Mathematical modelling of solid oxide fuel cell using Matlab/Simulink

被引：0

作者：

Lakshmi, T. V. V. S. ^{[1
]}

Geethanjali, P. ^{[1
]}

Prasad, Krishna ^{[1
]}

机构：

[1] VIT Univ, Sch Elect Engn, Vellore, Tamil Nadu, India

来源：

2013 ANNUAL INTERNATIONAL CONFERENCE ON EMERGING RESEARCH AREAS & 2013 INTERNATIONAL CONFERENCE ON MICROELECTRONICS, COMMUNICATIONS & RENEWABLE ENERGY (AICERA/ICMICR) | 2013年

关键词：

Solid Oxide Fuel Cell; simulation; transfer function model;

D O I：

暂无

中图分类号：

TE [石油、天然气工业]; TK [能源与动力工程];

学科分类号：

0807 ; 0820 ;

摘要：

This paper explicates a phenomenal approach for computer modeling of a single cell solid oxide fuel cell where transfer function model is implemented for the calculation of partial pressures of hydrogen, oxygen and water. Activation, concentration and ohmic losses are also considered to obtain better characteristics of fuel cell. Steady state characteristics of fuel cell are obtained at different fuel flow rates ranging from 31ml/sec to 51ml/sec at two different operating temperatures 800 degrees C and 850 degrees C. It is observed that the limiting current density of fuel cell increases with the increase in fuel flow rate. Results are validated with the experimental data. The software that has been incorporated in designing is MATLAB/SIMULINK.

引用

页数：5

共 50 条

[1] MODELLING THE INFLUENCE OF FUEL COMPOSITION ON SOLID OXIDE FUEL CELL BY USING THE ADVANCED MATHEMATICAL MODEL
Milewski, Jaroslaw
Badyda, Krzysztof
Miller, Andrzej
RYNEK ENERGII, 2010, (03): : 159 - 163
[2] Improved Mathematical Modelling for PV Module using MATLAB/Simulink
Sahoo, Rakesh Ranjan
Singh, Madhu
2016 3RD INTERNATIONAL CONFERENCE ON ELECTRICAL ENERGY SYSTEMS (ICEES), 2016, : 195 - 200
[3] Mathematical Modelling and Simulation of Photovoltaic Module using MATLAB/SIMULINK
Yadav, Nupur
Sambariya, D. K.
2018 9TH INTERNATIONAL CONFERENCE ON COMPUTING, COMMUNICATION AND NETWORKING TECHNOLOGIES (ICCCNT), 2018,
[4] Mathematical Modelling of Transport and Reaction in an Innovative Solid Oxide Fuel Cell
Bertei, Antonio
Nicolella, Cristiano
Thorel, Alain S.
ICHEAP-10: 10TH INTERNATIONAL CONFERENCE ON CHEMICAL AND PROCESS ENGINEERING, PTS 1-3, 2011, 24 : 127 - +
[5] Mathematical Design and Analysis of Photovoltaic Cell Using MATLAB/Simulink
Basha, C. H. Hussaian
Rani, C.
Brisilla, R. M.
Odofin, S.
SOFT COMPUTING FOR PROBLEM SOLVING, SOCPROS 2018, VOL 1, 2020, 1048 : 711 - 726
[6] Modelling and Analysis of a Fuel Cell Emulator for Integration in a Hybrid Photovoltaic System Using MATLAB-Simulink
Rudra, Aaditya
Kulkarni, P. S.
Sneha, Tabitha
Ghosh, Soumyadeep
10TH INTERNATIONAL CONFERENCE ON ELECTRONICS, COMPUTING AND COMMUNICATION TECHNOLOGIES, CONECCT 2024, 2024,
[7] Mathematical approaches to modelling the mass transfer process in solid oxide fuel cell anode
Blesznowski, Marcin
Sikora, Monika
Kupecki, Jakub
Makowski, Lukasz
Orciuch, Wojciech
ENERGY, 2022, 239
[8] Mathematical modelling and simulation of a solar water heater for an aviculture unit using MATLAB/SIMULINK
Nezhad, Mohammad Esmaeil Yousef
Hoseinzadeh, Siamak
JOURNAL OF RENEWABLE AND SUSTAINABLE ENERGY, 2017, 9 (06)
[9] Modelling and simulation of a SCARA robot using solid dynamics and verification by MATLAB/Simulink
Alshamasin, Mahdi Salman
Ionescu, Florin
Al-Kasasbeh, Riad Taha
INTERNATIONAL JOURNAL OF MODELLING IDENTIFICATION AND CONTROL, 2012, 15 (01) : 28 - 38
[10] Modelling of a Monolithic Solid Oxide Fuel Cell
Williams, G. J.
Chen, Y. K.
Bhinder, F. S.
ADVANCED ENGINEERING MATERIALS III, PTS 1-3, 2013, 750-752 : 1718 - 1733

← 1 2 3 4 5 →