A Sensorless Parabolic Current Control Method for Single Phase Standalone Inverters

Parabolic current control is an attractive current control method with fast transient response and constant switching frequency. Due to the good dynamics of parabolic current control, it can be employed in voltage source inverters to improve the system performance such as minimizing the distortion of current waveforms or voltage waveforms. To implement parabolic current control, a current sensor is required, associated with the current conditioning circuit and parabolic carrier generators. Since parabolic current control is based on the real-time information of the inductor current, any phase delay or propagation delay of the sensor itself and the conditioning circuitry, or limited resolution of parabolic carrier generators, could impact the current control performance. Since the parabolic current control compares analog signals to generate the required control signals, noise from the control board impacts the control precision as well. This paper will explore solutions to these problems. First, the inductor current of voltage source inverter is analyzed and the parabolic current control strategy is studied, then a sensorless parabolic current control method is proposed. The new sensorless parabolic control method utilizes a current emulator to rebuild the inductor current on a micro-controller. To avoid a dc offset on the ac-side output voltage caused by the current emulator, an additional control loop in the current emulator is added. The effectiveness of the proposed methods are experimentally verified by the use of an H-bridge voltage source inverter.