Magnetic properties of Fe-based toroidal cores prepared by continuous Joule heating under tensile stress

被引:0
|
作者
Yanai, T. [1 ]
Shimada, A. [1 ]
Takagi, K. [1 ]
Takahashi, K. [1 ]
Nakano, M. [1 ]
Fukunaga, H. [1 ]
Yoshizawa, Y. [2 ]
机构
[1] Faculty of Engineering, Nagasaki University, Nagasaki 852-8521, Japan
[2] Advanced Electronics Research Laboratory, Hitachi Metals Ltd., Kumagaya 360-0843, Japan
来源
Journal of Applied Physics | 2007年 / 101卷 / 09期
关键词
Fe-based toroidal cores with a permeability value of several hundreds were prepared by the continuous Joule heating method under tensile stress at a high moving velocity of 120 cmmin; corresponding to an effective annealing time of approximately 1.8 s; and their magnetic properties were evaluated. The prepared core showed a constant permeability value up to 2 MHz and a low magnetic loss compared with those for conventional cores with controlled permeability. An investigation of dc-bias properties of the core suggested that the core has constant and good magnetic properties below the dc-bias field of 1 kAm which is approximately 50% of the anisotropy field. Consequently; the continuous Joule heating under a tensile stress method at high moving velocity enables us to prepare a long annealed ribbon in a short time with simple equipment and improves productivity for the fabrication process of high performance Fe-based toroidal cores with controlled permeability. © 2007 American Institute of Physics;
D O I
暂无
中图分类号
学科分类号
摘要
Conference article (CA)
引用
下载
收藏
相关论文
共 50 条
  • [1] Magnetic properties of Fe-based toroidal cores prepared by continuous Joule heating under tensile stress
    Yanai, T.
    Shimada, A.
    Takagi, K.
    Takahashi, K.
    Nakano, M.
    Fukunaga, H.
    Yoshizawa, Y.
    JOURNAL OF APPLIED PHYSICS, 2007, 101 (09)
  • [2] Magnetic properties of Fe-based ribbons and toroidal cores prepared by continuous Joule heating under tensile stress
    Yanai, T.
    Shimada, A.
    Takahashi, K.
    Nakano, M.
    Yoshizawa, Y.
    Fukunaga, H.
    IEEE TRANSACTIONS ON MAGNETICS, 2006, 42 (10) : 2781 - 2783
  • [3] Fabrication of Fe-based ribbon with controlled permeability by Joule heating under tensile stress
    Yanai, T.
    Takagi, K.
    Takahashi, K.
    Nakano, M.
    Yoshizawa, Y.
    Fukunaga, H.
    JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS, 2008, 320 (20) : E833 - E836
  • [4] Magnetic properties of Fe-based ribbons with controlled permeability prepared by continuous pulse annealing under tensile stress
    Takagi, Kotaro
    Yanai, Takeshi
    Takahashi, Ken-ichiro
    Nakano, Masaki
    Fukunaga, Hirotoshi
    Yoshizawa, Yoshihito
    JOURNAL OF APPLIED PHYSICS, 2009, 105 (07)
  • [5] The effect of ribbon curvature on the magnetic properties of Fe-based amorphous cores
    Li, Z.
    Yao, K. F.
    Li, D. R.
    Ni, X. J.
    Lu, Z. C.
    JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS, 2017, 28 (22) : 16736 - 16740
  • [6] The effect of ribbon curvature on the magnetic properties of Fe-based amorphous cores
    Z. Li
    K. F. Yao
    D. R. Li
    X. J. Ni
    Z. C. Lu
    Journal of Materials Science: Materials in Electronics, 2017, 28 : 16736 - 16740
  • [7] Effect of Laser Irradiation and Tensile Stress on Microstructure and Magnetic Properties of Fe-Based Amorphous Alloys
    Yao, Yunxia
    Huang, Haoxuan
    Chen, Cai
    Ni, Mayan
    Yang, Sen
    NANOMATERIALS, 2024, 14 (01)
  • [8] MAGNETIC-PROPERTIES OF FLASH ANNEALED FE-BASED AMORPHOUS CORES
    YU, XJ
    QUAN, BY
    NARITA, K
    JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS, 1994, 133 (1-3) : 344 - 346
  • [9] Magnetic Properties of Fe-Based Amorphous Powder Cores With High Magnetic Flux Density
    Otsuka, Isamu
    Kadomura, Takeshi
    Ishiyama, Kazushi
    Yagi, Masaaki
    IEEE TRANSACTIONS ON MAGNETICS, 2009, 45 (10) : 4294 - 4297
  • [10] Structure and physical properties changes of Fe-based amorphous alloy induced by Joule-heating
    Nykyruy Y.
    Kulyk Y.
    Mudry S.
    Prunitsa V.
    Borysiuk A.
    Applied Nanoscience (Switzerland), 2023, 13 (11): : 7089 - 7100