Dielectric barrier discharge treatments at atmospheric pressure for wood surface modification

In this research, the effect of dielectric barrier discharge on mechanically manufactured (sawn, planed or polished) wood surfaces is investigated. The experiments have shown that the best hydrophilia is obtained with a cold plasma discharge in air under atmospheric pressure. Other gases such as helium, nitrogen, and argon have been tested, too. Changes of the wood surface properties were determined by absorption of water and contact angle measurements. As a result of a 1 to 20 seconds long exposure to plasma, wood surfaces became hydrophilic. The absorption of water in wood can be changed up to 22 times higher after plasma treatment in air for 20 seconds duration. The fracture strength of glued wood has been increased by 68% after this plasma pretreatment. Using plasma treatment in methane or acetylene wood surfaces are changed to hydrophobic properties. After plasma treatment for 1 min. in a Ar:CH4=80:20 gas mixture under atmospheric pressure, the absorption of water in wood is 32 times lower than without plasma treatment. As mentioned before, plasma treatment can produce hydrophobic and hydrophilic wood surfaces. But a good homogeneity of the gas discharge is necessary for the plasma treatment of wood.