Experimental seismic shear force amplification in scaled RC cantilever shear walls with base irregularities

RC structural slender walls under large seismic excitation are expected to reach base moment capacity mainly affected by the first vibration mode. However, the base shear could be affected by higher modes once yielding in flexure has occurred, which might result in base shear underestimation in linear design. In this work, an experimental program is carried out on five RC rectangular walls 1:10 scaled. All five specimens considered irregularities at base, common in construction and one specimen did not consider shear reinforcement or boundary detailing. Tests are carried on a unidirectional shaking table and excitation is based on two Chile earthquake records with different intensities. Damage is concentrated at the wall base for all specimens; primary due to flexure with some participation of shear. For one of the records an average amplification of 1.3 is obtained, and a decrease in height of the resultant equivalent lateral force closes to 0.4 h(w). By increasing the intensity of the input record, amplification grows to an average of 1.7, while it decreases drastically when subjected to input records with low frequency content. No significant difference is observed in shear amplification in specimens with a base central opening, nor with setback, even though the cracking and failure mode was different for such specimens. Ductility demand shows no correlation when two different earthquakes are considered, whereas the frequency content and Arias intensity (I-a) of the input record directly affected the shear amplification.