Precipitation and mechanical properties of Al-Li-Mg-Si alloys

被引：0
|
作者：
Chen, R. [1 ]
Chen, C.Q. [1 ]
Huang, Z. [1 ]
Zhang, Y.G. [1 ]
机构：
[1] Dept. of Mat. Sci. and Engineering, Beijing Univ. of Aero./Astronaut., Beijing, 100083, China
来源：
Materials Science Forum | 2000年 / 331卷
关键词：
Ductility - Failure analysis - Fracture - Metallographic microstructure - Phase diagrams - Phase equilibria - Plastic deformation - Precipitation (chemical) - Shear stress - Strengthening (metal) - Tensile strength - Volume fraction;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
The microstructure and mechanical properties of two Al-Li-Mg-Si alloys and the base Al-Mg-Si alloy were investigated. It was found that the coherent δ′ particles became the predominant precipitates with a little equilibrium Mg2Si phase and AlLiSi phase formed in the Li containing alloys. No other metastable phase precipitated. Large volume fraction of δ′ lead to higher strength for Li containing alloys than the base Al-Mg-Si alloy, and solution hardening of excess Mg in matrix also increased the strength. The Li containing alloys showed a lower elongation compared with Al-Mg-Si alloy because of the planar slip caused by δ′. The tensile specimens of Al-Li-Mg-Si alloys exhibited macroscopic shear failure and their fracture surface showed mainly transgranular fracture mode while the Al-Mg-Si alloy showed fully ductile dimple fracture.
引用
收藏
相关论文
共 50 条
  • [31] Effect of In addition on the precipitation behavior and mechanical property for Al-Mg-Si alloys
    Weng, Yaoyao
    Ding, Lipeng
    Xu, Yaqi
    Jia, Zhihong
    Sun, Qichen
    Chen, Fengchen
    Sun, Xinyan
    Cong, Yuan
    Liu, Qing
    Journal of Alloys and Compounds, 2022, 895
  • [32] The precipitation sequence in Al-Mg-Si alloys
    Edwards, GA
    Stiller, K
    Dunlop, GL
    Couper, MJ
    ACTA MATERIALIA, 1998, 46 (11) : 3893 - 3904
  • [33] Effect of In addition on the precipitation behavior and mechanical property for Al-Mg-Si alloys
    Weng, Yaoyao
    Ding, Lipeng
    Xu, Yaqi
    Jia, Zhihong
    Sun, Qichen
    Chen, Fengchen
    Sun, Xinyan
    Cong, Yuan
    Liu, Qing
    JOURNAL OF ALLOYS AND COMPOUNDS, 2022, 895
  • [34] The synergistic effect of Li addition on microstructure, texture and mechanical properties of extruded Al-Mg-Si alloys
    Din, Shamas Ud
    Kamran, J.
    Tariq, N. H.
    Hasan, B. A.
    Petrov, R. H.
    Bliznuk, V.
    Zuha, Shamas Uz
    MATERIALS CHEMISTRY AND PHYSICS, 2016, 174 : 11 - 22
  • [35] The effects of Mg amount on the microstructure and mechanical properties of Al-Si-Mg alloys
    Yildirim, Musa
    Ozyurek, Dursun
    MATERIALS & DESIGN, 2013, 51 : 767 - 774
  • [36] Effect of Cu and excess Si on mechanical properties in Al-Mg-Si alloys
    Matsuda, K
    Kido, K
    Uetani, Y
    Ikeno, S
    PRICM 4: FORTH PACIFIC RIM INTERNATIONAL CONFERENCE ON ADVANCED MATERIALS AND PROCESSING, VOLS I AND II, 2001, : 2619 - 2622
  • [37] Si poisoning and promotion on the microstructure and mechanical properties of Al–Si–Mg cast alloys
    Xixi Dong
    Shouxun Ji
    Journal of Materials Science, 2018, 53 : 7778 - 7792
  • [38] Effect of Si content on microstructure and mechanical properties of Al-Si-Mg alloys
    Wang, Yongjin
    Liao, Hengcheng
    Wu, Yuna
    Yang, Jian
    MATERIALS & DESIGN, 2014, 53 : 634 - 638
  • [39] Development of mechanical properties in Al-Li-Zn-Mg-Cu alloys
    Dinsdale, K.
    Noble, B.
    Harris, S.J.
    Gregson, P.J.
    Materials Science & Engineering A: Structural Materials: Properties, Microstructure and Processing, 1988, A104 : 75 - 84
  • [40] Influence of RE on microstructure and mechanical properties of Mg-Li-Al alloys
    Liu, B.
    Zhang, M. L.
    Niu, Z. Y.
    2006 BIMW: 2006 BEIJING INTERNATIONAL MATERIALS WEEK, PTS 1-4: MAGNESIUM, 2007, 546-549 : 211 - +
12345