Source process of the 2016 Kumamoto earthquake (Mj7.3) inferred from kinematic inversion of strong-motion records

被引:0
|
作者
Kunikazu Yoshida
Ken Miyakoshi
Kazuhiro Somei
Kojiro Irikura
机构
[1] Geo-Research Institute,Disaster Prevention Research Center
[2] Aichi Institute of Technology,undefined
来源
关键词
2016 Kumamoto earthquake; Source process; Kinematic inversion; Near-fault strong motion;
D O I
暂无
中图分类号
学科分类号
摘要
In this study, we estimated source process of the 2016 Kumamoto earthquake from strong-motion data by using the multiple-time window linear kinematic waveform inversion method to discuss generation of strong motions and to explain crustal deformation pattern with a seismic source inversion model. A four-segment fault model was assumed based on the aftershock distribution, active fault traces, and interferometric synthetic aperture radar data. Three western segments were set to be northwest-dipping planes, and the most eastern segment under the Aso caldera was examined to be a southeast-dipping plane. The velocity structure models used in this study were estimated by using waveform modeling of moderate earthquakes that occurred in the source region. We applied a two-step approach of the inversions of 20 strong-motion datasets observed by K-NET and KiK-net by using band-pass-filtered strong-motion data at 0.05–0.5 Hz and then at 0.05–1.0 Hz. The rupture area of the fault plane was determined by applying the criterion of Somerville et al. (Seismol Res Lett 70:59–80, 1999) to the inverted slip distribution. From the first-step inversion, the fault length was trimmed from 52 to 44 km, whereas the fault width was kept at 18 km. The trimmed rupture area was not changed in the second-step inversion. The source model obtained from the two-step approach indicated 4.7 × 1019 Nm of the total moment release and 1.8 m average slip of the entire fault with a rupture area of 792 km2. Large slip areas were estimated in the seismogenic zone and in the shallow part corresponding to the surface rupture that occurred during the Mj7.3 mainshock. The areas of the high peak moment rate correlated roughly with those of large slip; however, the moment rate functions near the Earth surface have low peak, bell shape, and long duration. These subfaults with long-duration moment release are expected to cause weak short-period ground motions. We confirmed that the southeast dipping of the most eastern segment is more plausible rather than northwest-dipping from the observed subsidence around the central cones of the Aso volcano.Graphical Abstract.[graphic not available: see fulltext]
引用
收藏
相关论文
共 50 条
  • [21] Source Model of the 2016 Kumamoto, Japan, Earthquake Constrained by InSAR, GPS, and Strong-Motion Data: Fault Slip under Extensional Stress
    Zhang, Yingfeng
    Shan, Xinjian
    Zhang, Guohong
    Gong, Wenyu
    Liu, Xiaodong
    Yin, Hao
    Zhao, Dezheng
    Wen, Shaoyan
    Qu, Chunyan
    BULLETIN OF THE SEISMOLOGICAL SOCIETY OF AMERICA, 2018, 108 (5A) : 2675 - 2686
  • [24] Destructive near-fault strong ground motion from the 2016 Kumamoto prefecture, Japan, M7.3 earthquake
    Takashi Furumura
    Landslides, 2016, 13 : 1519 - 1524
  • [25] Simultaneous inversion of geodetic and strong-motion data for the source process of the Hyogo-ken Nanbu, Japan, earthquake
    Horikawa, H
    Hirahara, K
    Umeda, Y
    Hashimoto, M
    Kusano, F
    JOURNAL OF PHYSICS OF THE EARTH, 1996, 44 (05): : 455 - 471
  • [26] Fling Effects from Near-Source Strong-Motion Records: Insights from the 2016 Mw 6.5 Norcia, Central Italy, Earthquake
    D'Amico, Maria
    Felicetta, Chiara
    Schiappapietra, Erika
    Pacor, Francesca
    Gallovic, Frantisek
    Paolucci, Roberto
    Puglia, Rodolfo
    Lanzano, Giovanni
    Sgobba, Sara
    Luzi, Lucia
    SEISMOLOGICAL RESEARCH LETTERS, 2019, 90 (02) : 659 - 671
  • [27] Source rupture process of the 2016 central Tottori, Japan, earthquake (MJMA 6.6) inferred from strong motion waveforms
    Hisahiko Kubo
    Wataru Suzuki
    Shin Aoi
    Haruko Sekiguchi
    Earth, Planets and Space, 69
  • [28] Source rupture process of the 2016 central Tottori, Japan, earthquake (MJMA 6.6) inferred from strong motion waveforms
    Kubo, Hisahiko
    Suzuki, Wataru
    Aoi, Shin
    Sekiguchi, Haruko
    EARTH PLANETS AND SPACE, 2017, 69
  • [29] Rupture Process of the 1964 MJMA 7.5 Niigata Earthquake Estimated from Regional Strong-Motion Records
    Shiba, Yoshiaki
    Uetake, Tomiichi
    BULLETIN OF THE SEISMOLOGICAL SOCIETY OF AMERICA, 2011, 101 (04) : 1871 - 1884
  • [30] Robust features of the source process for the 2004 Parkfield, California, earthquake from strong-motion seismograms
    Twardzik, C.
    Madariaga, R.
    Das, S.
    Custodio, S.
    GEOPHYSICAL JOURNAL INTERNATIONAL, 2012, 191 (03) : 1245 - 1254