A precision noise measurement and analysis method used to estimate reliability of semiconductor devices

被引:16
|
作者
Dai, YS
机构
来源
MICROELECTRONICS AND RELIABILITY | 1997年 / 37卷 / 06期
关键词
D O I
10.1016/S0026-2714(96)00117-5
中图分类号
TM [电工技术]; TN [电子技术、通信技术];
学科分类号
0808 ; 0809 ;
摘要
In this paper, some problems with previous ultra-low noise measurement methods have been discussed, then a double-channel preamplifier cross-spectrum measurement method has been adopted, different from the previous cross-correlation method [A. van der Ziel, Noise: Sources, Characterization, Measurement, p. 54. Prentice-Hall, Englewood Cliffs, NJ (1970), L. Stor, Experimental techniques in noise measurement with special emphasis on precision measurement, Proc. 10th Int. Conf: on Noise in Physical Systems, pp. 551-560. Budapest, Hungary (1989)] in that an average periodogram using a windowing procedure has been performed. The theoretical analysis shows that the expected value of the cross-spectrum is incoherent with background noise and zero-drift from the preamplifier and power supply system, the average periodogram can decrease the variance of the periodogram and the additional bias of the cross-spectrum periodogram. Experimental results demonstrate that if the equivalent input noise of measuremental set-up is two orders of magnitude lower than the noise of each preamplifier, then an ultra low noise spectrum can be measured accurately, the low limit is about 0.1 nV/root Hz at 1 kHz, which is 20 dB lower than the noise of each preamplifier. The thermal noise of a small resistance and the shot noise of a diode under forward conditions have been measured, the experimental results are in good agreement with the theoretical value, this means that this method is feasible and accurate for an ultra-low noise spectrum measurement. Finally, the noise spectrum analysis procedure based on the curve fitting method has been presented, which ensures that we obtain an accuracy value of three noise components in the semiconductor, i.e. 1/f noise, white noise and g-r noise. This noise spectrum analysis method is a useful tool for investigation of noise mechanism, the diagnosis of defects in semiconductors and reliability estimation. (C) 1997 Elsevier Science Ltd.
引用
收藏
页码:893 / 899
页数:7
相关论文
共 50 条
  • [31] Phase Noise Measurement of RF Devices using Full Digital Phase Noise Measurement Method
    Kouchi, Kazuya
    Imaike, Takeshi
    2018 IEEE INTERNATIONAL FREQUENCY CONTROL SYMPOSIUM (IFCS), 2018, : 375 - 378
  • [32] Burn-in tests for reliability assurance of semiconductor devices used in life qualified equipment
    Galateanu, L
    Baicu, F
    Boboc, D
    CAS '97 PROCEEDINGS - 1997 INTERNATIONAL SEMICONDUCTOR CONFERENCE, 20TH EDITION, VOLS 1 AND 2, 1997, : 327 - 330
  • [33] Long-term reliability evaluation of power semiconductor devices used in substation rectifiers
    Horiuchi, T
    Sugawara, Y
    ISPSD '98 - PROCEEDINGS OF THE 10TH INTERNATIONAL SYMPOSIUM ON POWER SEMICONDUCTOR DEVICES & ICS, 1998, : 195 - 198
  • [34] A novel method to estimate the parameters of 1/f noise of semiconductor laser diodes
    Zhang Zhen-Guo
    Guo Shu-Xu
    Gao Feng-Li
    Yu Si-Yao
    Li Xue-Yan
    ACTA PHYSICA SINICA, 2009, 58 (04) : 2772 - 2775
  • [35] Monte Carlo analysis of electronic noise in semiconductor materials and devices
    Reggiani, L
    Golinelli, P
    Varani, L
    Gonzalez, T
    Pardo, D
    Starikov, E
    Shiktorov, P
    Gruzinskis, V
    MICROELECTRONICS JOURNAL, 1997, 28 (02) : 183 - 198
  • [36] Extension of the characteristic potential method for noise calculation and its application to shot noise in semiconductor devices
    Hong, SM
    Min, HS
    Park, CH
    Park, YJ
    NOISE IN DEVICES AND CIRCUITS II, 2004, 5470 : 16 - 27
  • [37] TRAPPING NOISE IN SEMICONDUCTOR-DEVICES - A METHOD FOR DETERMINING THE NOISE SPECTRUM AS A FUNCTION OF THE TRAP POSITION
    LONGONI, A
    GATTI, E
    SACCO, R
    JOURNAL OF APPLIED PHYSICS, 1995, 78 (10) : 6283 - 6297
  • [38] A New Method to Estimate Failure Temperatures of Semiconductor Devices Under Electrostatic Discharge Stresses
    Miao, Meng
    Zhou, Yuanzhong
    Salcedo, Javier A.
    Hajjar, Jean-Jacques
    Liou, Juin J.
    IEEE ELECTRON DEVICE LETTERS, 2016, 37 (11) : 1477 - 1480
  • [39] RELIABILITY EVALUATION OF POWER SEMICONDUCTOR DEVICES USING COUPLED ANALYSIS SIMULATION
    Shinohara, Kazunori
    Yu, Qiang
    2010 12TH IEEE INTERSOCIETY CONFERENCE ON THERMAL AND THERMOMECHANICAL PHENOMENA IN ELECTRONIC SYSTEMS, 2010,
  • [40] PRACTICAL COMPONENT SPECIFICATION AND TEST METHOD TO INCREASE RELIABILITY OF SEMICONDUCTOR-DEVICES
    GORTON, HC
    IEEE TRANSACTIONS ON CONSUMER ELECTRONICS, 1975, 21 (04) : 356 - 360