Estimating Biomass and Canopy Height With LiDAR for Field Crop Breeding

被引:90
|
作者
Walter, James D. C. [1 ,2 ]
Edwards, James [1 ,2 ]
McDonald, Glenn [1 ]
Kuchel, Haydn [1 ,2 ]
机构
[1] Univ Adelaide, Sch Agr Food & Wine, Gien Osmond, SA, Australia
[2] Australian Grain Technol Pty Ltd, Roseworthy, SA, Australia
来源
关键词
wheat; phenomics; high throughput phenotyping; field phenotyping; plant breeding; YIELD; PLATFORM;
D O I
10.3389/fpls.2019.01145
中图分类号
Q94 [植物学];
学科分类号
071001 ;
摘要
Above-ground biomass (AGB) is a trait with much potential for exploitation within wheat breeding programs and is linked closely to canopy height (CH). However, collecting phenotypic data for AGB and CH within breeding programs is labor intensive, and in the case of AGB, destructive and prone to assessment error. As a result, measuring these traits is seldom a priority for breeders, especially at the early stages of a selection program. LiDAR has been demonstrated as a sensor capable of collecting three-dimensional data from wheat field trials, and potentially suitable for providing objective, non-destructive, high-throughput estimates of AGB and CH for use by wheat breeders. The current study investigates the deployment of a LiDAR system on a ground-based high-throughput phenotyping platform in eight wheat field trials across southern Australia, for the nondestructive estimate of AGB and CH. LiDAR-derived measurements were compared to manual measurements of AGB and CH collected at each site and assessed for their suitability of application within a breeding program. Correlations between AGB and LiDAR Projected Volume (LPV) were generally strong (up to r = 0.86), as were correlations between CH and LiDAR Canopy Height (LCH) (up to r = 0.94). Heritability (H-2) of LPV (H-2 = 0.32-0.90) was observed to be greater than, or similar to, the heritability of AGB (H-2 = 0.12-0.78) for the majority of measurements. A similar level of heritability was observed for LCH (H-2 = 0.41-0.98) and CH (H-2 = 0.49-0.98). Further to this, measurements of LPV and LCH were shown to be highly repeatable when collected from either the same or opposite direction of travel. UDAR scans were collected at a rate of 2,400 plots per hour, with the potential to further increase throughput to 7,400 plots per hour. This research demonstrates the capability of LiDAR sensors to collect high-quality, non-destructive, repeatable measurements of AGB and CH suitable for use within both breeding and research programs.
引用
收藏
页数:16
相关论文
共 50 条
  • [21] Estimating the vegetation canopy height using micro-pulse photon-counting LiDAR data
    Nie, Sheng
    Wang, Cheng
    Xi, Xiaohuan
    Luo, Shezhou
    Li, Guoyuan
    Tian, Jinyan
    Wang, Hongtao
    OPTICS EXPRESS, 2018, 26 (10): : A520 - A540
  • [22] Mapping forest canopy height globally with spaceborne lidar
    Simard, Marc
    Pinto, Naiara
    Fisher, Joshua B.
    Baccini, Alessandro
    JOURNAL OF GEOPHYSICAL RESEARCH-BIOGEOSCIENCES, 2011, 116
  • [23] Estimation of Peaks and Canopy Height using LiDAR Data
    Lavenya, R.
    Shanmukha, Kinnera
    Vaishnavi, Khokalay
    Abijith, N. G.
    Aravinth, J.
    PROCEEDINGS OF THE 2018 IEEE INTERNATIONAL CONFERENCE ON COMMUNICATION AND SIGNAL PROCESSING (ICCSP), 2018, : 518 - 522
  • [24] Challenges to Estimating Tree Height via LiDAR in Closed-Canopy Forests: A Parable from Western Oregon
    Gatziolis, Demetrios
    Fried, Jeremy S.
    Monleon, Vicente S.
    FOREST SCIENCE, 2010, 56 (02) : 139 - 155
  • [25] Estimating Canopy Height of Deciduous Forests at a Regional Scale with Leaf-Off, Low Point Density LiDAR
    Brubaker, K. M.
    Johnson, S. E.
    Brinks, J.
    Leites, L. P.
    CANADIAN JOURNAL OF REMOTE SENSING, 2014, 40 (02) : 123 - 134
  • [26] HEIGHT AND BIOMASS INVERSION OF WINTER WHEAT BASED ON CANOPY HEIGHT MODEL
    Feng, Haikuan
    Pan, Li
    Yang, Fan
    Pei, Haojie
    Wang, Huifang
    Yang, Guijun
    Liu, Mingxing
    Wu, Zhichao
    IGARSS 2018 - 2018 IEEE INTERNATIONAL GEOSCIENCE AND REMOTE SENSING SYMPOSIUM, 2018, : 7711 - 7714
  • [27] An automated method to quantify crop height and calibrate satellite-derived biomass using hypertemporal lidar
    Eitel, Jan U. H.
    Magney, Troy S.
    Vierling, Lee A.
    Greaves, Heather E.
    Zheng, Guang
    REMOTE SENSING OF ENVIRONMENT, 2016, 187 : 414 - 422
  • [28] Fusion of LiDAR and imagery for estimating forest canopy fuels
    Erdody, Todd L.
    Moskal, L. Monika
    REMOTE SENSING OF ENVIRONMENT, 2010, 114 (04) : 725 - 737
  • [29] Estimating biomass carbon stocks for a Mediterranean forest in central Spain using LiDAR height and intensity data
    Garcia, Mariano
    Riano, David
    Chuvieco, Emilio
    Danson, F. Mark
    REMOTE SENSING OF ENVIRONMENT, 2010, 114 (04) : 816 - 830
  • [30] Development of a pit filling algorithm for LiDAR canopy height models
    Ben-Arie, Joshua R.
    Hay, Geoffrey J.
    Powers, Ryan P.
    Castilla, Guillermo
    St-Onge, Benoit
    COMPUTERS & GEOSCIENCES, 2009, 35 (09) : 1940 - 1949