Selective Area Modification of Silicon Surface Wettability by Pulsed UV Laser Irradiation in Liquid Environment

被引:1
|
作者
Liu, Neng [1 ]
Moumanis, Khalid [1 ]
Dubowski, Jan J. [1 ]
机构
[1] Univ Sherbrooke, Lab Quantum Semicond & Photon Based BioNanotechno, Interdisciplinary Inst Technol Innovat, LN2,CNRS UMI 3463, Sherbrooke, PQ J1K 2R1, Canada
来源
关键词
Engineering; Issue; 105; Silicon; surface wettability; laser-surface interaction; selective area processing; excimer laser; X-ray photoelectron spectroscopy; contact angle; INP/INGAAS/INGAASP MICROSTRUCTURES; WAFER; PHOTOELECTRON; MECHANISMS; ROUGHNESS; EMISSION; GRADIENT; ADHESION; WATER; FILM;
D O I
10.3791/52720
中图分类号
O [数理科学和化学]; P [天文学、地球科学]; Q [生物科学]; N [自然科学总论];
学科分类号
07 ; 0710 ; 09 ;
摘要
The wettability of silicon (Si) is one of the important parameters in the technology of surface functionalization of this material and fabrication of biosensing devices. We report on a protocol of using KrF and ArF lasers irradiating Si (001) samples immersed in a liquid environment with low number of pulses and operating at moderately low pulse fluences to induce Si wettability modification. Wafers immersed for up to 4 hr in a 0.01% H2O2/H2O solution did not show measurable change in their initial contact angle (CA) similar to 75 degrees. However, the 500-pulse KrF and ArF lasers irradiation of such wafers in a microchamber filled with 0.01% H2O2/H2O solution at 250 and 65 mJ/cm(2), respectively, has decreased the CA to near 15 degrees, indicating the formation of a superhydrophilic surface. The formation of OH-terminated Si (001), with no measurable change of the wafer's surface morphology, has been confirmed by X-ray photoelectron spectroscopy and atomic force microscopy measurements. The selective area irradiated samples were then immersed in a biotin-conjugated fluorescein-stained nanospheres solution for 2 hr, resulting in a successful immobilization of the nanospheres in the non-irradiated area. This illustrates the potential of the method for selective area biofunctionalization and fabrication of advanced Si-based biosensing architectures. We also describe a similar protocol of irradiation of wafers immersed in methanol (CH3OH) using ArF laser operating at pulse fluence of 65 mJ/cm(2) and in situ formation of a strongly hydrophobic surface of Si (001) with the CA of 103 degrees. The XPS results indicate ArF laser induced formation of Si-(OCH3)(x) compounds responsible for the observed hydrophobicity. However, no such compounds were found by XPS on the Si surface irradiated by KrF laser in methanol, demonstrating the inability of the KrF laser to photodissociate methanol and create -OCH3 radicals.
引用
收藏
页数:10
相关论文
共 50 条
  • [31] Pulsed UV laser irradiation of polymer surfaces
    J Photochem Photobiol A Chem, (129):
  • [32] Surface modification of LDPE film by CO2 pulsed laser irradiation
    Dadbin, S
    EUROPEAN POLYMER JOURNAL, 2002, 38 (12) : 2489 - 2495
  • [33] Effect of liquid environment on the titanium surface modification by laser ablation
    Ali, Nisar
    Bashirc, Shazia
    Umm-i-Kalsoom
    Begum, Narjis
    Rafique, Muhammad Shahid
    Husinsky, Wolfgang
    APPLIED SURFACE SCIENCE, 2017, 405 : 298 - 307
  • [34] Modification of the surface state and doping of CdTe and CdZnTe crystals by pulsed laser irradiation
    Gnatyuk, V. A.
    Aoki, T.
    Vlasenko, O. I.
    Levytskyi, S. N.
    Dauletmuratov, B. K.
    Lambropoulos, C. P.
    APPLIED SURFACE SCIENCE, 2009, 255 (24) : 9813 - 9816
  • [35] SURFACE MODIFICATION OF POLYMER FIBERS BY UV LASER IRRADIATION .11. SURFACE MODIFICATION OF POLYPROPYLENE FIBERS AND FABRIC
    KESTING, W
    KNITTEL, D
    SCHOLLMEYER, E
    ANGEWANDTE MAKROMOLEKULARE CHEMIE, 1991, 191 : 145 - 161
  • [36] Observation of liquid carbon on diamond films under pulsed IR and UV laser irradiation
    Tosin, P.
    Luethy, W.
    Weber, H. P.
    Physical Review B: Condensed Matter, 53 (02):
  • [37] Observation of liquid carbon on diamond films under pulsed IR and UV laser irradiation
    Tosin, P
    Luthy, W
    Weber, HP
    PHYSICAL REVIEW B, 1996, 53 (02): : 543 - 546
  • [38] FAR UV PULSED LASER MELTING OF SILICON
    GORODETSKY, G
    KANICKI, J
    KAZYAKA, T
    MELCHER, RL
    APPLIED PHYSICS LETTERS, 1985, 46 (06) : 547 - 549
  • [39] Surface structuring of polymer fibers by UV laser irradiation, 15 - Description of the temperature field in PETP polymers during and after laser irradiation with a pulsed UV laser
    Cleve, E
    Schollmeyer, H
    Schlosser, U
    Schollmeyer, E
    ANGEWANDTE MAKROMOLEKULARE CHEMIE, 1999, 270 : 87 - 93
  • [40] Pulsed Laser Patterned Copper Surface with Tunable Wettability
    Zhou, Rui
    Lin, Shengdong
    Shen, Fei
    Zhang, Guobiao
    Li, Xiaoguang
    Li, Kui
    2017 CONFERENCE ON LASERS AND ELECTRO-OPTICS PACIFIC RIM (CLEO-PR), 2017,