Microstructure evolution during high-strain-rate superplastic flow in Al-Ni-misch metal alloy produced from amorphous powders

被引：0
|
作者：
Umakoshi, Y [1 ]
Fujitani, W [1 ]
Nakano, T [1 ]
Inoue, A [1 ]
Ohtera, K [1 ]
Mukai, T [1 ]
Higashi, K [1 ]
机构：
[1] Osaka Univ, Fac Engn, Dept Mat Sci & Engn, Suita, Osaka 565, Japan
来源：
THERMEC '97 - INTERNATIONAL CONFERENCE ON THERMOMECHANICAL PROCESSING OF STEELS AND OTHER MATERIALS, VOLS I-II | 1997年
关键词：
D O I：
暂无
中图分类号：
TF [冶金工业];
学科分类号：
0806 ;
摘要：
Changes in microstructure and deformation substructure in Al-14mass%Ni-14mass%misch metal alloy produced from amorphous powders were investigated during superplastic deformation at a high-strain-rate of 1s(-1) at 873K. Grain refinement occurred and the frequency of small angle boundaries increased in superplastically deformed specimens. Dynamic recovery and recrystallization occurred. Dislocations were observed in grains and were annihilated at grain boundaries during superplastic deformation. High-strain-rate superplasticity was mainly controlled by grain boundary sliding. Dislocations played an important role in the accommodation of residual stress induced by the grain boundary sliding. Small precipitates of Al(3)Mm and Al3Ni effectivaly suppressed the grain growth during annealing and acted as nucleation and/or annihilation sites of dislocations.
引用
收藏
页码：1983 / 1989
页数：7
相关论文
共 50 条
  • [31] A High-Strain-Rate Superplasticity of the Al-Mg-Si-Zr-Sc Alloy with Ni Addition
    Mochugovskiy, Andrey
    Kotov, Anton
    Esmaeili Ghayoumabadi, Majid
    Yakovtseva, Olga
    Mikhaylovskaya, Anastasia
    MATERIALS, 2021, 14 (08)
  • [32] Microstructure and texture evolution during high-strain-rate superplastic deformation of coarse-grained Mg-Gd-Y-Zr rolled sheet
    Li Li
    Zhang Xin-ming
    TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA, 2011, 21 (07) : 1491 - 1497
  • [33] MECHANICAL-PROPERTIES OF AN AL88.5NI8MM3.5 (MM, MISCH METAL) ALLOY PRODUCED BY EXTRUSION OF ATOMIZED AMORPHOUS PLUS FCC-AL PHASE POWDERS
    OHTERA, K
    INOUE, A
    TERABAYASHI, T
    NAGAHAMA, H
    MASUMOTO, T
    MATERIALS TRANSACTIONS JIM, 1992, 33 (08): : 775 - 781
  • [34] CHANGES IN MICROSTRUCTURE DURING HIGH STRAIN RATE SUPERPLASTIC DEFORMATION OF AN Al-Zn-Mg-Cu-Zr ALLOY CONTAINING Sc
    Mukhopadhyay, A. K.
    Prasad, K. S.
    Kumar, A.
    Raveendra, S.
    Samajdar, I.
    PROCEEDINGS OF THE 13TH INTERNATIONAL CONFERENCE ON ALUMINUM ALLOYS (ICAA13), 2012, : 819 - 824
  • [35] Precipitation Behavior during Aging Operations in an Ultrafine-Grained Al-Cu-Mg Alloy Produced by High-Strain-Rate Processing
    Zhang, Linyan
    Luo, Hongyun
    MATERIALS, 2022, 15 (23)
  • [36] Microstructural characteristics and evolution mechanisms of 90W?Ni?Fe alloy under high-strain-rate deformation
    Zhang, Lei
    Chen, Xun
    Huang, Yufeng
    Liu, Wensheng
    Ma, Yunzhu
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2021, 811
  • [37] Microstructure Evolution and Mechanical Properties of Dual-Phase AlCrFe2Ni2 High-Entropy Alloy Under High-Strain-Rate Compression
    Yan, Hang
    Wang, Yu
    Gan, Xilin
    Dong, Yong
    Liu, Shichao
    Duan, Shougang
    Mao, Lingbo
    MATERIALS, 2025, 18 (06)
  • [38] Nanoscale phase separation and microstructure evolution during crystallization in Al-Si-Ni amorphous alloy
    Hyun, J., I
    Kim, C., I
    Nam, S. W.
    Kim, W. T.
    Kim, D. H.
    MATERIALS & DESIGN, 2020, 192
  • [39] READILY SUPERPLASTIC FORGING AT HIGH-STRAIN RATES IN AN ALUMINUM-BASED ALLOY PRODUCED FROM NANOCRYSTALLINE POWDERS
    TAKETANI, K
    UOYA, A
    OHTERA, K
    UEHARA, T
    HIGASHI, K
    INOUE, A
    MASUMOTO, T
    JOURNAL OF MATERIALS SCIENCE, 1994, 29 (24) : 6513 - 6517
  • [40] The role of liquid phase in cavitation and fracture in high-strain-rate superplastic Si3N4p/Al alloy composite
    Iwasaki, H
    Mabuchi, M
    Higashi, K
    TOWARDS INNOVATION IN SUPERPLASTICITY II, 1999, 304-3 : 645 - 650
12345