behavior of Duplex Stainless Steel
    C. Meena
    V. Uthaisangsuk
    Metallurgical and Materials Transactions A, 2021, 52 : 1293 - 1313
  • [49] Micromechanics Based Modeling of Effect of Sigma Phase on Mechanical and Failure Behavior of Duplex Stainless Steel
    Meena, C.
    Uthaisangsuk, V.
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2021, 52 (04): : 1293 - 1313
  • [50] Hot working behavior of duplex stainless steel UNS S32750 characterized by constitutive equations and processing maps
    Zhao, Xin
    Chen, Langji
    INTERNATIONAL SYMPOSIUM ON MATERIALS APPLICATION AND ENGINEERING (SMAE 2016), 2016, 67