Research on High-Strength Economic Support Technology for Soft Rock Roadway with Roof Drenching under Thin Bedrock Irregular Surface

被引:1
|
作者
Wang, Junfeng [1 ,2 ]
Tai, Lianhai [3 ,4 ]
Li, Chong [3 ,4 ]
Qu, Qundi [3 ,4 ]
Yu, Xiaoxiao [3 ,4 ]
Liu, Yitao [3 ,5 ]
Yao, Wei [2 ]
机构
[1] Inner Mongolia Univ Sci & Technol, Coll Min & Coal, Baotou 014017, Peoples R China
[2] Ordos City Jintong Min Ind Co Ltd, Ordos 017000, Peoples R China
[3] China Univ Min & Technol, Sch Mines, Xuzhou 221116, Peoples R China
[4] China Univ Min & Technol, MOE Key Lab Deep Coal Resource Min, Xuzhou 221116, Peoples R China
[5] Uxin Banner Mengda Min Ind Co Ltd, Ordos 017399, Peoples R China
来源
APPLIED SCIENCES-BASEL | 2024年 / 14卷 / 20期
基金
中国国家自然科学基金;
关键词
nondestructive immersion test; mechanical properties; multistage bearing structure; anchor cable truss; zoning control; MECHANICAL-PROPERTIES; CRACK-PROPAGATION; FAILURE-MECHANISM; WATER INTRUSION; SENSITIVITY; MOISTURE;
D O I
10.3390/app14209428
中图分类号
O6 [化学];
学科分类号
0703 ;
摘要
The control of soft surrounding rock stability has always been a hot academic issue. Soft rock has poor stability and low strength, and the deformation of a soft rock tunnel becomes more serious after it is affected by water for a long time. In this paper, the Jintong Coal Mine is taken as the research object, and nondestructive immersion experiments are used to study the change in mechanical properties of rock after being affected by water. The FLAC numerical model is used to analyze the stress evolution characteristics of the surrounding rock after being affected by water, and the results of the study show that the water absorption of siltstone is always higher than that of coarse-grained sandstone, and the uniaxial compressive strength of siltstone and coarse-grained sandstone decreases by 54.59% and 67.99%, respectively, under a state of saturated water compared with that under a state of dryness. Influenced by a T-shaped surface, the maximum principal stress concentration area occurs in the rock layer below the T-shaped surface and outside the joint. Concentrations of maximum shear stress occur within the "T" channel. Vertical stress concentration zones occur at the higher ground level and the bottom of the slope. The maximum shear stress of the roof fluctuates before the face reaches the surface of the "1" section, and continues to increase with and continues to increase with the distance of the face. After entering below the surface of the "1" section, the maximum shear stress of the roof increases rapidly, and the influence range is about 24 m. The maximum shear stress distribution plays a dominant role in the stability of the surrounding rocks of the two roadways. We analyze the principle of high-strength economic support, propose a "four-in-one" surrounding rock control technology based on "controlled hydrophobicity, structural adjustment, district management, and gradient control", and propose a surrounding rock control scheme of district management. The measured data on site show that the roadway surrounding the rock is reasonably controlled. This provides a reference for the stable control of the surrounding rock of the roadway under similar conditions.
引用
收藏
页数:21
相关论文
共 47 条
  • [41] Research and development of fully enclosed wire-shell support structure technology for deep soft rock roadway based on TRIZ theory
    Weijing Yao
    Chengjun Wang
    Jianyong Pang
    Yushan Liu
    Jinsong Zhang
    Scientific Reports, 14
  • [42] Research on spatiotemporal evolution law of surrounding rock fractures and hierarchical collaborative control technology in high-stress soft rock roadway: A case study
    He, Zhe
    Xie, Zhengzheng
    Zhang, Nong
    Han, Changliang
    Xiang, Zhe
    Yan, Guojie
    Qiao, Haoxuan
    Shao, Changyao
    ENGINEERING FAILURE ANALYSIS, 2023, 150
  • [43] Bolt-grouting support in cracked soft rock roadway under high stress-a case study at pingmei no.6 coal mine
    Zhen, Wang
    Gangwei, Fan
    Peng, Liu
    Shizhong, Zhang
    Electronic Journal of Geotechnical Engineering, 2015, 20 (07): : 1765 - 1772
  • [44] A yielding bolt - grouting support design for a soft-rock roadway under high stress: a case study of the Yuandian No. 2 coal mine in China
    Sun, X.
    Wang, L.
    Lu, Y.
    Jiang, B.
    Li, Z.
    Zhang, J.
    JOURNAL OF THE SOUTHERN AFRICAN INSTITUTE OF MINING AND METALLURGY, 2018, 118 (01) : 71 - 82
  • [45] Mechanism of Instantaneous High-Strength Sand-Water Inrush in Steeply Inclined Mining of Soft Coal Seam under Disturbed Rock-Soil Overburden
    Zeng, Yifan
    Yang, Donghui
    Wu, Qiang
    Cui, Yashuai
    Liu, Zeyang
    LITHOSPHERE, 2024, 2024 (03)
  • [46] Experimental research on local buckling of BS700 high-strength steel thin-walled box-section members under axial compression
    Gao, Lei
    Shao, Fei
    Bai, Linyue
    Xie, Xingkun
    He, Xiaohui
    JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY, 2022, 36 (05) : 2299 - 2307
  • [47] Experimental research on local buckling of BS700 high-strength steel thin-walled box-section members under axial compression
    Lei Gao
    Fei Shao
    Linyue Bai
    Xingkun Xie
    Xiaohui He
    Journal of Mechanical Science and Technology, 2022, 36 : 2299 - 2307