Residual stresses in thermal barrier coatings measured by photoluminescence piezospectroscopy and indentation technique

被引：56

作者：

Zhao, X. ^{[1
]}

Xiao, P. ^{[1
]}

机构：

[1] Univ Manchester, Sch Mat, Ctr Mat Sci, Manchester M1 7HS, Lancs, England

来源：

SURFACE & COATINGS TECHNOLOGY | 2006年 / 201卷 / 3-4期

基金：

英国工程与自然科学研究理事会;

关键词：

thermal barrier coatings; stresses; Young's modulus; photoluminescence piezospectroscopy; indentation;

D O I：

10.1016/j.surfcoat.2006.01.035

中图分类号：

TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

Residual stresses in electron beam physical vapour deposition (EB-PVD) thermal barrier coatings (TBCs) have been measured by photoluminescence piezospectroscopy (PLPS). It was found that the macro-stress, caused by the thermal mismatch between the substrate and the coating, decreases from the TBC/TGO interface to the top surface. The Young's modulus, measured on the cross-section of EB-PVD coating by nano-indentation, was also found to decrease from TBC/TGO interface to top surface. The variation of Young's modulus can be explained by change in the contact area of TBC under macro-stress. A model was employed to examine the contact area in relation to the stresses. And the stresses estimated based on results from nano-indentation measurements showed the same trend as that obtained from PLPS. (c) 2006 Elsevier B.V. All rights reserved.

引用

页码：1124 / 1131

页数：8

共 50 条

[41] Thermal shock failure and residual stresses analysis of thermal barrier coatings by atmospheric plasma spray
Wang, Zhi-Ping
Lin, Xiao-Ping
Jia, Peng
Ding, Kun-Ying
Cailiao Rechuli Xuebao/Transactions of Materials and Heat Treatment, 2012, 33 (04): : 116 - 120
[42] Photoluminescence peizospectroscopy for non-destructive residual life assessment of thermal barrier coatings
Sridharan, S
Jordan, EH
Gell, M
SURFACE ENGINEERING, 2004, 20 (06) : 405 - 411
[43] Experimental and Numerical Investigation of Residual Stresses in Plasma-sprayed Thermal Barrier Coatings
Yang Jia-Sheng
Yu Jian-Hua
Zhong Xing-Hua
Zhao Hua-Yu
Zhou Xia-Ming
Tao Shun-Yan
Ding Chuan-Xian
JOURNAL OF INORGANIC MATERIALS, 2013, 28 (12) : 1381 - 1386
[44] Residual stresses in ceramic plasma-sprayed thermal barrier coatings: Measurement and calculation
Levit, M
Grimberg, I
Weiss, BZ
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1996, 206 (01): : 30 - 38
[45] Mechanical Characterisation of thermal barrier coatings using a micro-indentation instrumented technique
Kanoute, P.
Leroy, F. H.
Passilly, B.
MECHANICAL BEHAVIOR OF MATERIALS X, PTS 1AND 2, 2007, 345-346 : 829 - +
[46] Residual stresses in PVD/plasma sprayed thermal barrier multilayered coatings at high temperature
Teixeira, V
Andritschky, M
Fischer, W
Stover, D
ADVANCED MULTILAYERED AND FIBRE-REINFORCED COMPOSITES, 1998, 43 : 415 - 430
[47] Surface-roughness induced residual stresses in thermal barrier coatings: computer simulations
Hsueh, C.H.
Becher, P.F.
Fuller Jr., E.R.
Langer, S.A.
Carter, W.C.
Materials Science Forum, 1999, 308-311 : 442 - 449
[48] Numerical simulation of interfacial residual stresses in thermal barrier coatings induced by interface topography
Wang, H.
Zhang, K.
Chen, G.N.
Jinshu Rechuli/Heat Treatment of Metals, 2001, 26 (09):
[49] Modeling and characterization of residual stresses and microstructure in thermal barrier coatings after plasma spraying
Persson, C
Bengtsson, P
Wigren, J
Greving, D
THERMAL SPRAY: PRACTICAL SOLUTIONS FOR ENGINEERING PROBLEMS, 1996, : 941 - 946
[50] Thermomechanical simulations of the transient coupled effect of thermal cycling and oxidation on residual stresses in thermal barrier coatings
Lim, L. Y.
Meguid, S. A.
CERAMICS INTERNATIONAL, 2022, 48 (03) : 3133 - 3147

← 1 2 3 4 5 →