Numerical simulations of forced convection heat transfer and flow characteristics of nanofluids in small tubes using two-phase models

被引:13
|
作者
Chen, Yan-jun [1 ]
Li, Yuan-yang [1 ]
Liu, Zhen-hua [1 ]
机构
[1] Shanghai Jiao Tong Univ, Sch Mech Engn, Shanghai 200240, Peoples R China
基金
中国国家自然科学基金;
关键词
Nanofluid; Multiphase flow; Heat transfer; Simulation; LAMINAR MIXED CONVECTION; ENHANCEMENT; SINGLE;
D O I
10.1016/j.ijheatmasstransfer.2014.07.052
中图分类号
O414.1 [热力学];
学科分类号
摘要
Laminar and turbulent forced convection heat transfer and flow characteristics of nanofluids in small smooth tubes are numerically simulated using two kinds of multiphase-flow models. The simulated results are compared with the experimental results from the published papers and the traditional predicting correlations to investigate the applicability of these models for nanofluids. The multiphase-flow models including mixture model and Eulerian model, and both of them belong to the well-known Euler-Euler model. The effects of various parameters such as Reynolds number and nanoparticles concentration on the heat transfer and flow characteristics are investigated and discussed in each model. The study results show that little deviation exists between the simulated results and the traditional predicting correlations for low concentration nanofluid, which indicates that low concentration nanofluid has no meaningful nano-effect on forced convection heat transfer. While, non-traditional fluid characteristics occur and increase with increasing the nanoparticles concentration, and the simulated results using special models of multiphase flow are closer to the experimental data than that of the traditional correlations, which means the multiphase flow models are more accurate than traditional correlations for high concentration nanofluid. Moreover, the numerical results also indicate that the drag coefficients of simulated results have only little difference less than 0.4% with that of experimental results for nanofluids in the laminar flow region. However, the drag coefficients of simulated results have a increase by about 60-22% compared with the experimental results in the turbulent flow region. As conclusion, the present study indicates that the two-phase models, including mixture model and Eulerian model, can predict the forced convection heat transfer and flow characteristics of nanofluid well, and have important implications for the application of nanofluid. (C) 2014 Elsevier Ltd. All rights reserved.
引用
收藏
页码:993 / 1003
页数:11
相关论文
共 50 条
  • [3] Characteristics of two-phase flow and heat transfer in small tubes
    Lin, S
    Kew, PA
    SIXTH UK NATIONAL CONFERENCE ON HEAT TRANSFER, 1999, 1999 (07): : 185 - 190
  • [4] Two-phase forced convection of nanofluids flow in circular tubes using convergent and divergent conical rings inserts
    Mohammed, Hussein A.
    Abuobeida, Ibrahim A. M. Ali
    Vuthaluru, Hari B.
    Liu, Shaomin
    INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2019, 101 : 10 - 20
  • [5] Two-phase flow regimes and heat transfer in small tubes and channels
    Lin, S
    Kew, PA
    Cornwell, K
    HEAT TRANSFER 1998, VOL 2: GENERAL PAPERS, 1998, : 45 - 50
  • [6] Heat transfer characteristics of a two-phase closed thermosyphons using nanofluids
    Huminic, Gabriela
    Huminic, Angel
    EXPERIMENTAL THERMAL AND FLUID SCIENCE, 2011, 35 (03) : 550 - 557
  • [7] Numerical simulations of two-phase fluid flow and heat transfer in a condenser
    Bokil, A
    Zhang, C
    ADVANCED COMPUTATIONAL METHODS IN HEAT TRANSFER IV, 1996, : 413 - 424
  • [8] Two-Phase Flow and Boiling Heat Transfer in Small-Diameter Tubes
    Mori, Hideo
    HEAT TRANSFER ENGINEERING, 2016, 37 (7-8) : 686 - 695
  • [9] Heat transfer to two-phase flow in inclined tubes
    Hetsroni, G
    Mewes, D
    Enke, C
    Gurevich, M
    Mosyak, A
    Rozenblit, R
    INTERNATIONAL JOURNAL OF MULTIPHASE FLOW, 2003, 29 (02) : 173 - 194
  • [10] Two-phase heat transfer using no-phase flow models?
    Thome, JR
    HEAT TRANSFER ENGINEERING, 2004, 25 (06) : 1 - 2