Comparison of early osseointegration between laser-treated/acid-etched and sandblasted/acid-etched titanium implant surfaces

This study was designed to compare the early osseointegration of titanium surfaces prepared via laser-treated/acid-etched (LA) and sandblasted/acid-etched (SLA) in dogs. Titanium implants were divided into two groups: Surfaces of the experimental group were treated via LA, while in the control group, surfaces were treated via SLA. The physical and chemical properties of LA and SLA surfaces were tested and compared. Sixteen implants with LA or SLA surfaces were placed into the tibias of four beagle dogs, each treatment group received two implants per single tibia. The dogs were sacrificed two and four weeks after implant placement. Scanning electron microscopy showed that both the LA and SLAs surface exhibited rough structures with micro pores sized 1–3 μm. In the LA surface, regular melting points were observed. However, in the SLA surface, the structure was irregular and few oxide aluminum particles still remained. Only titanium and a small amount of titanium compounds were detected on LA surfaces, while Al was found of SLA surfaces. The LA surface roughness was above that of SLA surfaces (LA: Ra: 2.1 μm; SLA: Ra :1.53 μm; P < 0.01). Both groups exhibited good osseointegration and no significant differences were found in the BIC% at two or four weeks between both groups (P > 0.05). Both groups exhibited good osseointegration; however, the LA surface was cleaner and more uniform than the SLA surface, and no significant differences were found between both groups.