Research on High-Strength Economic Support Technology for Soft Rock Roadway with Roof Drenching under Thin Bedrock Irregular Surface

被引:1
|
作者
Wang, Junfeng [1 ,2 ]
Tai, Lianhai [3 ,4 ]
Li, Chong [3 ,4 ]
Qu, Qundi [3 ,4 ]
Yu, Xiaoxiao [3 ,4 ]
Liu, Yitao [3 ,5 ]
Yao, Wei [2 ]
机构
[1] Inner Mongolia Univ Sci & Technol, Coll Min & Coal, Baotou 014017, Peoples R China
[2] Ordos City Jintong Min Ind Co Ltd, Ordos 017000, Peoples R China
[3] China Univ Min & Technol, Sch Mines, Xuzhou 221116, Peoples R China
[4] China Univ Min & Technol, MOE Key Lab Deep Coal Resource Min, Xuzhou 221116, Peoples R China
[5] Uxin Banner Mengda Min Ind Co Ltd, Ordos 017399, Peoples R China
来源
APPLIED SCIENCES-BASEL | 2024年 / 14卷 / 20期
基金
中国国家自然科学基金;
关键词
nondestructive immersion test; mechanical properties; multistage bearing structure; anchor cable truss; zoning control; MECHANICAL-PROPERTIES; CRACK-PROPAGATION; FAILURE-MECHANISM; WATER INTRUSION; SENSITIVITY; MOISTURE;
D O I
10.3390/app14209428
中图分类号
O6 [化学];
学科分类号
0703 ;
摘要
The control of soft surrounding rock stability has always been a hot academic issue. Soft rock has poor stability and low strength, and the deformation of a soft rock tunnel becomes more serious after it is affected by water for a long time. In this paper, the Jintong Coal Mine is taken as the research object, and nondestructive immersion experiments are used to study the change in mechanical properties of rock after being affected by water. The FLAC numerical model is used to analyze the stress evolution characteristics of the surrounding rock after being affected by water, and the results of the study show that the water absorption of siltstone is always higher than that of coarse-grained sandstone, and the uniaxial compressive strength of siltstone and coarse-grained sandstone decreases by 54.59% and 67.99%, respectively, under a state of saturated water compared with that under a state of dryness. Influenced by a T-shaped surface, the maximum principal stress concentration area occurs in the rock layer below the T-shaped surface and outside the joint. Concentrations of maximum shear stress occur within the "T" channel. Vertical stress concentration zones occur at the higher ground level and the bottom of the slope. The maximum shear stress of the roof fluctuates before the face reaches the surface of the "1" section, and continues to increase with and continues to increase with the distance of the face. After entering below the surface of the "1" section, the maximum shear stress of the roof increases rapidly, and the influence range is about 24 m. The maximum shear stress distribution plays a dominant role in the stability of the surrounding rocks of the two roadways. We analyze the principle of high-strength economic support, propose a "four-in-one" surrounding rock control technology based on "controlled hydrophobicity, structural adjustment, district management, and gradient control", and propose a surrounding rock control scheme of district management. The measured data on site show that the roadway surrounding the rock is reasonably controlled. This provides a reference for the stable control of the surrounding rock of the roadway under similar conditions.
引用
收藏
页数:21
相关论文
共 47 条
  • [21] Failure mechanism of bolting support and high-strength bolt-grouting technology for deep and soft surrounding rock with high stress
    Li Shu-cai
    Wang Hong-tao
    Wang Qi
    Jiang Bei
    Wang Fu-qi
    Guo Nian-bo
    Liu Wen-jiang
    Ren Yao-xi
    JOURNAL OF CENTRAL SOUTH UNIVERSITY, 2016, 23 (02) : 440 - 448
  • [22] Research on High Ground Stress and Soft Rock Roadway Supporting Technology of Bide Coal Mine
    Jiang, Yongdong
    Xiong, Ling
    Zhou, Weixin
    Han, Xingjiang
    Mei, Shixing
    Hu, Jian
    TRENDS IN CIVIL ENGINEERING, PTS 1-4, 2012, 446-449 : 2156 - +
  • [23] Roadway support technology of high rock burst risk area under complex mining conditions
    Hengjie, Luan
    Zeyu, Chen
    Chuanyang, Jia
    Guanzhao, Wang
    Tao, Liu
    Electronic Journal of Geotechnical Engineering, 2015, 20 (20): : 11635 - 11645
  • [24] Research on Support Technology for Unstable Roof Roadway Under Abandoned Roadways in Ultra-Thick Coal Seam
    Yu, Xianyang
    Lv, Siyuan
    Luo, Yafei
    Liu, Pengchao
    Fu, Hao
    Zhou, Yicai
    Processes, 2024, 12 (12)
  • [25] Research on an automatic roadway formation method in deep mining areas by roof cutting with high-strength bolt-grouting
    Wang, Qi
    Jiang, Zhenhua
    Jiang, Bei
    Gao, Hongke
    Huang, Yubing
    Zhang, Peng
    INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES, 2020, 128 (128)
  • [26] Research on Application of the Bolt-Truss Coupling Support Technology in Roadway With Water-Rich and Soft Rock
    Zhang, Jianguo
    Wang, Yingwei
    Qi, Xiaohan
    Zhu, Tongguang
    FRONTIERS IN EARTH SCIENCE, 2022, 10
  • [27] Research on steel tube confined concrete supports support technology for soft rock roadway in coal bed washout
    Li, Xuebin
    Ma, Zhengxing
    Liu, Guolei
    Chen, Mingcheng
    Zhu, Quanmei
    FRONTIERS OF MANUFACTURING AND DESIGN SCIENCE II, PTS 1-6, 2012, 121-126 : 3471 - 3476
  • [28] Principle and practice of coupling support of double yielding shell of soft rock roadway under high stress
    Li Chong
    Wang Zhongliang
    Liu Tao
    INTERNATIONAL JOURNAL OF MINING SCIENCE AND TECHNOLOGY, 2014, 24 (04) : 513 - 518
  • [29] Principle and practice of coupling support of double yielding shell of soft rock roadway under high stress
    Li Chong
    Wang Zhongliang
    Liu Tao
    InternationalJournalofMiningScienceandTechnology, 2014, 24 (04) : 513 - 518
  • [30] Research on Deformation Mechanisms of a High Geostress Soft Rock Roadway and Double-Shell Grouting Technology
    Wang, Fengnian
    Chen, Shizhuang
    Gao, Pan
    Guo, Zhibiao
    Tao, Zhigang
    GEOFLUIDS, 2021, 2021