Experimental study of convective heat transfer from in-line cam shaped tube bank in crossflow

被引：63

作者：

Lavasani, Arash Mirabdolah ^{[1
]}

Bayat, Hamidreza ^{[2
]}

Maarefdoost, Taher ^{[2
]}

机构：

[1] Islamic Azad Univ, Cent Tehran Branch, Dept Mech Engn, Tehran, Iran

[2] Islamic Azad Univ, Cent Tehran Branch, Young Researchers & Elite Club, Tehran, Iran

来源：

APPLIED THERMAL ENGINEERING | 2014年 / 65卷 / 1-2期

关键词：

Experimental; Cam shaped; Tube bank; Heat transfer; Crossflow; FORCED-CONVECTION; ELLIPTIC TUBES; PRESSURE-DROP; EXCHANGER; PERFORMANCE; CYLINDERS; OPTIMIZATION; BUNDLES;

D O I：

10.1016/j.applthermaleng.2013.12.078

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

Heat transfer from cam-shaped tube bank has been studied experimentally. Tubes were mounted in an in-line arrangement with two longitudinal pitch ratios 1.5 and 2. Reynolds number based on equivalent diameter varied in range of 27,000 <= Re-D <= 42,500. Drag coefficient and heat transfer from tubes in second row were obtained. Results show that drag coefficient and heat transfer of cam shaped tubes depend on position of tubes in tube bank. Tubes that located at first and second column have the maximum and minimum value of drag coefficient, respectively. In addition, Heat transfer from subsequent tubes is greater than tube in first column. Thermal hydraulic performance of cam shape tube is about 6 times greater than circular tube with same equivalent diameter. (C) 2014 Elsevier Ltd. All rights reserved.

引用

页码：85 / 93

页数：9

共 50 条

[1] Numerical investigation of heat transfer and friction factor characteristics from in-line cam shaped tube bank in crossflow
Mangrulkar, Chidanand K.
Dhoble, Ashwinkumar S.
Deshmukh, Amey R.
Mandavgane, Sachin A.
APPLIED THERMAL ENGINEERING, 2017, 110 : 521 - 538
[2] CROSSFLOW AND HEAT TRANSFER CHARACTERISTICS ACROSS A CAM-SHAPED TUBE BANK: A NUMERICAL STUDY
Petinrin, M. O.
Sikirullahi, B. A.
Olugasa, T. T.
Oyewola, O. M.
FRONTIERS IN HEAT AND MASS TRANSFER, 2022, 19
[3] Effect of longitudinal pitch on convective heat transfer in crossflow over in-line tube banks
Kim, Taewan
ANNALS OF NUCLEAR ENERGY, 2013, 57 : 209 - 215
[4] Experimental and numerical study of convective heat transfer in-line tube bundle by acoustic action
Yu, Miao
Jiang, Genshan
Jiang, Yu
Liu, Yuechao
Zhang, Wei
Sun, Jianhao
CASE STUDIES IN THERMAL ENGINEERING, 2023, 44
[5] AN EXPERIMENTAL STUDY OF AIR FLOW AND HEAT TRANSFER OVER IN-LINE FLAT TUBE BANK
Tahseen, Tahseen Ahmad
Rahman, M. M.
Ishak, M.
INTERNATIONAL JOURNAL OF AUTOMOTIVE AND MECHANICAL ENGINEERING, 2014, 9 : 1487 - 1500
[6] A Numerical Study of Heat Transfer and Fluid Flow Over an In-line Tube Bank
Abdel-Rehim, Z. S.
ENERGY SOURCES PART A-RECOVERY UTILIZATION AND ENVIRONMENTAL EFFECTS, 2012, 34 (22) : 2123 - 2136
[7] Experimental study of forced convection heat transfer from a cam shaped tube in cross flows
Nouri-Borujerdi, A.
Lavasani, A. M.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2007, 50 (13-14) : 2605 - 2611
[8] Experimental study of heat transfer from in-line tube bundles to upward foam flow
Gylys, J.
Gabrielaitiene, I.
Zdankus, T.
Sinkunas, S.
Maladauskas, R.
ADVANCES IN FLUID MECHANICS VII, 2008, 59 : 383 - 390
[9] EXPERIMENTAL STUDY AND CFD SIMULATION OF HEAT TRANSFER AND FRICTION FACTOR CHARACTERISTICS IN THE CROSSFLOW TUBE BANK
Li, Shigang
Zhao, Xiaoyun
COMPUTATIONAL THERMAL SCIENCES, 2022, 14 (05): : 21 - 46
[10] Experimental study of in-line tube bundle heat transfer in vertical foam flow
Gylys, J.
Sinkunas, S.
Giedraitis, V.
Zdankus, T.
ADVANCED COMPUTATIONAL METHODS IN HEAT TRANSFER IX, 2006, 53 : 213 - +

← 1 2 3 4 5 →