Evaluation of the Bending Performance of Glued CLT-Concrete Composite Floors Based on the CFRP Reinforcement Ratio

A study was conducted on the reinforcement of cross-laminated timber (CLT) concrete composite floors with carbon fiber reinforced plastic (CFRP) to improve its mechanical performance and reliability in wood composite structures. A four-point bending test evaluation was completed on three types of cross-laminated timber concrete composite floors produced with different carbon fiber reinforced plastic reinforcement ratios (33%, 66%, and 100%) on the entire surface of the tensile portion. An increase in the carbon fiber reinforced plastic reinforcement ratio of the composite floors led to an increased bending capacity and a slightly improved yield performance. In the case of a composite floor with a reinforcement ratio of 33%, premature failure occurred in the elastic region due to defects of the CLT such as knots and slopes of the grain. Failure mode analysis revealed that tensile and shear failure coexist when the composite floor has a CFRP reinforcement ratio of 33%. In contrast, reinforcement ratios of 66% and 100% prevented premature failures in the elastic region caused by defects and induced a consistent failure mode. These reinforcement effects reduced the variability in the increased bending capacity of the composite floors and improved the accuracy of the theoretical prediction design via the ?? -method. Meanwhile, the shear connections between the cross-laminated timber and concrete via epoxy adhesive exhibited full-composite behavior without being affected by the reinforcement ratio.