Experimental study of a capillary pumped loop in comparison with the prediction of a 3D CFD

A comparison is presented between experimental and numerical results regarding the operation of a capillary pumped loop evaporator. Two cylindrical evaporators were tested, with different heated porous lengths, 20 and 40 mm, respectively. Both have 22 mm external diameter, 9 mm porous thickness and 80 mm porous length. The working liquid was water. The loop was made from copper tubes and the evaporator from copper porous wick covered with aluminum with grooves formed in the inner surface. All tests took place on a horizontal level using heat load applied to the evaporator surface from an 85-W electric resistance. The experimental measurements were compared with the predictions of a three-dimensional CFD model of the evaporator and were found to be in satisfactory agreement. For the 20-mm wick heated length evaporator CFD model with water initial temperature of 20 degrees C the divergence with the experimental pressure drop mean value was 0 Pa for volume flow rates between 0.4 and 0.6 l/min and 50 Pa for the rest of the values. For 30 degrees C the divergence was 0 Pa,0.4 l/min and 50 Pa for larger flow rates. Moreover, for 40 degrees C the difference was up to 50 Pa from 0 to 0.9 l/min. In every case predictions were below the wick capillary limit. The computed outflow temperature presented a maximum difference of 1.5% compared with the experimental data, which is very satisfying. On the other hand, the predictions of the evaporator CFD model with a 40-mm wick heated length were even better.