Faceting of Σ3 and Σ9 grain boundaries in Cu-Bi alloys

被引：31
|
作者：
Straumal, BB
Polyakov, SA
Bischoff, E
Gust, W
Baretzky, B
机构：
[1] Chernogolovka Solid State Phys Inst, Lab Interfaces Met, Chernogolovka 142432, Moscow Dist, Russia
[2] Max Planck Inst Met Res, D-70569 Stuttgart, Germany
[3] Inst Metallkunde, D-70569 Stuttgart, Germany
来源：
ACTA MATERIALIA | 2005年 / 53卷 / 02期
基金：
俄罗斯基础研究基金会;
关键词：
grain boundaries; faceting; roughening; Cu; Cu-Bi alloys; prewetting; phase diagrams;
D O I：
10.1016/j.actamat.2004.08.015
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
The faceting of Sigma3 and Sigma9 tilt grain boundaries (GBs) has been studied in bicrystals of pure Cu and Cu-Bi alloys containing 2.5 x 10(-3), 10 x 10(-3) and 16 x 10(-3) at.% Bi. The Sigma3(100), Sigma9(100), Sigma9(-110), and Sigma9(-120) facets and non-CSL Sigma3 82degrees 9R facet were observed, where Sigma is the inverse density of coincidence sites. The ratio between GB energy, sigma(GB), and surface energy, sigma(sur), was measured by atomic force microscopy using the GB thermal-groove method. The GB energy and thermal-groove deepening rate increased slightly between 0 and 10 X 10(-3) at.% Bi for all facets studied. However, between 10 X 10(-3) and 16 x 10(-3) at.% Bi the GB energy increased dramatically [from a factor 2 for the Sigma9(110) facet to 15 times larger for the Sigma3(100) facet]. The thermal-groove deepening rate also increased by a factor of 10 in this concentration range. This change corresponds well with the GB solidus line (i.e., the formation of a stable layer of a liquid-like GB phase called GB prewetting) observed previously. Wulff diagrams were constructed using measured sigma(GB)/sigma(sur) values. (C) 2004 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
引用
收藏
页码：247 / 254
页数：8
相关论文
共 50 条
  • [21] Grain-boundary melting phase transition in the Cu-Bi system
    Divinski, S
    Lohmann, M
    Herzig, C
    Straumal, B
    Baretzky, B
    Gust, W
    PHYSICAL REVIEW B, 2005, 71 (10):
  • [22] Influence of grain boundary phase transitions on the properties of Cu-Bi polycrystals
    Straumal, B.B., 2001, Scitec Publications Ltd., Zurich, Switzerland (188-190):
  • [23] Influence of grain boundary phase transitions on the properties of Cu-Bi polycrystals
    Straumal, BB
    Sluchanko, NE
    Gust, W
    DEFECTS AND DIFFUSION IN METALS III, 2001, 188-1 : 185 - 194
  • [24] Creep of Cu-Bi Alloys with High Bi Content Near and Above Melting Temperature of Bi
    Shobhit P. Singh
    Dipali Sonawane
    Praveen Kumar
    Metallurgical and Materials Transactions A, 2019, 50 : 2690 - 2701
  • [25] Creep of Cu-Bi Alloys with High Bi Content Near and Above Melting Temperature of Bi
    Singh, Shobhit P.
    Sonawane, Dipali
    Kumar, Praveen
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2019, 50A (06): : 2690 - 2701
  • [26] Faceting–roughening of twin grain boundaries
    B. B. Straumal
    B. Baretzky
    O. A. Kogtenkova
    A. S. Gornakova
    V. G. Sursaeva
    Journal of Materials Science, 2012, 47 : 1641 - 1646
  • [27] Analysis of faceting of grain boundaries in GaN
    Chen, J
    Béré, A
    Nouet, G
    Ruterana, P
    SUPERLATTICES AND MICROSTRUCTURES, 2004, 36 (4-6) : 369 - 375
  • [28] The influence of misorientation deviation on the faceting of Σ3 grain boundaries in aluminium
    Kogtenkova, O
    Straumal, B
    Protasova, S
    Tsurekawa, S
    Watanabe, T
    ZEITSCHRIFT FUR METALLKUNDE, 2005, 96 (02): : 216 - 219
  • [29] Experimental investigation and modeling of phase equilibria for Cu-Bi and Cu-Bi-Sb alloys in vacuum distillation
    Chen, Yuhu
    Yang, Bin
    Xu, Baoqiang
    Yang, HongWei
    FLUID PHASE EQUILIBRIA, 2019, 490 : 86 - 91
  • [30] Atomistic simulation of segregation in Cu-Bi system. II. Segregation-induced structural transformations at grain boundaries
    Wang, Guijin
    Vitek, V.
    Acta Metallurgica Sinica Series A, Physical Metallurgy & Materials Science, 1988, 1 (01): : 7 - 12
12345