Design of "double layer" texture to obtain superhydrophobic and high wear-resistant PTFE coatings on the surface of Al2O3/Ni layered ceramics

被引：42

作者：

Fan, Hengzhong ^{[1
]}

Su, Yunfeng ^{[1
]}

Song, Junjie ^{[1
]}

Wan, Hongqi ^{[1
]}

Hu, Litian ^{[1
]}

Zhang, Yongsheng ^{[1
]}

机构：

[1] Chinese Acad Sci, Lanzhou Inst Chem Phys, State Key Lab Solid Lubricat, Lanzhou 730000, Gansu, Peoples R China

来源：

TRIBOLOGY INTERNATIONAL | 2019年 / 136卷

基金：

中国国家自然科学基金;

关键词：

Al2O3/Ni layered ceramics; Bonded PTFE coating; Double texture; Superhydrophobic and wear-resistant; COMPOSITION-LUBRICATION DESIGN; TRIBOLOGICAL PROPERTIES; MECHANICAL-PROPERTIES; LAMINATED COMPOSITES; MG ALLOY; BEHAVIORS; PERFORMANCE; FABRICATION; FRICTION;

D O I：

10.1016/j.triboint.2019.04.004

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

Solid lubricating polytetrafluoroethylene (PTFE) coating was designed to have a "double layer" texture after being sprayed on the untextured and textured surface of Al2O3/Ni layered ceramics. Surface texture of PTFE coating with smaller diameter and higher density showed excellent superhydrophobicity. Laser caused defluorinated and enhanced hardness of the PTFE coating. Meanwhile, Solid lubricants embedded in micro-dimples of substrate surface act as "mechanical self-locking" roles, which increase the surface contact area and provided a secondary lubricating effect, thus significantly increase the wear life of the coatings. Contact angle and wear life of the optimized "double layer" texture PTFE coatings could reach 160 degrees and 1.6 x 10(4) s, which are about 2.0 and 5.0 times higher comparing to untextured smooth PTFE coatings surface, respectively.

引用

页码：455 / 461

页数：7

共 50 条

[21] Development of Wear Resistant Coatings Formed by Plasma Spraying of Alloy Ni-Fe-Cr-Si-B-C System Reinforced with Ceramics Al2O3
Kalinichenko, A. S.
Devoino, O. G.
Meshkova, V. V.
SCIENCE & TECHNIQUE, 2016, 15 (05): : 365 - 370
[22] Trying out spraying modes and properties of wear-resistant flame Al2O3–TiO2 coatings fabricated using a flexible cord material
A. S. Anikeev
I. V. Blinkov
V. V. Ivanov
A. I. Laptev
V. S. Chelnokov
I. Yu. Kuchina
Russian Journal of Non-Ferrous Metals, 2017, 58 : 449 - 455
[23] Microstructure and tribological properties of laser clad CaF2/Al2O3 self-lubrication wear-resistant ceramic matrix composite coatings
Wang, HM
Yu, YL
Li, SQ
SCRIPTA MATERIALIA, 2002, 47 (01) : 57 - 61
[24] Friction-reduction and wear-resistant behavior of graphite in gray cast iron sliding against Al2O3 ceramics under different conditions
Si, S.H.
Fang, L.
Mocaxue Xuebao/Tribology, 2001, 21 (02): : 154 - 156
[25] Effect of duty ratio on the performance of pulsed electrodeposition Ni–P–Al2O3–PTFE nanocomposite coatings
Yongfeng Li
Long Zheng
Mengyu Liu
Zhipeng Qu
Xiaochang Xu
Yaqi Zhang
Mingming Zhang
Hongjiang Han
Zongju Yang
Applied Physics A, 2022, 128
[26] Microstructure and tribological properties of laser clad CaF2/Al2O3 self-lubrication wear-resistant ceramic matrix composite coatings
Wang, H.M.
Yu, Y.L.
Li, S.Q.
Yingyong Jiguang/Applied Laser Technology, 2002, 22 (02):
[27] Wear-resistant and stable low-friction nanodiamond composite superhard coatings against Al2O3 counter-body in dry condition
Diab, Mohamed Ragab
Murasawa, Koki
Ibrahim, Ahmed Mohamed Mahmoud
Naragino, Hiroshi
Yoshitake, Tsuyoshi
Egiza, Mohamed
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS, 2025, 126
[28] FRICTION AND WEAR REDUCTION OF AL2O3 CERAMICS BY LASER-INDUCED SURFACE ALLOYING
ZUMGAHR, KH
BOGDANOW, C
SCHNEIDER, J
WEAR, 1995, 181 : 118 - 128
[29] Force Analysis of the Stress-Strain State of the Surface Layer of Al2O3–TiC Ceramics with AlN and TiN Coatings
V. V. Kuzin
M. A. Volosova
M. Yu. Fedorov
Refractories and Industrial Ceramics, 2021, 62 : 355 - 360
[30] Combined Analysis of the Stress-Strain State of Al2O3–TiC Ceramics Surface Layer with AlN and TiN Coatings
V. V. Kuzin
M. A. Volosova
M. Yu. Fedorov
Refractories and Industrial Ceramics, 2021, 62 : 439 - 443

← 1 2 3 4 5 →