Microstructure evolution during high-strain-rate superplastic flow in Al-Ni-misch metal alloy produced from amorphous powders

被引：0

作者：

Umakoshi, Y ^{[1
]}

Fujitani, W ^{[1
]}

Nakano, T ^{[1
]}

Inoue, A ^{[1
]}

Ohtera, K ^{[1
]}

Mukai, T ^{[1
]}

Higashi, K ^{[1
]}

机构：

[1] Osaka Univ, Fac Engn, Dept Mat Sci & Engn, Suita, Osaka 565, Japan

来源：

THERMEC '97 - INTERNATIONAL CONFERENCE ON THERMOMECHANICAL PROCESSING OF STEELS AND OTHER MATERIALS, VOLS I-II | 1997年

关键词：

D O I：

暂无

中图分类号：

TF [冶金工业];

学科分类号：

0806 ;

摘要：

Changes in microstructure and deformation substructure in Al-14mass%Ni-14mass%misch metal alloy produced from amorphous powders were investigated during superplastic deformation at a high-strain-rate of 1s(-1) at 873K. Grain refinement occurred and the frequency of small angle boundaries increased in superplastically deformed specimens. Dynamic recovery and recrystallization occurred. Dislocations were observed in grains and were annihilated at grain boundaries during superplastic deformation. High-strain-rate superplasticity was mainly controlled by grain boundary sliding. Dislocations played an important role in the accommodation of residual stress induced by the grain boundary sliding. Small precipitates of Al(3)Mm and Al3Ni effectivaly suppressed the grain growth during annealing and acted as nucleation and/or annihilation sites of dislocations.

引用

页码：1983 / 1989

页数：7

共 50 条

[1] HIGH-STRAIN RATE SUPERPLASTICITY IN AN AL-NI-MISCH METAL ALLOY PRODUCED FROM ITS AMORPHOUS POWDERS
HIGASHI, K
MUKAI, T
TANIMURA, S
INOUE, A
MASUMOTO, T
KITA, K
OHTERA, K
NAGAHORA, J
SCRIPTA METALLURGICA ET MATERIALIA, 1992, 26 (02): : 191 - 196
[2] The role of dislocations in high-strain-rate superplasticity of an Al-Ni-misch metal alloy
Umakoshi, Y
Fujitani, W
Nakano, T
Inoue, A
Ohtera, K
Mukai, T
Higashi, K
ACTA MATERIALIA, 1998, 46 (13) : 4469 - 4478
[3] Evolution in microstructure and superplastic flow at high-strain-rate in dynamically recrystallized aluminum alloy
Hirata, T
Mukai, T
Saito, N
Kohzu, M
Tanabe, S
Higashi, K
JAPAN INSTITUTE OF METALS, PROCEEDINGS, VOL 12, (JIMIC-3), PTS 1 AND 2: SOLID - SOLID PHASE TRANSFORMATIONS, 1999, : 289 - 292
[4] Microstructural dynamics during high-strain-rate superplastic flow in PM 7475 alloy
Hirata, T
Mukai, T
Saito, N
Kohzu, M
Tanabe, S
Higashi, K
TOWARDS INNOVATION IN SUPERPLASTICITY II, 1999, 304-3 : 333 - 338
[5] Mechanisms of high strain-rate superplasticity of Al-14 mass%Ni-14 mass%Mm (misch metal) alloy produced from amorphous powder
Higashi, Kenji
Mukai, Toshiji
Uoya, Akihiro
Inoue, Akihisa
Masumoto, Tsuyoshi
Materials Transactions, JIM, 1995, 36 (12): : 1467 - 1475
[6] Mechanisms of high strain-rate superplasticity of Al-14 mass%Ni-14 mass%Mm (Misch metal) alloy produced from amorphous powder
Higashi, K
Mukai, T
Uoya, A
Inoue, A
Masumoto, T
MATERIALS TRANSACTIONS JIM, 1995, 36 (12): : 1467 - 1475
[7] Microstructure evolution of 2195 Al-Li alloy subjected to high-strain-rate deformation
Yang, Yang
Ma, Fei
Hu, Hai Bo
Zhang, Qing Ming
Zhang, Xiao Wei
Materials Science and Engineering: A, 2014, 606 : 299 - 303
[8] Microstructure evolution of 2195 Al-Li alloy subjected to high-strain-rate deformation
Yang, Yang
Ma, Fei
Hu, Hai Bo
Zhang, Qing Ming
Zhang, Xiao Wei
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2014, 606 : 299 - 303
[9] The mechanisms of the high-strain-rate superplastic deformation of Al-Mg-based alloy
Yakovtseva, O.A.
Kishchik, A.A.
Cheverikin, V.V.
Kotov, A.D.
Mikhaylovskaya, A.V.
Materials Letters, 2022, 325
[10] Application to seismic dampers in high-strain-rate superplastic Zn-Al alloy
Kushibe, A
Makii, K
Chiang, LF
Tanaka, T
Kohzu, M
Higashi, K
PRICM 5: THE FIFTH PACIFIC RIM INTERNATIONAL CONFERENCE ON ADVANCED MATERIALS AND PROCESSING, PTS 1-5, 2005, 475-479 : 3055 - 3060

← 1 2 3 4 5 →