Rock Fracture Toughness Study Under Mixed Mode I/III Loading

被引:1
|
作者
M. R. M. Aliha
A. Bahmani
机构
[1] Iran University of Science and Technology (IUST),Welding and Joining Research Center, School of Industrial Engineering
[2] University of Waterloo,Department of Mechanical and Mechatronics Engineering
来源
关键词
Mixed mode I/III; Marble rock; Novel disc shape specimen; –; data; Fracture models;
D O I
暂无
中图分类号
学科分类号
摘要
Fracture growth in underground rock structures occurs under complex stress states, which typically include the in- and out-of-plane sliding deformation of jointed rock masses before catastrophic failure. However, the lack of a comprehensive theoretical and experimental fracture toughness study for rocks under contributions of out-of plane deformations (i.e. mode III) is one of the shortcomings of this field. Therefore, in this research the mixed mode I/III fracture toughness of a typical rock material is investigated experimentally by means of a novel cracked disc specimen subjected to bend loading. It was shown that the specimen can provide full combinations of modes I and III and consequently a complete set of mixed mode I/III fracture toughness data were determined for the tested marble rock. By moving from pure mode I towards pure mode III, fracture load was increased; however, the corresponding fracture toughness value became smaller. The obtained experimental fracture toughness results were finally predicted using theoretical and empirical fracture models.
引用
收藏
页码:1739 / 1751
页数:12
相关论文
共 50 条
  • [21] Fractographic study of epoxy under mode I and mixed mode I/III loading
    Ren, Fei
    Wang, John Jy-An
    Bertelsen, Williams D.
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2012, 532 : 449 - 455
  • [22] Mode I fracture toughness of rock under confining pressure
    Stoeckhert, F.
    Brenne, S.
    Molenda, M.
    Alber, M.
    ROCK MECHANICS AND ROCK ENGINEERING: FROM THE PAST TO THE FUTURE, VOL 1, 2016, : 313 - 318
  • [23] Low temperature fracture toughness study for bitumen under mixed mode I plus II loading condition
    Aliha, M. R. M.
    Shaker, S.
    Keymanesh, M. R.
    ENGINEERING FRACTURE MECHANICS, 2019, 206 : 297 - 309
  • [24] Experimental study on the fracture toughness of rust stone under mixed mode loading condition
    Hua, W.
    Dong, S.
    Xu, J.
    Materials Research Innovations, 2015, 19 : 531 - 536
  • [25] Influence of mixed mode I/III loading on fracture toughness of mild steel at various strain rates
    Srinivas, M
    Kamat, SV
    Rao, PR
    MATERIALS SCIENCE AND TECHNOLOGY, 2004, 20 (02) : 235 - 242
  • [26] Fracture behavior of GPPS brittle polymer under mixed mode I/III loading
    Safaei, Sajjad
    Ayatollahi, Majid R.
    Saboori, Behnam
    THEORETICAL AND APPLIED FRACTURE MECHANICS, 2017, 91 : 103 - 115
  • [27] A new fixture for fracture tests under mixed mode I/II/III loading
    Razavi, Seyed Mohammad Javad
    Berto, Filippo
    FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES, 2019, 42 (09) : 1874 - 1888
  • [28] Initial and unstable fracture toughness of quartz-diorite rock under mixed mode I/II loading: Experimental and numerical investigation
    Wu, You
    Yin, Tubing
    Zhuang, Dengdeng
    Chen, Yongjun
    Ma, Jiexin
    Guo, Wenxuan
    THEORETICAL AND APPLIED FRACTURE MECHANICS, 2023, 127
  • [29] The effect of volume fraction of primary α phase on fracture toughness behaviour of Timetal 834 titanium alloy under mode I and mixed mode I/III loading
    Rao, B. S. S. Chandra
    Srinivas, M.
    Kamat, S. V.
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2009, 520 (1-2): : 29 - 35
  • [30] Mixed mode I/III fracture toughness in extruded magnesium alloys
    Sharma, R.
    Kamat, S. V.
    Srinivas, M.
    Singh, A. K.
    Rao, P. Rama
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2011, 528 (18): : 5875 - 5882