Influence of morphology on photo-degradation of low density polyethylene films

The effect of the morphology on photo-degradation was investigated for low-density polyethylene materials. For this purpose, films with different degrees of crystallinity and different degrees of orientation were prepared. For all the films, photodegradation was promoted at 336K for 12 days using a weather meter. The following results were obtained. There existed an induction period before degradation or chain scission. The induction period was longer for stretched films than for un-stretched ones. Also, the rate of degradation became lower for stretched films. However, both the induction period and the rate of degradation hardly changed with heat-treatment condition, that is, the degree of crystallinity. In the induction period, the density changed in a complicated manner. This complicated change must be due to the change in the molecular aggregation state of the amorphous phase. The rheological and GPC measurements indicated that photo-degradation causes the lowering of molecular weight and the increase in higher molecular weight fraction, and consequently the broadening of molecular weight distribution. The lowering of molecular weight may be caused by chain scission and the increase in higher molecular weight fraction by the formation of crosslinks.