Benchmark Evaluation of Start-Up and Zero-Power Measurements at the High-Temperature Engineering Test Reactor

被引:12
|
作者
Bess, John D. [1 ]
Fujimoto, Nozomu [2 ]
机构
[1] Idaho Natl Lab, Idaho Falls, ID 83415 USA
[2] Japan Atom Energy Agcy, Oarai Res & Dev Ctr, Dept HTTR, Oarai, Ibaraki 3111393, Japan
关键词
CORE PHYSICS TESTS; NUCLEAR-DATA; HTTR; SCIENCE; CRITICALITY; LIBRARY;
D O I
10.13182/NSE14-14
中图分类号
TL [原子能技术]; O571 [原子核物理学];
学科分类号
0827 ; 082701 ;
摘要
Benchmark models were developed to evaluate six cold-critical and two warm-critical, zero-power measurements of the high-temperature engineering test reactor (HTTR). Additional measurements of the subcritical configuration of the fully loaded core, core excess reactivity, shutdown margins, six isothermal temperature coefficients, and axial reaction-rate distributions were also evaluated as acceptable benchmark experiments. Insufficient information is publicly available to develop finely detailed models of the HTTR as much of the design information is still proprietary. The uncertainties in the benchmark models are judged to be of sufficient magnitude to encompass any biases and bias uncertainties incurred through the simplification process used to develop the benchmark models. However, use of the benchmark critical configurations of the HTTR for nuclear data adjustment is not recommended as the impact of these biases has not been addressed with rigorous detail. The impact of any simplification biases, if any, is not expected to significantly impact evaluation of the other reactor physics measurement calculations. Dominant uncertainties in the experimental k(eff) for all core configurations come from uncertainties in the impurity content of the various graphite blocks that compose the HTTR. Monte Carlo calculations of k(eff) are between 0.9% and 2.7% greater than the benchmark values. Reevaluation of the HTTR models as additional information becomes available could improve the quality of this benchmark and possibly reduce the computational biases. High-quality characterization of graphite impurities would significantly improve the quality of the HTTR benchmark assessment. Simulations of the other reactor physics measurements are in good agreement with the benchmark experiment values. The complete benchmark evaluation details are available in the 2014 edition of the International Handbook of Evaluated Reactor Physics Benchmark Experiments.
引用
收藏
页码:414 / 427
页数:14
相关论文
共 50 条
  • [41] Experimental investigation on start-up and heat transfer performance of the high-temperature heat pipe receiver with an ellipse-concave plate absorber
    Zhang, Wenqi
    Yao, Huicong
    Wang, Yinfeng
    Chen, Haijun
    Zhu, Yuezhao
    CASE STUDIES IN THERMAL ENGINEERING, 2021, 28
  • [42] A preliminary neutronic evaluation of high temperature engineering test reactor using the SCALE6 code
    Tanure, L. P. A. R.
    Sousa, R. V.
    Costa, D. F.
    Cardoso, F.
    Veloso, M. A. F.
    Pereira, C.
    RADIATION PHYSICS AND CHEMISTRY, 2014, 95 : 417 - 419
  • [43] Hydrogen production at a nuclear power engineering plant with a high-temperature gas-cooled reactor (HTGR NPEP)
    I. V. Marov
    G. N. Kodochigov
    D. S. Birin
    Atomic Energy, 2024, 136 (5) : 245 - 252
  • [44] Safety shutdown of the high temperature engineering test reactor during loss of off-site electric power simulation test
    Takeda, T
    Nakagawa, S
    Honma, F
    Takada, E
    Fujimoto, N
    JOURNAL OF NUCLEAR SCIENCE AND TECHNOLOGY, 2002, 39 (09) : 986 - 995
  • [45] DEVELOPMENT OF AN IN-SERVICE INSPECTION TECHNIQUE FOR THE INTERMEDIATE HEAT-EXCHANGER TUBES OF THE HIGH-TEMPERATURE ENGINEERING TEST REACTOR
    INAGAKI, Y
    MIYAMOTO, Y
    NAKAJIMA, T
    KOZUMA, T
    SHOJI, H
    NUCLEAR TECHNOLOGY, 1993, 104 (01) : 106 - 117
  • [46] Research on low temperature brittleness of 30Cr1Mo1V high-temperature rotor and its life optimization in rapid start-up and warm-up process
    Tang, Minjin
    Xia, Xianxi
    Zhang, Xiancheng
    Xue, Fei
    Chen, Zhongbing
    Zhang, Guodong
    INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING, 2021, 194
  • [47] BOWING TEST OF GRAPHITE SLEEVE FOR HIGH-TEMPERATURE GAS-COOLED REACTOR - OUT OF PILE HEAT-UP EXPERIMENT AND BENDING TEST
    ETO, M
    FUJISAKI, K
    YODA, S
    OKU, T
    JOURNAL OF NUCLEAR SCIENCE AND TECHNOLOGY, 1985, 22 (01) : 58 - 67
  • [48] Improvement of neutron startup source handling work by developing new transportation container for high-temperature engineering test reactor (HTTR)
    Shimazaki, Yosuke
    Sawahata, Hiroaki
    Shinohara, Masanori
    Yanagida, Yoshinori
    Kawamoto, Taiki
    Takada, Shoji
    JOURNAL OF NUCLEAR SCIENCE AND TECHNOLOGY, 2017, 54 (02) : 260 - 266
  • [49] ANALYTICAL METHOD AND RESULT OF OFF-SITE EXPOSURE DURING NORMAL OPERATION OF HIGH-TEMPERATURE ENGINEERING TEST REACTOR (HTTR)
    SAWA, K
    MIKAMI, H
    SAITO, S
    ENERGY, 1991, 16 (1-2) : 459 - 470
  • [50] Analysis on zero power experiment of high flux engineering test reactor with three-dimensional continuous energy Monte Carlo code
    Peng, Gang
    Hedongli Gongcheng/Nuclear Power Engineering, 2012, 33 (06): : 127 - 131