Measuring local heat transfer by application of Rainbow Schlieren Deflectometry in case of different symmetric conditions

被引:9
|
作者
Schulz, Joschka M. [1 ]
Junne, Henning [1 ]
Boehm, Lutz [1 ]
Kraume, Matthias [1 ]
机构
[1] Tech Univ Berlin, Chair Chem & Proc Engn, Ackerstr 76, D-13355 Berlin, Germany
关键词
Rainbow Schlieren; Local heat transfer; Thermal free convection; Axisymmetric refractive index field; LAMINAR NATURAL-CONVECTION; QUANTITATIVE MEASUREMENTS; COLOR SCHLIEREN; MASS-TRANSFER; TEMPERATURE; INVERSION; FIELD; TOMOGRAPHY; ATMOSPHERE; ACCURACY;
D O I
10.1016/j.expthermflusci.2019.109887
中图分类号
O414.1 [热力学];
学科分类号
摘要
An experimental setup applying Rainbow Schlieren Deflectometry (RSD) is developed and used successfully for non-invasive measurement of thermal free convection. Tempered, solid test specimens in planar and cylindrical shapes are designed to exhibit a two-dimensional or axisymmetric temperature field. Experiments have been conducted with variation of the continuous phase and the surface temperature of the respective test specimen between 50 and 90 degrees C for air and 24-30 degrees C for water as continuous phase. To evaluate performance, surface temperature and heat transfer coefficient or Nusselt number respectively are extracted from the obtained experimental data. Quantitative validation is done by comparing RSD results with either experimental surface temperatures obtained with a PT100 sensor attached to the surface of the test specimen or with results from literature in case of the heat transfer coefficient Numerical simulations in COMSOL Multiphysics have been conducted to validate assumptions and are referred to where needed. The experimental setup is validated successfully for two-dimensional and axisymmetric refractive index fields and yields good results in case the signal-to-noise ratio is sufficient. Especially for measurements in water good accuracy is achieved due to the refractive index gradients being higher in water as continuous phase.
引用
收藏
页数:15
相关论文
共 50 条
  • [41] Local heat transfer of compressible fluid in porous media: application to the HBC fuse
    Rochette, D
    Clain, S
    INTERNATIONAL JOURNAL OF HEAT AND FLUID FLOW, 2005, 26 (02) : 322 - 333
  • [42] Comparative experimental procedures for measuring the local heat transfer coefficient during flow boiling in a microchannel
    Bortolin, Stefano
    Bortolato, Matteo
    Azzolin, Marco
    Del Col, Davide
    EXPERIMENTAL THERMAL AND FLUID SCIENCE, 2018, 90 : 231 - 245
  • [43] Modeling the turbulent heat and momentum transfer in flows under different thermal conditions
    Nagano, Y
    Hattori, H
    Abe, K
    FLUID DYNAMICS RESEARCH, 1997, 20 (1-6) : 127 - 142
  • [44] Ideal Heat Transfer Conditions for Tubular Solar Receivers with Different Design Constraints
    Kim, Jin-Soo
    Potter, Daniel
    Gardner, Wilson
    Too, Yen Chean Soo
    Padilla, Ricardo Vasquez
    INTERNATIONAL CONFERENCE ON CONCENTRATING SOLAR POWER AND CHEMICAL ENERGY SYSTEMS (SOLARPACES 2016), 2017, 1850
  • [45] Modeling the turbulent heat and momentum transfer in flows under different thermal conditions
    Dept Mechanical Eng, Nagoya Inst Technology, Gokiso-cho, Showa-ku, Nagoya 466, Japan
    Fluid Dyn Res, 1-6 (127-142):
  • [46] Heat transfer in pool boiling of propane under the conditions of different saturation pressures
    A. S. Zhuravlev
    Journal of Engineering Physics and Thermophysics, 2000, 73 (2) : 238 - 242
  • [47] An experimental study of convective heat transfer in silicon microchannels with different surface conditions
    Wu, HY
    Cheng, P
    INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2003, 46 (14) : 2547 - 2556
  • [48] Numerical Investigation of Nucleate Pool Boiling Heat Transfer for Different Superheat Conditions
    Shyamkumar, Palakkeel Irinavu
    Singh, Suneet
    Srivastava, Atul
    Visaria, Milan
    HEAT TRANSFER ENGINEERING, 2021, 43 (01) : 83 - 100
  • [49] HEAT TRANSFER CHARACTERISTICS OF VARIOUS GUN BARRELS UNDER DIFFERENT OPERATING CONDITIONS
    Gadalla, Mohamed
    Jasim, Muhammad
    Ahmad, Omar
    PROCEEDINGS OF THE ASME INTERNATIONAL MECHANICAL ENGINEERING CONGRESS AND EXPOSITION, 2019, VOL 8, 2019,
  • [50] Formation of acrylamide in biscuits during baking under different heat transfer conditions
    Schouten, Maria Alessia
    Tappi, Silvia
    Glicerina, Virginia
    Rocculi, Pietro
    Angeloni, Simone
    Cortese, Manuela
    Caprioli, Giovanni
    Vittori, Sauro
    Romani, Santina
    LWT-FOOD SCIENCE AND TECHNOLOGY, 2022, 153