Precipitation and mechanical properties of Al-Li-Mg-Si alloys

被引：0
|
作者：
Chen, R. [1 ]
Chen, C.Q. [1 ]
Huang, Z. [1 ]
Zhang, Y.G. [1 ]
机构：
[1] Dept. of Mat. Sci. and Engineering, Beijing Univ. of Aero./Astronaut., Beijing, 100083, China
来源：
Materials Science Forum | 2000年 / 331卷
关键词：
Ductility - Failure analysis - Fracture - Metallographic microstructure - Phase diagrams - Phase equilibria - Plastic deformation - Precipitation (chemical) - Shear stress - Strengthening (metal) - Tensile strength - Volume fraction;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
The microstructure and mechanical properties of two Al-Li-Mg-Si alloys and the base Al-Mg-Si alloy were investigated. It was found that the coherent δ′ particles became the predominant precipitates with a little equilibrium Mg2Si phase and AlLiSi phase formed in the Li containing alloys. No other metastable phase precipitated. Large volume fraction of δ′ lead to higher strength for Li containing alloys than the base Al-Mg-Si alloy, and solution hardening of excess Mg in matrix also increased the strength. The Li containing alloys showed a lower elongation compared with Al-Mg-Si alloy because of the planar slip caused by δ′. The tensile specimens of Al-Li-Mg-Si alloys exhibited macroscopic shear failure and their fracture surface showed mainly transgranular fracture mode while the Al-Mg-Si alloy showed fully ductile dimple fracture.
引用
收藏
相关论文
共 50 条
  • [41] Al–Cu–Li and Al–Mg–Li alloys: Phase composition, texture, and anisotropy of mechanical properties (Review)
    Betsofen S.Y.
    Antipov V.V.
    Knyazev M.I.
    Russian Metallurgy (Metally), 2016, 2016 (4) : 326 - 341
  • [42] Effect of Aging Conditions on Precipitation Hardening in Al–Si–Mg and Al–Si–Cu–Mg Alloys
    Mohamed F. Ibrahim
    Agnes M. Samuel
    Herbert W. Doty
    Fawzy H. Samuel
    International Journal of Metalcasting, 2017, 11 : 274 - 286
  • [43] Mechanical behavior of Mg-Li-Al alloys
    Rahulan, N.
    Gopalan, Sundararaman
    Kumaran, S.
    MATERIALS TODAY-PROCEEDINGS, 2018, 5 (09) : 17935 - 17943
  • [44] Microstructural and mechanical properties of precipitation-strengthened Al-Mg-Zr-Sc-Er-Y-Si alloys
    Jung, Jae-Gil
    Farkoosh, Amir R.
    Seidman, David N.
    ACTA MATERIALIA, 2023, 257
  • [45] Influence of Mg and Cu on precipitation behaviors and mechanical properties of Al-Si alloys (vol 908, 146775, 2024)
    Xue, Li-Wen
    Jia, Hai-Long
    Ma, Pin-kui
    Song, Jia-Wang
    Zha, Min
    Wang, Hui-Yuan
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2024, 909
  • [46] Al-Li-Mg-Si合金时效行为及力学性能的研究
    魏炳忱
    黄正
    张永刚
    陈昌麒
    航空学报, 1999, (06) : 522 - 526
  • [47] Structure and mechanical properties of eutectic Al-Si-Mg-Ni alloys
    Belov, N.A.
    Izvestia Akademii nauk SSSR. Metally, 1993, (05): : 133 - 138
  • [48] The influence of SB, Si and Sn on the mechanical properties of Mg-Al alloys
    Bakke, P
    Pettersen, K
    Albright, D
    MAGNESIUM TECHNOLOGY 2004, 2004, : 289 - 296
  • [49] THE EFFECTSON MICROSTRUCTURE AND MECHANICAL PROPERTIES OF FILTRATION IN Al-Si-Mg ALLOYS
    Tuncay, Tansel
    Ozyurek, Dursun
    JOURNAL OF THE FACULTY OF ENGINEERING AND ARCHITECTURE OF GAZI UNIVERSITY, 2014, 29 (02): : 271 - 279
  • [50] Thermal properties of Mg-Li and Mg-Li-Al alloys
    Rudajevová, A
    Kúdela, S
    Stanek, M
    Lukác, P
    MATERIALS SCIENCE AND TECHNOLOGY, 2003, 19 (08) : 1097 - 1100
12345