Electrochemical degradation of RS-5 dye by anodic oxidation, electro-Fenton and by combining anodic oxidation-electro-Fenton in a filter-press flow cell

被引:65
|
作者
Vasconcelos, V. M. [1 ]
Ponce-de-Leon, C. [2 ]
Nava, J. L. [3 ]
Lanza, M. R. V. [1 ]
机构
[1] Univ Sao Paulo, Inst Quim Sao Carlos, BR-13563120 Sao Carlos, SP, Brazil
[2] Univ Southampton, Fac Engn & Environm, Southampton SO17 1BJ, Hants, England
[3] Univ Guanajuato, Dept Ingn Geomat & Hidraul, Ave Juarez 77, Guanajuato 36000, Mexico
基金
巴西圣保罗研究基金会;
关键词
Boron-doped diamond; Electrochemical oxidation; Electro-Fenton process; Filter-press flow cell; Reactive Black 5 dye; Reticulated vitreous carbon; BORON-DOPED DIAMOND; REACTIVE BLACK 5; RETICULATED VITREOUS CARBON; TEXTILE DYES; WASTE-WATER; ORGANIC POLLUTANTS; HYDROXYL RADICALS; AZO-DYE; WASTEWATERS; REDUCTION;
D O I
10.1016/j.jelechem.2015.07.040
中图分类号
O65 [分析化学];
学科分类号
070302 ; 081704 ;
摘要
This paper reports the removal of a recalcitrant and toxic dye, Reactive Black 5 (RB-5) by three methods; 1) anodic oxidation (AO) on Boron-Doped Diamond (BDD), 2) by electro-Fenton (EF) process where hydrogen peroxide was produced by oxygen reduction on reticulated vitreous carbon (RVC) electrodes and 3) by the combination of AO-EF. The BDD and RVC electrodes were fitted in a filter-press flow cell in recyde batch mode of operation. The experimental set-up for the AO and EF processes consisted of two electrolyte compartments separated by a Nafion membrane with the dye contained in the anolyte and the catholyte, respectively. The combined AO-EF process used only one electrolyte compartment. The colour and total organic carbon (TOC) removal were more efficient when the AO and EF processes were used separately than the combined process, AO-EF. The influence of current density and initial concentration of ferrous ions were examined. The lowest energy efficiency (208 kWh kg(-1)) with the EF process was found when -0.4 V vs. Ag/AgCl was applied to a RVC electrode and the concentration of Fe2+ was 1.0 x 10(-4) mol dm(-3) achieving total colour and 74% of TOC removals in less than 90 min electrolysis. All proposed processes were able to promote high percentages of TOC removal following a pseudo-first order kinetic oxidation. The BDD electrode was the most effective material to remove RB-5 dye within 7.5 min and presented the highest apparent rate constant (0.835 min(-1)) with 82% TOC removal within 30 min at an energy consumption of 291 kWh kg -I and 41.1 mA cm(-2) current density. In the case of the combined process AO-EF the electrodegradation rate of RB-5 was at least three times lower, apparent rate constant (0.269 min(-1)), and 32% of TOC was removed with a high EC (682 kWh kg(-1)). Therefore oxidation process applied separately was more efficient. (C) 2015 Elsevier B.V. All rights reserved.
引用
收藏
页码:179 / 187
页数:9
相关论文
共 50 条
  • [41] Fenton and electro-Fenton methods for oxidation of H-acid and Reactive Black 5
    Rao, NN
    Bose, G
    Khare, P
    Kaul, SN
    [J]. JOURNAL OF ENVIRONMENTAL ENGINEERING, 2006, 132 (03) : 367 - 376
  • [42] Degradation of 2,4-dichlorophenoxyacetic acid by anodic oxidation and electro-Fenton using BDD anode: Influencing factors and mechanism
    Cai, Jingju
    Zhou, Minghua
    Pan, Yuwei
    Lu, Xiaoye
    [J]. SEPARATION AND PURIFICATION TECHNOLOGY, 2020, 230
  • [43] High-efficiency refractory organic pollutants removal boosted by combining heterogeneous electro-Fenton with electrochemical anodic oxidation over a broad pH range
    Wang, Kaixuan
    Qin, Xin
    Cao, Peike
    Chen, Shuo
    Yu, Hongtao
    Quan, Xie
    [J]. PROCESS SAFETY AND ENVIRONMENTAL PROTECTION, 2023, 177 : 635 - 642
  • [44] Degradation of the herbicide 2,4-DP by anodic oxidation, electro-Fenton and photoelectro-Fenton using platinum and boron-doped diamond anodes
    Brillas, Enric
    Angel Banos, Miguel
    Skoumal, Marcel
    Lluis Cabot, Pere
    Antonio Garrido, Jose
    Maria Rodriguez, Rosa
    [J]. CHEMOSPHERE, 2007, 68 (02) : 199 - 209
  • [45] Salicylic acid degradation and mineralization by coupling advanced oxidation processes: Photo electro Fenton, anodic oxidation and heterogeneous photocatalysis
    Garza, Benjamin
    El-Ghenymy, Abdellatif
    Brillas, Enric
    Hernandez-Ramirez, Aracely
    Ruiz, Edgar
    [J]. ABSTRACTS OF PAPERS OF THE AMERICAN CHEMICAL SOCIETY, 2015, 250
  • [46] Phenol degradation by advanced electrochemical oxidation process electro-Fenton using a carbon felt cathode
    Pimentel, Marcio
    Oturan, Nihal
    Dezotti, Marcia
    Oturan, Mehmet A.
    [J]. APPLIED CATALYSIS B-ENVIRONMENTAL, 2008, 83 (1-2) : 140 - 149
  • [47] Comparative study of oxidation of dye-Reactive Black B by different advanced oxidation processes: Fenton, electro-Fenton and photo-Fenton
    Huang, Yao-Hui
    Huang, Yi-Fong
    Chang, Po-Shun
    Chen, Chuh-Yung
    [J]. JOURNAL OF HAZARDOUS MATERIALS, 2008, 154 (1-3) : 655 - 662
  • [48] Acetaminophen degradation by electro-Fenton and photoelectro-Fenton using a double cathode electrochemical cell
    de Luna, Mark Daniel G.
    Veciana, Mersabel L.
    Su, Chia-Chi
    Lu, Ming-Chun
    [J]. JOURNAL OF HAZARDOUS MATERIALS, 2012, 217 : 200 - 207
  • [49] Comparative use of anodic oxidation, electro-Fenton and photoelectro-Fenton with Pt or boron-doped diamond anode to decolorize and mineralize Malachite Green oxalate dye
    El-Ghenymy, Abdellatif
    Centellas, Francesc
    Maria Rodriguez, Rosa
    Lluis Cabot, Pere
    Antonio Garrido, Jose
    Sires, Ignasi
    Brillas, Enric
    [J]. ELECTROCHIMICA ACTA, 2015, 182 : 247 - 256
  • [50] A Comparative Analysis of 2-(Thiocyanomethylthio)-Benzothiazole Degradation Using Electro-Fenton and Anodic Oxidation on a Boron-Doped Diamond Electrode
    Vazquez, Armando
    Alvarado, Lucia
    Lazaro, Isabel
    Cruz, Roel
    Nava, Jose Luis
    Rodriguez-Torres, Israel
    [J]. INTERNATIONAL JOURNAL OF PHOTOENERGY, 2018, 2018